FCC Rule Part: CFR 47 Part 90, DA 09-2482
Manufacturer: L-3 Communications CyTerra Corporation
Certification Exhibit
FCC ID: YKD-25STW4100-019
ACS Project: 13-2037
Model: Range-R 2D
User Manual
3998 FAU Blvd. Suite 310 Boca Raton, FL 33431 Tel: 561-961-5585 Fax: 561-961-5587
TB X-XXXX-XXX-XX TB X-XXXX-XXX-XX TB X-XXXX-XXX-XX
FCC COMPLIANCE
Do not open the unit. There are
no user serviceable parts
contained within the unit, and
opening or tampering with it will
void the FCC certification and
the manufacturer’s warranty.
This device is approved for use by the FCC
under FCC Order
25STW4100-019.
Warning: Changes or modifications to this
device not expressly approved by L-3 CyTerra
could void the user’s authority to operate the
equipment.
“This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment may operate in
WARNING
DA 09-2482, FCC ID YKD-
encouraged to try to correct the interference by
one or more of the following measures:”
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
For any questions related to FCC compliance
contact L-3 CyTerra Technical Support.
This RANGE-R 2D Handheld Through Wall
Radar is controlled under the U.S.
International Traffic in Arms Regulations
(ITAR) and may not be exported without
proper authorization by the U.S. Department of
State.
direct contact with the body of the user under
normal operating conditions. This transmitter
must not be co-located or operating in
conjunction with any other antenna or
transmitter.”
“NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is