Laerdal Medical AS 120-60750 User Manual

Little Anne

QCPR Sensor

Important Product Information

EN

English

Little Anne QCPR Sensor

Warnings and Cautions

A Warning states a condition, hazard, or unsafe practice
that can result in serious personal injur y or death.

A Caution states a condition, hazard, or unsafe practice
that can result in minor personal injury or damage to
the manikin.

Care, Maintenance and Cleaning

Clean with a dry cloth only.

Caution

During use and assembly, do not touch the uncovered
section of circuit board.

Battery

Consumer grade, non-rechargeable, carbon zinc or
alkaline batteries, LR6 1.5V AA only to be used.
Battery must be replaced with correct type.

Caution

Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to the
instructions.

Federal Communications Commission
Statement and Industry Canada Statements

This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:

1. This device may not cause harmful interference

2. This device must accept any interference received,
including interference that may cause undesired
operation.

Caution

Changes or modifications not expressly approved by
Laerdal Medical could void the user’s authority to operate
the equipment.

This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment
and receiver.

• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.

• Consult the dealer or an experienced radio/TV
technician for help.

Contains FCC ID: QHQ-120-60750
IC: 20263-12060750

Industry Canada ICES-003 Compliance:

CAN ICES-3 (B)/NMB-3(B)

Korea Certication:

MSIP-CMM-Lm1-120-60750

2