KYE SYSTEMS GMZKP User Manual

GM-130012/T(Traveler D6600) English

Hardware Installation

1. Connect the receiver to a USB port of a PC or Notebook.

2. Install one AA or AAA battery in the mouse as instructed.

3. Make sure that you have switched on the power switch underneath t he mouse.

4. Use the OTG cable to connect your tablet PC.

(OTG cable for Android OS 4.0 + for tablet PC and smart phones)

Mouse Button Assignments

1. Left Button: Provides traditional mous e fun ctions like

click, double click and drag.

2. Magic-Roller: Press the “Magic-Roller” to surf the

Internet and Windows documents.

3. Right Button: Provide s traditional mouse click functions.

4. Change device Button: Press this button to change

another PC or Notebook device.

Note: Download the programmable driver from our website:

www.geniusnet.com

Warning: (Troubleshooting)

1. Do not use the wireless optical/laser mouse on a desk which is made of glass or

mirror.

2. The connection of the wireless device is factory preset , so when you plug the

USB receiver into any USB port, the connection between t he micro rece iver and
the mouse will be es tablished automatically.

3. In case your PC did not install the hardware successfully, remove the micro

receiver from the USB port and go Human Interface Devices under Device
Manager to remove the mouse then plug in the micro receiver to a USB port
again.

4. If you feel the mouse does not move smooth as usual, it is possible the battery ha s

lost its charge so you need to replace it. Remember to put the battery in the correct
direction.

1

GM-130012/T(Traveler D6600) English

FCC ID: FSUGMZKP

FCC Compliance and Advisory Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:(1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. This equipment has been
tested and found to comply with the limits for a Class B digital device,
according to Part 15 of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiat e radio fre quency ene rgy and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
correct the interference by one or more of the following measures: 1.Reorient
the receiving antenna. 2.Increase the separation between the equipment and
receiver. 3.Connect the equipment into and outlet on a circuit different from
that to which the receiver is connected. 4.Consult the dea ler or an ex perienc ed
radio/TV technician for help. Any special accessories needed for compliance
must be specified in the instruction manual. Warning: A shielded-type power
cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that
only the supplied power cord be used. Use onl y shielde d cab les to conn ect I/ O
devices to this equipment. CAUSION: Any changes or modifications not
expressly approved by the party responsible for compliance could void your
authority to operate the equipment.

2