KYE SYSTEMS GMZKD, GMZKE User Manual

English

Hardware Installation

1. You can connect the receiver to a USB port of a PC.

2. Install one AA battery in the correct direction in the mouse as shown.

3. Make sure that you have switched on the power switch underneath the
mouse.

Factory Settings

1. Left Button: Provides traditional mouse

functions like click double click and drag.

2. Magic-Roller: Press the “Magic-Roller” to

surf the Internet and Windows documents.

3. Right Button: Provides traditional mouse

click functions.

Note: Download the programmable driver from
Genius website at www.geniusnet.com

Warning: (Troubleshooting)

1. Do not use the wireless optical/laser mouse on a desk which is made of

glass or mirror.

2. The connection of the wireless device is factory preset, so when you plug

the USB receiver into any USB port, the connection between the micro
receiver and the mouse will be established automatically.

3. In case your PC did not install the hardware successfully, remove the micro

receiver from the USB port and go to Human Interf ace Devices under
Device Manager to remove the mouse driver, and then plug in the micro
receiver to a USB port again.

4. If you feel the mouse does not move smooth as usual, it is possible the

batteries have lost their charge so you need to replace them. Remember to
put the batteries in the correct direction.

1

English

FCC Warning：

Warning: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user＇s authority to operate
the
equipment.
NOTE: This equipment has been tested and found to compl y w i th the l imi ts for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and
on, the user is encouraged to try to correct the interference by one or more of
the
following measures:
_ Reorient or relocate the receiving antenna.
_ Increase the separation between the equipment and receiver.
_ Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
_ Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to
the
following two conditions : (1) this device may not cause harmful interference,

2