Lacava 1586 User Manual

LACAVA

®

2243 S. Throop St.
Chicago, IL 60608

[e-mail]

www.lacava.com

Owner’s Manual

Important: Keep this manual for future technical assistance and/or replacement parts.
Please read the instructions within the booklet carefully prior to installation. LACAVA
recommends that this fixture be installed by a professional plumber and will not be held
responsible for any damage caused by improper installation. It is the responsibility of the
homeowner to ensure that this fixture complies with all local plumbing codes. Please see
our Terms and Conditions found in this booklet for additional information. For technical
assistance please contact: 888-522-2823 (toll free).

Please reference this number:

PS#:

Table of Contents

Page 2: Cleaning & Care Instructions
Page 3: Warranty
Page 4: Parts Breakdown
Page 5: Installation Instructions
Page 7: Specification Sheet
Page 8: Terms and Conditions

Cigno Single-Hole Faucet

Item #1586

LACAVA LLC

®

Page 1 of 9

Cleaning & Care Instructions

STAINLESS STEEL
Stainless steel is a very wear-resistant material. In order to achieve maximum corrosion resistance, the
surface of stainless steel must be kept clean. Provided that you follow a few simple steps, it will last a
lifetime in good condition.

• After each use, wash the sink with water and mild soap detergents; rinse the surface with clean warm

water; and dry the sink with a soft dry cloth.

• Do not leave liquids containing chlorine, rusty items, toilet cleaners, acids, concentrated disinfectants,

or strong alkalis in the sink for long periods because they may discolor the surface.

• AVOID using coarse abrasive materials such as scouring pads, wire wool, etc. which scratch the

surface of polished stainless steel.
NEVER let strong acids come into contact with stainless steel.
Other Metals (like faucets, chrome brackets, etc.). Use pure water for regular care. If the parts are
heavily congested, dissolve a couple of drops of dish soap in a small amount of water for cleaning. Do not

use abrasive agents - they will cause scratches. For best results, rub the surface with a soft cloth until dry.

GLASS

To prevent the formation of deposits, rinse and dry the glass after each use. To remove permanent water
stains, apply any glass cleaning aids and detergents available and/or baking soda(apply directly with a soft
cloth and a couple drops of water), like the ones used to clean shower doors, rinse the surface with clean
water, and dry with soft dry cloth. DO NOT use coarse abrasive materials or sharp objects which may
scratch the surface and leave marks on the glass.

WOOD

Clean the surface with soft cloth using only cleaning agents designated for wood care. To preserve and
restore the natural beauty of wood, apply paste wax with a soft cloth once a week and polish the surface
until wax evenly spread. NEVER use course abrasive materials which will scratch and discolor the surface,
and avoid oily agents that can engage in chemical reactions with lacquered surface. Extensive use of water
may also discolor and damage the wood surface, so wiping the wood surface dry after each use is highly
recommended.

MARBLE

Marble stone should be treated with marble sealer (we recommend Stoneguard Sealer) at least once a
week to prevent staining. Please follow the sealer manufacturer’s instructions to assure the best results.

VITREOUS CHINA

Vitreous china can be cleaned with a range of cleaning agents designated for bathroom maintenance: only
strong acids and abrasive agents should be avoided in order to prevent discoloration and scratches in the
glazed surface. Wash with detergent and warm water and rinse. Black marks in the glaze created by contact
with metal elements can be removed with very fine steel wool. The marks should be damped with water or
glass cleaner and rubbed with steel wool until it is removed (this may take longer than a couple of minutes).
Lime deposits may be removed by a solution of vinegar and water. Bathroom fixtures should be disinfected
weekly with a solution of chlorine bleach and water or a spray-on disinfectant or by using disinfectant cleaning
foam. Rust stains can be removed by using commercial rust remover or by using a solution of 1 tablespoon
oxalic acid crystals (poison), dissolved in ½ cup warm water. Apply to stain, allowing to stand a few minutes,
and then rinse well.

ACRYLIC & SOLID SURFACE

Acrylic and solid surface is non-porous so liquids cannot penetrate it. Use water with dish soap or an
ammonia-based cleanser (such as glass cleanser).Wipe away water stains with a damp cloth and sponge and
dry with a towel. Occasionally wipe sinks and bowls with diluted household bleach (1/1 water/bleach solution)
to disinfect. Surfaces exposed to acetone-based polish removers and paint removers should be promptly
flushed with water. To remove stains, use Soft Scrub(r) diluted bleach and a sponge to rub in circular motion.
If the area is dull in contrast with the surrounding surface, use a white polishing compound with a sponge to
get a higher gloss. To remover cuts and scratches, sand with 400-grit (30 micron) or 600-grit (20 micron)
sandpaper; buff with polishing pad at a low speed (1,500 - 2,000 rpm) polisher equipped with a wool pad;
finish with wax.

LACAVA LLC

®

Page 2 of 9

Warranty

Lacava does not make any warranties, expressed or implied, except for warranty that
our product be free from manufacturing defects in material and workmanship for a
period of one year from the date of purchase. If a product is determined to be defective
when still under warranty, Lacava will repair or replace the product (whichever cost is
smaller to Lacava) at its own expense (excluding shipping and installation charges). The
warranty does not cover the normal wear and tear, damages due to negligence,
improper installation, alterations, improper repairs, improper use, improper maintenance,
or damages due to uses of the product other than its intended and normal use. In
accordance with the laws of limitation and exclusion state by state, and therefore
provided the duly exceptions, Lacava will not be held liable, in any event, for any
special, indirect, incidental or consequential damages or losses (including but not limited
to damages for loss of business, loss of profits, etc.) for breach of contract, tort (including
negligence), product liability or otherwise, even if it has been advised of the possibility of
such damages. LACAVA’s liability on any claim (including negligence) will not in any
case exceed the contract price paid by the original purchaser for the product claimed
defective or unsuitable.

Important Information:
Failure to fully comply with these installation instructions will void your warranty LACAVA
LLC is not responsible for any damages resulting form non-compliance with these
instructions. Furthermore it is the responsibility of the installer to ensure that this product
complies with all local plumbing codes

Warranty Conditions:

1. LACAVA Subjects all its products to quality controls and guarantees them against
manufacturing defects. The guarantee covers the free elimination of all faults, as
judged by LACAVA, by repair and/or replacement of the product or parts of it.
The guarantee covers all countries in which the product is supplied by LACAVA.

2. LACAVA guarantees its products for a period of:

• 5 years against fusion and porosity faults

• 5 years against cartridge or bolts faults

• 5 years for chrome-plating defects

• 1 year for faults with all other finishes (wood)

• 1 year for washer or o-rings faults

3. The warranty is acknowledged exclusively if proof of purchase is available in the
form of a receipt or invoice bearing the date of purchase and the name of the
dealer bought from.

4. Faulty material must be returned to our facility together with proof or purchase
and RGA sheet.

5. For the products which have not been installed, the warranty will only be
acknowledge if the returned to LACAVA in the original packaging, along with
proof of purchase and RGA sheet.

6. The warranty does not cover damages due to :

• Failure to observe the instructions in this installation booklet and; therefore
incorrect installation , improper use , incorrect maintenance

• Transport and handling

• Wear of parts (valves, membranes, etc…)

• Tampering or repairs carried out by anyone other that those authorized by

LACAVA, and the use of non-original LACAVA spare parts

• Frost and foreign bodies inside the pipes

7. The warranty does not cover assembly or disassembly of the product, transfers
and technical intervention by authorized personnel.

LACAVA LLC

®

Page 3 of 9