KYE SYSTEMS GMZKY User Manual

KYE SYSTEMS CORP.

English

Hardware Installation
For Mouse use:

Energy Mouse
Model:GM-120031/S

1. Connect the receiver to a USB port of a PC.

2. Make sure that you have switched on the power switch underneath the mouse.

For Mouse with power bank function charging:

1. How to start charge Energy Mouse

a. Plug the Micro USB cable into the Energy Mouse Micro USB port, and then

insert the other end of the cable into USB port of your power supply (e.g. wall
charger, or computer USB port). The power level LED indicators will be
flashing in sequence.

b. When the charge is completed, the four LEDs will stay on for 10 minutes, and

then turn off for power saving.

2. How to start charging mobile devices

a. Connect your device to the Energy Mouse USB output port.
b. Press and hold the button for two seconds to turn it on. The power level

LED indicators will flash three times and the charging will start.

c. To stop charging, press the button for two seconds again. Or just

disconnect the cable; Energy Mouse will automatically turn off in 30 seconds.

3. How to check power capacity of Energy Mouse

a. Press and hold button for two seconds for the power level. The four LEDs

will flash three times first then show the power capacity.

4. How to turn off Energy Mouse when charging is finished

a. Just remove the charger cable. Energy Mouse will

automatically turn off automatic off in 30 seconds.

Mouse Button Assignments

1. Left Button: Provides traditional mouse functions like click,

1

KYE SYSTEMS CORP.

double click and drag.

2. Magic-Roller: Press the “Magic-Roller” to surf the Internet

and Windows documents.

3. Right Button: Provides traditional mouse click functions.

4. Button: Press and hold this button for two seconds to turn it on. The power

level LED indicators will flash three times and the display battery’s capacity.

5. Power Level LED indicators: When the charge is completed, the four LEDs will

stay on for 10 minutes, and then turn off for power saving.

LED
Indicators

Power Level 100-75% 75-50% 50-25% 25-5%

● LED On ○ LED Off ⊙ LED Blinking
Remark: Power level low indication
If the LED is flashing five times, then the power level is low, and you need to
recharge the mouse immediately.

Note: Download the programmable driver from our website: www.geniusnet.com

Warning: (Troubleshooting)

1. Make sure the Energy Mouse is completely charged before first usage.

2. Use the standard cable or it could cause damage to Energy Mouse.

3. Confirm the voltage of the mobile device is 5V before you use Energy Mouse to

charge it.

4. To maintain the life span and quality of Energy Mouse battery, we recommend

you unplug the power cable promptly after Energy Mouse is fully charged and
fully charge it every four months.

5. Do not drop, knock, disassemble or attempt to repair Energy Mouse by yourself or

you will void the warranty. If there is any problem, you can contact a service
center for assistance.

6. Do not leave Energy Mouse in a vehicle, expose it to sunlight or put it near any

heat source for a long time as strong light and high temperature will lead to
battery damage.

7. Store Energy Mouse in a cool, dry place, and keep it away from fire and moisture.

8. Do not put any object (except the USB cable) into any of the Energy Mouse micro

USB input or USB output ports to avoid short circuit damage.

9. Keep Energy Mouse away from children and pets. Do not use the wireless

optical/laser mouse on a desk which is made of glass or mirror.

10. The connection of the wireless device is factory preset, so when you plug the

USB receiver into any USB port, the connection between the micro receiver and
the mouse will be established automatically.

11. In case your PC did not install the hardware successfully, remove the micro

receiver from the USB port and go Human Interface Devices under Device

●●●● ●●●○ ●●○○

2

English

⊙○○○

Blinking