Küppersbusch FKE 167-4 Instructions For Installation And Use Manual

410 627 E

6

Küppersbusch Vertriebsgesellschaft mbH
Postfach 10 01 32
45801 Gelsenkirchen
Hausanschrift:
Küppersbuschstr. 16
45883 Gelsenkirchen
Telefon: [phone]
Teletex: 20 931 810
Telefax: (02 09) 4 01-3 03

Gebrauchs- und Montageanleitung

Instructions for installation and use
Instructions de montage et d’emploi
Gebruiks- en montageaanwijzing
Istruzioni per l’installazione e l’uso
Istrucciones para el montaje y el uso

Wichtig: Unbedingt lesen und aufbewahren!

Important: Read these instructions carefully and then store them in a safe place
Important: Lire attentivement et ranger soigneusement ce mode d’emploi
Belangrijk: Beslist lezen en bewaren
Importante: È necessario leggere attentamente queste istruzioni e conservarle con cura
Importante: Leerlas imprescindiblemente y guardarlas

Integrierte Einbau-Kühlgeräte

Integrated refrigerator
Réfrigérateur à intégrer
Integreerbare koelkasten
Frigoriferi integrabili
Frigorífico integrable

Modell: FKE 167-4

p.: 9 - 14 15 - 20 21 - 26 27 - 32 33 - 38

GB F NL I E

2222 160-71

9

WARNINGS

It is most important that this instruction book should be
retained with the appliance for future reference. Should
the appliance be sold or transferred to another owner, or
should you move house and leave the appliance, always
ensure that the book is supplied with the appliance in
order that the new owner can be acquainted with the
functioning of the appliance and the relevant warnings.

These warnings are provided in the interest of safety.
You must read them carefully before installing or using
the appliance.

ª This appliance is designed to be operated by

adults. Children should not be allowed to tamper
with the controls or play with the product.

ª Any electrical work required to install this

appliance should be carried out by a qualified
electrician or competent person.

ª This product should be serviced by an authorized

Service Centre, and only genuine spare parts
should be used.

ª It is dangerous to alter the specifications or

modify this product in any way.

ª Care must be taken to ensure that the appliance

does not stand on the electrical supply cable.

ª The domestic refrigerators and freezers are

designed to be used specifically for the storage of
edible foodstuffs only.

ª Frozen food must not be re-frozen once it has

been thawed out.

ª Manufacturers’ storage recommendations should

be strictly adhered to. Refer to relevant
instructions.

ª During normal operation, the condenser and

compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the relevant
Figure.

Attention: keep ventilation openings clear of
obstruction.

ª Before any cleaning or maintenance work is

carried out, be sure to switch off and unplug the
appliance.

ª If the appliance has been transported

horizontally , it is possible that the oil contained in
the compressor flows in the refrigerant circuit. It
is advisable to wait at least two hours before
connecting the appliance to allow the oil to flow
back in the compressor.

ª The inner lining of the appliance consists of

channels through which the refrigerant passes. If
these should be punctured this would damage the
appliance beyond repair and cause food loss. DO
NOT USE SHARP INSTRUMENTS to scrape
off frost or ice. Frost may be removed by using
the scraper provided. Under no circumstances

should solid ice be forced off the liner. Solid ice
should be allowed to thaw when defrosting the
appliance. See defrost instructions.

ª Do not use a mechanical device or any artificial

means to speed up the thawing process other
than those recommended by the manufacturer.

ª Do not place carbonated or fizzy drinks in the

freezer as it creates pressure on the container,
which may cause it to explode, resulting in
damage to the appliance.

ª This appliance is heavy. Care should be taken

when moving it.

ª Ice lollies can cause frost burns if consumed

straight from the appliance.

ª This appliance contains hydrocarbons in its

cooling unit; maintenance and recharging must
therefore only be carried out by authorized
technicians.

ª Never use metal objects for cleaning your

appliance as it may get damaged.

ª Under no circumstances should you attempt to

repair the appliance yourself.
Repairs carried out by inexperienced persons
may cause injury or more serious malfunctioning.
Refer to your local Service Centre, and always
insist on genuine spare parts.

ª This appliance does not contain gasses which could

damage the ozone layer, in either its refrigerant
circuit or insulation materials. The appliance shall not
be discarded together with the urban refuse and
rubbish. Avoid damaging the cooling unit, especially at
the rear near the heat exchanger. Information on your
local disposal sites may be obtained from your
municipal authorities.

ª Take utmost care when handling your appliance so as

not to cause any damages to the cooling unit with
consequent possible fluid leakages.

ª The appliance must not be located close to radiators or

gas cookers.

ª Avoid prolonged exposure of the appliance to direct

sunlight.

ª There must be adequate ventilation round the back of

the appliance and any damage to the refrigerant
circuit must be avoided.

ª For freezers only (except built-in models): an ideal

location is the cellar or basement.

Printed on recycled paper

10

INSTALLATION

If this appliance featuring magnetic door seals is to
replace an older appliance having a spring lock (latch) on
the door or lid, be sure to make that spring lock
unusable before you discard the old appliance. This will
prevent it from becoming a death-trap for a child.

Positioning

The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
Best performance is obtained with ambient
temperature between +18°C and +43°C (class T);
+18°C and +38°C (class ST); +16°C and +32°C (class
N); +10°C and +32°C (class SN).

The class of your appliance is shown on its rating plate.

For building into kitchen units follow the special
“Building-in” instructions given.

Electrical connection

Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply.
Voltage can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably
sized auto-transformer must be used.

The appliance must be earthed.

The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.

The Manufacturer declines all responsibility if the above
safety precautions are not observed.

This appliance complies with EEC directive number
87/308 of 2/6/87 relative to radio interference
suppression.

This appliance complies with the following
E.E.C. Directives:

- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;

- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.

Cleaning the interior

Before using the appliance for the first time, wash
the interior and all internal accessories with
lukewarm water and some neutral soap so as to
remove the typical smell of a brand-new product,
then dry thoroughly.

Do not use detergents or abrasive powders, as
these will damage the finish.

Assembly instructions

Fitting the decor panel

(Fig. 1)

Fig. 1

Preliminary
requirement: the

overall
dimensions of the
decor panel must
be 1-2 mm less
than those of the
door, with a
maximum

thickness of 4 mm.
With the refrigerator door closed, unscrew the
screws securing the removable side piece of the
frame to the door. Remove this side piece and slide
the decor panel into place, after having slackened
the remaining frame screws; push the panel fully
home and secure the frame to the door, including
the side piece previously removed.

Door reversibility

Right hand door opening

Fig. 2

Remove the

upper and lower

screws (1) and

pivots (2) with the

safety washer (4)

on the left side

(Fig. 2). Remove

the door stop

hinge (3-Fig. 3).

Fig. 3

D243

D561

1

2

6
4

5

3

D562