LACAVA®
Owner’s Manual
Libera Vanity
Item #5101A
Caution!
Remove doors and drawers from this cabinet during installation and
store them away from the work area. This will make the cabinet lighter,
easier to move, and also helps protect drawer and door faces during
installation. Drawers and doors can open unexpectedly and unbalance
the cabinet, causing injury or damage.
All cabinets, even free-standing, should be secured to the wall stud to
prevent any movement.
Damage caused during installation is not covered by warranty.
Please see our terms and conditions for additional details.
Important: Keep this manual for future technical assistance and/or replacement parts. Please read the instructions within
the booklet carefully prior to installation. LACAVA recommends that this fixture be installed by a professional plumber and
will not be held responsible for any damage caused by improper installation. It is the responsibility of the homeowner to
ensure that this fixture complies with all local plumbing codes. Please see the Terms & Conditions found within this
booklet for additional information. For technical assistance please contact 888-522-2823 (toll free).
Importante: Guarde este manual para futura asistencia técnica y / o piezas de repuesto. Por favor, lea las instrucciones
en el folleto cuidadosamente antes de la instalación. LACAVA recomienda que este aparato sea instalado por un técnico
y no se hace responsable de los daños causados por una instalación incorrecta. Es la responsabilidad del propietario
garantizar que este aparato cumpla con todos los códigos de plomería locales. Por favor, consulte nuestros Términos y
Condiciones que se encuentran en este folleto para información adicional. Para obtener asistencia técnica, por favor
contacte a: 888-522-2823 (llamada gratuita).
Table of Contents/Contenido:
Page 2: Product Specifications
Page 3: Mounting Instructions
Page 5: Cleaning and Care
Page 6: Warranty
Page 7: Terms and Conditions
6630 west wrightwood ave chicago il 60707 usa tel 773 637 9600 fax 773 637 9601 info@lacava.com www.lacava.com
Product Specifications/Especificaciones de Producto
32"
810
3 7/8"
98.4
minimum of 3 7/8” from
permanent structure for
ADA compliance
26 1/4”
667
22 1/2”
571
H
5 1/2"
140
C
18"
460
24 7/8”
632
34”
864
6"
150
Note:
Drawings provided herein are meant to give the user an idea of the product and are not made to scale. The sizes in
inches are rounded up to the nearest 1/16.
Nota:
Los planos proporcionados en este documento tienen el propósito de dar al usuario una idea del producto y no
están hechos a escala. Los tamaños de pulgadas se redondean al más cercano 1 / 16.
LACAVA LLC 2
Wall-mounted Cabinet Instructions
Cleat
Side
1. In order to provide proper support for wall-mounting a cabinet, it's usually necessary to remove a small section of
drywall so you can access the wall studs and attach blocking between them.
2. Based on the cabinet’s dimensions and mounting height, decide where support will be needed. Then remove the
drywall in that area and install 2-by-6 or 2-by-8 blocking between the wall studs. Then using 3 1/2” galvanized
common nails, toenail the blocking to the studs and repair the drywall.
3. If the studs cannot be used, then ¾” plywood behind the wall can also provide the necessary support.
Back
4. Attach wooden cleat to the wall by
drilling screws through the cleat directly
into the studs or reinforced wall. (NOTE:
ADA compliance states vanity must be
mounted at least 3 7/8” away from
permanent structures.
6. Reomove sliding doors from the vanity.
5. Remove cleat, make a cutout to access the drain
pipe, then reinstall the cleat.
6. Attach the outlet end of the “P” trap to the drain
pipe in the wall.
A. Push door up into top runner/track clearing the
the door from the bottom track.
B. With the bottom of the door removed from lower track
push the door into the vanity to create room to pull door
from top runner. Pull door from top runner and remove
door completely. Repeat with second door.
LACAVA LLC3