Laerdal Medical AS 20430150 User Manual
SimPad PLUS
Link Box PLUS
Important Product Information
EN
www.laerdal.com
English
SimPad PLUS / Link Box PLUS - Regulatory Information
English
SimPad PLUS / Link Box PLUS - Regulatory Information
Read these instructions thoroughly before
connecting the equipment to the power
source. Observe all warnings, precautions
and instructions on the SimPad PLUS,
in the User Guide and in this Important
Product Information booklet. Retain this
booklet for future reference.
These declarations also apply when using
the following manikins in conjunction with
SimPad PLUS system:
MegaCode Kelly Advanced
•
• Megacode Kelly Basic ECG Only
•
Megacode Kid Advanced
Megacode Kid Basic ECG Only
•
Nursing Anne
•
• Nursing Kid
•
Nursing Baby
•
Resusci Anne QCPR
•
Resusci Baby QCPR
Resusci Anne Simulator
•
•
Resusci Anne Advanced Skill Trainer
•
Premature Anne
SimMan ALS
•
Warnings and Cautions
A Warning states a condition, hazard, or
unsafe practice that can result in serious
personal injury or death.
A Caution states a condition, hazard, or
unsafe practice that can result in minor
personal injury or damage to the manikin.
Operating Conditions
Water and Moisture
Cautions
• Do not operate the device under or near
water - for example near a bathtub,
kitchen sink, or laundry tub, in a wet
basement, near a swimming pool or in
other areas with high humidity.
•
Never install jacks for communication
cables in wet locations.
•
Do not operate the product with
wet hands.
Lightning
Never use this device, or connect/
disconnect communication cables or
power cables during lightning storms.
Dust
Do not operate the device in areas with
a high concentration of dust.
Cleaning and Maintenance
Cleaning
•
Unplug the device from communication
lines, mains power outlet or any power
source before cleaning or polishing.
• Do not use liquid cleaners or aerosol
cleaners. Use a lint-free cloth lightly
moistened with water for cleaning the
exterior of the device.
Servicing
Refer all servicing to qualified
service personnel.
Warnings
Do not attempt to service the device
•
yourself. Opening or removing covers may
expose you to dangerous voltages or other
hazards, and will void the warranty.
WiFi Connections
Please ensure that your settings of the
device adhere to any regional restrictions
on the use of WiFi channels.
Accessories
Use only accessories specified by the
•
manufacturer, or sold with the apparatus.
The RJ-45 jack should not be used for
•
telephone line connection.
Internal Battery Pack in SimPad PLUS
Cautions
Use only the SimPad battery with
•
SimPad PLUS.
•
Do not expose to high temperatures, such
as in direct sunlight or in a car parked in
the sun.
•
Only charge SimPad PLUS using
the supplied battery charger or a
recommended charging device that can
charge the battery.
•
Dispose of used battery pack promptly
and according to local legislations.
•
Do not dispose of in water.
Warnings
Do not disassemble, crush, puncture, or
•
short external contacts and do not allow
metal objects to come into contact with
the battery terminals.
• Do not try to repair the batter y, it may
cause an explosion.
Do not incinerate or dispose of in re,
•
the battery may explode or release toxic
materials.
Risk of explosion if battery is replaced by
•
an incorrect type.
• If the internal battery pack in
SimPad PLUS is mishandled, it can burst,
cause a re or even chemical burns.
2 3
Power Connection and
Hazardous Voltage
Cautions
•
Never attempt to open this product, or any
peripherals connected to it, if this action
requires a tool.
If any parts of the product have visual
•
damage, never attempt to connect main
power, or any other power source, before
consulting service personnel.
Route the power cord to avoid it being
•
walked on or pinched by items placed
upon or against it. Pay particular attention
to the plugs, receptacles and the point
where the cord exits from the device.
• Do not tug the power cord.
Warnings
•
The product or its accessories may have a
hazardous voltage inside.
•
The product should always be powered
from an earthed power outlet.
•
If the provided plug does not t into your
outlet, consult an electrician.
English
SimPad PLUS / Link Box PLUS - Regulatory Information
English
SimPad PLUS / Link Box PLUS - Regulatory Information
US
Federal Communications
Commission (FCC) Statement
This device complies with part 15 of the
FCC rules. Operation is subject to the
following two conditions:
(1) This device may not cause
harmful interference.
(2) This device must accept any interference
received, including interference that
may cause
undesired operation.
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation. This equipment generates, uses,
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
•
Reorient or relocate the receiving
antenna.
Increase the separation between the
•
equipment and receiver.
•
Consult the dealer or an experienced
radio/TV technician for help.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
SimPad PLUS
FCC ID : QHQ-20430150
Link Box PLUS
FCC ID : QHQ-20430250
Cautions
This transmitter must not be co-located
•
or operating in conjunction with any other
antenna or transmitter
Any changes or modications not expressly
•
approved by the party responsible for
compliance could void the user’s authority
to operate this equipment.
The use of shielded I/O cables is required
when connecting this equipment to any and all
optional peripheral or host devices. Failure to do
so may violate FCC rules.
For Portable Device Usage
(<20cm from body/Specific Absorption
Rate (SAR) needed))
Radiation Exposure Statement:
This device meets the government’s
requirements for exposure to radio waves.
This device is designed and manufactured
not to exceed the emission limits for
exposure to radio frequency (RF) energy set
by the FCC of the U.S. Government.
The exposure standard for wireless device
employs a unit of measurement known
as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6W/kg.
Tests for SAR are conducted using standard
operating positions accepted by the FCC
with the device transmitting at its highest
certified power level in all tested frequency
bands.
For Country Code Selection Usage
(WLAN Devices)
Notes
The country code selection is for non-US
•
model only and is not available to all
US model. Per FCC regulation, all WiFi
product marketed in US must xed to US
operation channels only.
Changes or modications not covered
•
in this manual must be approved in
writing by the manufacturer’s Regulatory
Engineering Department. Changes or
modications made without written
approval may void the user’s authority to
operate this equipment
Canada
Industry Canada Rules
This device complies with Industry Canada
license-exempt RSS standard(s). Operation
is subject to the following two conditions:
(1) This device may not cause interference,
and
(2) This device must accept any
interference, including interference that
may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR
d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de
brouillage, et
(2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi,
même si le brouillage est susceptible
d’en compromettre le fonctionnement.
4 5
Canadian ICES-003 Statement
This Class B digital apparatus complies with
Canadian ICES-003.
Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
(1) This equipment complies with IC RSS-102
radiation exposure limits set forth for an
uncontrolled environment.
(2) This device and its antenna(s) must not
be co-located or operating in conjunction
with any other antenna or transmitter, except
tested built-in radios
(1) Cet équipement est conforme aux limites
d’exposition aux rayonnements définies par la
norme IC RSS-102 pour un environnement
non contrôlé.
(2) Cet appareil et son ou ses antenne(s) ne
doivent pas être placés à proximité d’un autre
émetteur ou d’une autre antenne, exception
faites des radios intégrées qui ont été testées.
The County Code Selection feature is
disabled for products marketed in the US/
Canada.
La fonction de sélection du code de pays est
désactivée pour les produits distribués aux
États-Unis ou au Canada.
SimPad PLUS
IC ID: 20263-20430150
Link Box PLUS
IC ID: 20263-20430250
EU
Radio and Telecommunication
Terminal Equipment (R&TTE)
Directive
This product is in compliance with the
essential requirements and other relevant
provisions of EU Council directive 1999/5/EC.
Loading...