KYE SYSTEMS GMZKW User Manual

GM-130016/T(NS-6000) English

Hardware Installation

1. You can connect the receiver to a USB port of a PC.

2. Install one AA battery in the mouse as instructed.

3. Make sure that you have switched on the power switch underneath the mouse.

Factory Settings

1. Left Button: Provides traditional mouse functions like click, double click and

drag.

2. Magic-Roller: Press the “Magic-Roller” to surf the Internet and Windows

documents.

3. Right Button: Provides traditional mouse click functions.

Warning: (Troubleshooting)

1. Do not use the wireless optical/laser mouse on a desk which is made of glass or

mirror.

2. The connection of the wireless device is factory preset, so when you plug the

USB receiver into any USB port, the connection between the micro receiver and
the mouse will be established automatically.

3. In case your PC did not install the hardware successfully, remove the micro

receiver from the USB port and go Human Interface Devices under Device
Manager to remove the mouse then plug in the micro receiver to a USB port
again.

4. If you feel the mouse does not move smooth as usual, it is possible the batteries

have lost their charge so you need to replace them. Remember to put the batteries
in the correct direction.

GM-130016/T(NS-6000) English

FCC Compliance and Advisory Statement

This device complies with Part 15 of the FCC rules. Operation i s subj ect to t he
following two conditions:(1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. This equipment has been
tested and found to comply with the limits for a Class B digital device,
according to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and ca n radiate radio frequency energy and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
correct the interference by one or more of the following measures: 1.Reorient
the receiving antenna. 2.Increase the separation between the equipment and
receiver. 3.Connect the equipment into and outlet on a circuit different from
that to which the receiver is c onnecte d. 4.Con sult t he dealer or an ex perience d
radio/TV technician for help. Any special accessories needed for compliance
must be specified in the instruction manual. Warning: A shielded-type power
cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that
only the supplied power cord be used. Use only shielded cables to connect I/O
devices to this equipment. CAUSION: Any changes or modifications not
expressly approved by the party responsible for compliance could void your
authority to operate the equipment.