KYE SYSTEMS GMZKF Users manual

English

Hardware Installation

1. Connect the receiver to a USB port of a PC.

2. Install one AA or AAA battery in the mouse as instructed.

3. Make sure that you have switched on the power switch underneath the mouse.

Mouse Button Assignments

1. Left Button: Provides traditional mouse functions like

click, double click and drag.

2. Magic-Roller: Press the “Magic-Ro ller” to surf the

Internet and Windows documents.

3. Right Button: Provid es traditional mouse click

functions.

4. DPI adjustment: Defa ult is 1200 dp i, 800 dpi (1 flash),

1200dpi (2 flashes), 1600 dpi (3 flashes)

Note: Download the programmable driver from our website:
www.geniusnet.com

Warning: (Troubleshooting)

1. The connection of the wireless device is factory preset, so when you plug the

USB receiver into any USB port, the connection bet ween t he micro rece iver and
the mouse will be established automatically.

2. In case your PC did not install the hardware successfully, remove the micro

receiver from the USB port and go Human Interface Devices under Device
Manager to remove the mouse then plug in the micro receiver to a USB port
again.

3. If you feel the mouse does not move smooth as usual, it is possible the battery has

lost its charge so you need to replace it. Remember to put the battery in the correct
direction.

1

English

FCC ID: FSUGMZKF

FCC Compliance and Advisory Statement

This device complies with Part 15 of the FCC rules. Operati on is subject to the following two
conditions:(1) this device may not cause harmf ul interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
according to Part 15 of the FCC rules. These limits are designed to prov ide reasonable
protection against harmful interference in a residential installation. Thi s equi pm ent generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not oc c ur i n a particul ar installation. If this equipment does
cause harmful interference to radio or telev ision reception, which can be determined by
turning the equipment off and on, the user is encouraged to try correct the interference by one
or more of the fo llowing measures:

1. Reorient the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into and outlet on a circuit different from that to which the receiver is
connected.

4. Consult the dealer or an experienced radio/T V tec hnic ian for help.

Any special accessories needed for compliance m ust be specif ied in the instruction manual.
Warning: A shielded-type power cord is required in order to meet FCC emission limits and
also to prevent interference to the nearby radio and television reception. It is essential t hat
only the supplied power cord be used. Use only shielded cabl es to c onnec t I/O devices to this
equipment.
CAUSION: Any changes or modifications not expr essly appr oved by the party responsible for
compliance could void your authority to operate the equipment.

IC statement: This Class B digital apparatus complies with Canadian ICES-003.Cet appareil
numérique de la classe B est conforme à la norme NMB-003 du Canada.

2