Labgear 27884LAB User Manual

The dipole clips onto the central boom. Ensure that the cable exit hole (from the terminal box) faces the rear of the aerial and that the locating stud fi ts into the locating hole on the boom as shown in Fig. 1.
Wideband - suitable for all UK TV reception areas, covering UHF channels 21 to 68
Receives both digital and analogue TV signals
attenuator may be required, or for very weak strength signal areas an amplifi er may be needed
The aerial requires some assembly - please read these instructions carefully before beginning.
Main Features
1. Rotate the elements about the central fi xing clip until they ‘snap’ into an upright position as shown in Fig. 2.
2. The central boom comes in two sections using the bracket supplied and the holes drilled in the boom sections join these two sections as shown in Fig. 3.
3. Attach centre mount bracket in the position shown using the clips supplied.
rotate elements
B. Rotating aerial elements, central boom and centre mount assembly
A. Fitting the dipole assembly
Congratulations on the purchase of your high gain wideband aerial which is designed to receive both analogue and digital terrestrial signals. This aerial has been manufactured to the standard required to get the best reception of digital terrestrial TV services (such as Freeview™). If the aerial is to be used for DTT reception check before installation at www.dtg.org.uk/retailer/coverage to confi rm that your home is in a coverage area and to fi nd where your local transmitter is. For optimum results install the aerial using double screened digital coax cable and screened coax outlets.
High Gain Wideband Digital Aerial
27884LAB
1. Using the refl ector clamps, screw and large wing nut, fi x the refl ector assemblies to the main aerial boom.
2. Check that the refl ector clamp tabs locate in the holes of the refl ector boom sections and that the wing nut is tight - see Fig. 4.
2. Ensure that the refl ector elements are facing towards the front of the aerial (convex surface forward).
C. Fitting the refl ectors
engage tab in hole
refl ector element
locating hole
locating stud
rear of aerial
element in upright position
refl ector boom assembly
central boom
dipole
refl ector clamps
USER GUIDE
central boom back section
central boom front section
joining bracket with bolts and wing nuts
centre mount bracket with clips, bolts and wing nuts
Fig. 1
Fig. 2 Fig. 3
Fig. 4
braid
centre wire
5mm
10mm
8mm
Coax plug wiring instructions
1 Unscrew coax plug housing and slide cap over cable. 2 Strip 23mm of cable outer sheath. Gather copper braid, wrap around outer sheath, slide claw over braid and crimp. 3 Strip 18mm of inner insulation to leave 5mm exposed 4 Undo screw on plug/clamp, slide clamp over inner wire & tighten screw. Reassemble plug
1
2
3
4
5
5 Trim inner wire flush with plug.
Loading...