La Gard LGBASIC 3710 User Operating Instructions Manual

Page 1

CHANGING YOUR CODE

ALWAYS PERFORM THIS OPERATION WITH THE DOOR OPEN

➀ Enter “zero” six times. ➁ Enter your exisiting six (6) digit code one time. ➂ Enter your NEW six (6) digit code two times. ④ If a mistake is made wait thirty (30) seconds and repeat steps ➀ - ➂. ➄ Test lock operation several times before closing the door.

● Valid Code Entry - Double signal after valid six (6) digit code is entered.

● Invalid Code Entry - Triple signal and old code is still valid.

BATTERY LOW WARNING

● Repeated beeping during an opening indicates that the battery is low and needs immediate replacement.

● Uses one (1) 9-Volt Alkaline Battery. LA GARD recommends the use of Duracell™ or Everready™ Alkaline batteries.

If battery is depleted and will not allow lock to open, simply follow instructions below.

CHANGING YOUR BATTERY

Note: Some manufacturers use a small screw to

secure the battery compartment cover to the keypad

housing. If your model has this screw, it must be

removed first before following the steps listed below.

➀ Remove black plastic battery

compartment cover (located at the bottom of the keypad) by gently pulling downward on it’s handle.

➁ Allow the battery and it’s attached

leads to drop down and out of the battery compartment. If it does not drop, gently pull on the battery until it does.

➂ The connector is easily removed by

unsnapping it from the two terminals on the top of the battery.

Never Pull on the Battery Leads

④ Connect a new 9-Volt Alkaline battery

to the battery clip.

➄ Push the battery and the leads completely

up into the battery compartment.

➅ Install the battery cover by placing

one side of the cover in position and then pressing the other side into position with your finger.

FEATURES

USER CODE

● Open Lock

● Change Code

WRONG TRY PENALTY

● Four (4) consecutive invalid codes initiates five minute delay period.

LOW BATTERY WARNING

● Repeated audio and visual signal (LED flashing and repeated beeping) during opening indicates battery low.

AUDIO AND VISUAL SIGNAL

● Double signal (LED flashes and unit beeps) indicates entry is valid or accepted.

● Triple signal indicates invalid or not accepted.

OPENING THE LOCK

➀ Enter valid six (6) digit code. ➁ The lock will signal a valid code entry with a double signal. ➂ Within four (4) seconds, turn handle to the open position. ④ Pull door open.

● Invalid Code Entry - Lock will signal three (3) times.

WRONG TRY PENALTY

● Entry of four (4) consecutive invalid codes starts a 5-minute delay period.

- LED flashed red at five (5) second intervals.

● At the end of the delay period, two more consecutive invalid codes will restart an additional 5-minute delay period.

3710 Electronic Entry Device

USER OPERATING INSTRUCTIONS