Labway D041K8 Users Manual

USB Hub-Audio Series

January 1999

A15-0157-110

USB Hub-Audio

FCC COMPLIANCE STATEMENT:

This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.

INFORMATION TO USER:

This equipment has been tested and fo und to comply with the limits of a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation; if this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient / Relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit difference from that to wh ich th e
receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

CAUTION: Changes or modifications not expressly approved by the manufacturer

responsible for compliance could void the user’s authority to operate the equipment

Page - 1

USB Hub-Audio

TABLE OF CONTENTS

USB Hub-Audio..........................................................................................................3

Introduction.............................................................................................................3

USB Hub Device Driver Installation Under Windows 98.....................................0

Verifying Correct USB Hub Device Driver Installation.................................................7

USB Audio Device Driver Installation Under Windows 98 ..................................0

Verifying Correct USB Audio Device Driver Installation............................................13

How to Enable USB Audio ...........................................................................................14

USB Hub-Audio Device Driver Install ation Und er Windows 98...........................0

Verifying Correct USB Hub-Audio Device Driver Installation....................................17

Page - 2

USB Hub-Audio

USB Hub-Audio

Introduction

Thank you for choosing our USB series products. We provide USB Hub, USB Audio
and USB Hub-Audio which are combinations of Hub and audio.
The following diagrams show you the back plates of the different devices.

Back Plate for USB Hub-Audio (Xtend K90)

Port 1

Port 2 Port 3

Port 4

SPK Out Line Out Line In MIC

Back Plate for USB Hub-Audio (Xtend K85)

Port 1

Port 2 Port 3

SPK Out Line Out Line In MIC

Back Plate for USB Hub (Xtend K80)

Port 1

Port 2 Port 3

Port 4

Back Plate for USB Audio (Xtend K50)

SPK Out Line Out Line In MIC

Page - 3

USB Hub-Audio

USB Hub Device Driver Installation Under Windows 98

1.) After starting up your Microsoft Windows 98 operating system, the “Add New
Hardware Wizard” dialog box will be displayed on your screen. Click on “Next>”.

Fig.1

2.) The “Add New Hardware Wizard” dialog box appears, asking you what Windows
should do. Please choose ”Search for the best driver for your device.
(Recommended)”, and click on “Next>”.

Fig.2

3.) You will receive the following dialog box. Select “CD-ROM drive” and click on
“Next>“ again. Please make sure that before you click on “Next>”, the Windows 98
CD-title has been inserted into your CD-ROM drive.

Page - 4

USB Hub-Audio

Fig.3

4.) If Windows 98 could not find the correct driver program, the next dialog box will
appear on your screen automatically.

Fig. 4

5.) The “Insert Disk” dialog box may appear and ask you to insert the Windows 98 CD­ROM. Just insert it and continue by clicking on “OK”.

Fig.5

Page - 5