LABEC J-WD-1 User Manual

INSTRUCTION MANUAL

Laboratory Equipment Pty Ltd
email: [e-mail]
Ph: 02 9560 2 811 • Fax: [phone]

www.labec.com.au

2014

Distilling Water Apparatus

Operation Manual

Model: J-WD1

Please read this Operation Manual carefully before use.

Operation Manual
J-WD-1-2-M-08-001(REV.01)

Use of Operation Manual

Please read through and understand this Operation Manual before operating the product. After reading,
always keep the manual nearby so that you may refer to it as needed. When moving the product to
another location, be sure to bring the manual as well. If you find any incorrectly arranged or missing
pages in this manual, they will be replaced.
If the manual it gets lost or soiled, a new Operation Manual can be purchased. In either case, please
contact your LABORATORY EQUIPMENT PTY LIMITED agent, and provide the "Model No." given on
cover. This manual has been prepared with the utmost care; however, if you have any questions, or
note any errors or omissions, please contact your LABORATORY EQUIPMENT PTY LIMITED
distributor or agent. Reproduction and reprinting of this operation manual, whole or partially, without our
permission is prohibited.
Both unit specifications and manual contents are subject to change without notice.

Operation Manual
J-WD-1-2-M-08-001(REV.01)\

SAFETY SYMBOLS

This operation manual and this product use the following safety symbols. Please keep in mind the
meaning of each of the symbols to ensure safe use of the product and to prevent any damages,
accidents, or problems resulting from negligence of these safety symbols. (As using symbols may
depend on the product, not all of the symbols may be used.)

SAFETY SYMBOLS

SAFETY SYMBOLS

Indicates the possibility of
personal injury or death. Never
fail to follow the operating
procedure.

Do not proceed beyond a
WARNING sign until the noted
conditions are fully met to
satisfactory and understood.

Indicates the existence of
possibility of damage to the
product or to the operator in
operation.

Never fail to follow the
operating procedure.

Indicates the existence of
possibility of damage to the
product or to the operator in
operation when cautions are
not observed and followed
properly.

Indicates additional information
such as general warning,
caution, risk of danger, and
operating procedure.

When this mark is indicated on
the product, refer the relevant
section of the Operation
Manual.