KYE SYSTEMS GMZL8 Users manual

1

How to use the Presenter:

1. Insert two AAA batteries in the Media Pointer.

2. Plug the receiver unit into any USB port.

ID identification

The Media Pointer ID has been factory preset.
The 2.4GHz DSSS technology works up to 15 meters and has a anti-interference function.

edia Pointer features:

M

1. The mini receiver can be stored inside the Media Pointer
for easy storage.

Button Functions:

1. F5/ESC: Start Presention / Exit full screen

2. Blank Screen

3. Previous Page

4. Next Page

5. Laser Beam

English

FCC Compliance and Advisory Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
according to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try correct the interference by one or more of the following
measures:

English

1. Reorient the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into and outlet on a circuit different from that to which the receiver is

connected.

4. Consult the dealer or an experienced radio/TV technician for help.

Any special accessories needed for compliance must be specified in the instruction manual.

CAUSION: Any changes or modifications not expressly approved by the party responsible for

compliance could void your authority to operate the equipment.

2