Page 1
SmartScope A11/A12
User’s Manual
Page 2
For laboratory use only
Operation instructions
For all instructions regarding installation, usage and operation of the SmartScope, please visit
http://www.lab-nation.com/smartscope/manual
Safety Instructions
Review the following safety precautions carefully before operating the device to avoid any personal injuries
or damages to the device and any products connected to it. To avoid potential hazards use the device as
specified by this user’s guide only.
-
Use proper accessories. Use only the cables and accessories that are certified and supplied by
LabNation.
-
Connect and Disconnect Properly. Do not connect or disconnect probes or test leads while they
are connected to a voltage source.
-
Connect and Disconnect Properly. Connect the probe output to the measurement device before
connecting the probe to the circuit under test. Disconnect the probe input and the probe reference
lead from the circuit under test before disconnecting the probe from the measurement device.
-
Use Proper Probes. To avoid shock hazard, use a properly rated probe for your measurement.
-
Avoid Circuit or Wire Exposure. Do not touch exposed connections or components when power is
on. Do not touch any parts of the SmartScope, or any objects connected to the SmartScope,
whenever any ground clip of the probes are connected to anything else than ground/earth.
-
Do Not Operate With Suspected Failures. If suspected damage occurs with the device, have it
inspected by qualified service personnel before further operations.
-
Do not operate in Wet/Damp Conditions.
-
Do not operate in an Explosive Atmosphere.
-
Keep Product Surfaces Clean and Dry.
-
Do not connect any part of the SmartScope to voltages higher than 20V, or lower than -20V.
- Connect ground clip to earth only, never to elevated voltages!
www.lab-nation.com
Page 3
For laboratory use only
Regulations
All LabNation products that are subject to the WEEE directive shipped from
13th August 2005 are compliant with the WEEE marking requirement. Such products are
marked with the “crossed-out wheelie bin” WEEE symbol (shown, right) in accordance with
European Standard EN50419.
DECLARATION OF CONFORMITY WITH FCC RULES FOR
ELECTROMAGNETIC COMPATIBILITY
We, LabNation BVBA, of Tolstraat 50, 2000 Antwerp, Belgium declare under our sole responsibility that the
product:
SmartScope (Models A11, A12)
to which this declaration relates:
Complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
For Customers in Canada
This apparatus complies with Canadian ICES-003//NMB-003B.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
www.lab-nation.com
Page 4
For laboratory use only
Declaration of Conformity
Designer: LabNation BVBA
Tolstraat 50
2000 Antwerpen
Product: SmartScope
Models A11, A12
Starting Date: July 17th, 2014
We declare, under our sole responsibility, the above-referenced products, if used according to all
guidelines mentioned in this manual, to which this declaration relates, is in conformity with the provisions
of:
Directive 2004/108/EC “Electromagnetic Compatibility”
EN 55011:2009/A1:2010 - Industrial, scientific and medical equipment - Radio-frequency
disturbance characteristics - Limits and methods of measurement
For the designer
Date: 17/07/2014
Name: Riemer Grootjans, Electronical Engineer
www.lab-nation.com
Loading...