Küppersbusch IKD 943.1 Instructions For Use And Installation Instructions

IKD 943.1

04306403/1

BEDIENUNGSANWEISUNG

mit Montageanweisungen

GB

Instructions for use and installation instructions
Instructions d'utilisation et avis de montage
Gebruiksaanwijzing en montagehandleiding
Istruzioni di uso e di montaggio
Instrucciones de uso y de montaje
Instruções de uso e de montagem

F

NL

I

E
P

WARNING

--------------------------------------------------

The distance between the supporting
surface for the cooking vessels on the hob
and the lower part of the hood must be at
least 65 cm. If the instructions for installation
for the hob specify a greater distance, this
has to be taken into account.
The air collected must not be conveyed
into a duct used to blow off smokes from
appliances fed with an energy other than
electricity (central heating systems, ther­mosiphons, water-heaters, etc.).
Comply with the official instructions provided
by the competent authorities in merit when
installing the disposal duct. In addition,
exhaust air should not be discharged into
a wall cavity, unless the cavity is designed
for that purpose.
The room must be well aerated in case a
hood and some other heat equipment fed
with an energy other than electricity (gas,
oil, coal heaters, etc) operate at the same
time. In fact the intake hood, disposing of
air, could create a vacuum in the room.
The vacuum should not exceed 0,04mbar.
This prevents the gas exhausted by the
heat source from being intaken again. It is
therefore advisable to ensure the room
contains air taps able to ensure a steady
flow of fresh air.

ATTENTION: This appliance must be
grounded.

The following warning is valid in the United
Kingdom only: in case your cable is not
furnished with a plug, read the following
instructions; as the colours of the wires in
the mains lead of this appliance may not
correspond with the coloured markings
identifying the terminals in your plug,
proceed as follows:
– the wire which is coloured green and
yellow must be connected to the terminal
in the plug which is marked with the letter
E or by the earth symbol [ ], or coloured
green or green and yellow;
– the wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black;
– the wire which is coloured brown must

English

be connected to the terminal which is
marked with the letter L or coloured red.
When making the electrical connections,
check that the current socket has a ground
connection and that the voltage values
correspond to those indicated on the data
plate inside the appliance itself.
In case your appliance is not furnished with
a non separating flexible cable and has no
plug, or has not got any other device ensu­ring omnipolar disconnection from the elec­tricity main, with a contact opening distance
of at least 3 mm, such separating device
ensuring disconnection from the main must
be included in the fixed installation. If your
unit features a power lead and plug, position
this so the plug is accessible.
Always switch off the electricity supply be­fore carrying out any cleaning or servicing
operations on the appliance.

USE

--------------------------------------------------

Avoid using materials which could cause
spurts of flame (flambées) near the ap­pliance.
When frying, take particular care to prevent
oil and grease from catching fire. Already
used oil is especially dangerous in this re­spect. Do not use uncovered electric grates.
To avoid possible risks of fire always comply
with the indicated instructions when
cleaning anti-grease filters and when
removing grease deposits from the
appliance.

MAINTENANCE

--------------------------------------------------

Thorough servicing guarantees correct and
long-lasting operation.
Pay special attention to the grease filters.
The grease filters must be cleaned
approximately once every 30 hours of
operation (when the central segment on the
display goes on or starts blinking). To
remove the filters: press inward on the
clamps at the handles and pull the filter
downward (Fig. 3). Wash out the filter by
hand or in the dishwasher using a neutral
soap. Once the cleaned filters are
reinstalled, keep button R (Reset) pressed
for two seconds to reset the counter. For
further information, see the Commands in
the paragraph entitled "Operation".
Any fat deposits should be removed from
the appliance periodically depending on