KYE SYSTEMS KM001 Users manual

English

Introduction

▼

Congratulations on your purchase of a rockets h 27MHz Wireless Optical Mouse. This

ergonomically designed mouse uses a radio frequency (RF) link that enables you to use

the mouse anywhere within distance of its receiver. No line-of-sight between the mouse
and its receiver is required. In addition to this user’s guide this package contains:

Mouse

•

USB receiver

•

2 AAA batteries

•

Carrying pouch

•

System Requirements

▼

Hardware

PC with a Pentium® processor or the equivalent

•

USB interface

•

Operating System

Windows® 98SE/Me/2000/XP and Mac

•

Connecting the Mouse Receiver

▼

To connect the mouse receiver:

1. Plug the USB receiver into an available USB port on your computer.

2. Your computer’s operating system identies the receiver and begins installing the
default driver.

3. Follow any on-screen procedures to complete the default driver installation.

1

English

Using the mouse

▼

Install the batteries

a. Press the battery releasing button to open battery cover.

b. Insert batteries, making sure that the positive (+) and negative (-) ends of each battery
match the polarity indicators inside the battery housing.

+

_

_

+

c. Put on the battery cover.

2

English

Establishing a communications link

▼

The mouse has 256 identication codes that allow the mouse and its receiver to operate
without interference from other radio frequency devices.

After your computer detects the USB receiver and the driver is installed, you must establish
a communications link between the mouse and its receiver BEFOR E you can use the
mouse. To do this, follow the instructions below:

1. Press and release the link button located on the receiver.The receiver’s status light
blinks when the receiver is activated.

Link Button

2. Press and release the link button, located on the bottom of the mouse, and you are now
ready to use the mouse.

Mouse Power Management

▼

a. Push back the lock of dongle holder.
b. Pull the dongle holder till the end to power off
c. Insert receiver to the dongle holder while travelling.

Link Button

a

d. The mouse will go into “sleep mode” after 7 minutes of idling status.
To awake the mouse, just move or click any key of the mouse.
e. While power is running out, the LED light will turn to RED with blinking light.

b

c

3