KYE SYSTEMS GMZGJ User Manual

Hardware Installation

Hardware Installation

Note: Always turn off your computer before you connect or disconnect your mouse and keyboard unless you’re using a USB device

in Win98 or above. If you have a PC with the PC 99 spec, then the mouse port and keyboard port are green and purple

respectively.

1. Connect the receiver’s green mouse connector to the computer’s 6-pin mouse port.

Connect the receiver’s purple keyboard connector to the computer’s 6-pin keyboard port.

2. Install two AAA batteries in the mouse and two AA batteries in the keyboard.

3. Turn on your computer.

4. After you open Windows, please press the button under the receiver first and then press the button under the mouse and

keyboard for channel setting. Make sure each button press is for at least three seconds.

War ni ng :

1. When you use Wireless TwinTouch+ on a desk that is made of metal, try using a pad and reduce the receiving distance.

2. Before the first installation is completed (channel setting ready), the keyboard and mouse will not work in DOS.

3. The Wireless TwinTouch+ channel provides 256 ID-codes, and it automatically selects the ID # for your keyboard and mouse.

You can only set up one TwinTouch+ at a time. But if you have additional TwinTouch+ sets in an area of 10 square meters,

more interference will occur between the receiver and your keyboard and mouse.

4. If you feel the mouse does not move smooth as usual or the keyboard does not work when typing, that the batteries have lost

their charge, so please replace them. Also, the wireless icon will be blinking “red” when there is a battery-low situation

5. The TwinTouch+ with radio frequency gives you free movement and an enjoyable experience. For optimal performance,

place the receiver at least 8 inches (about 20 cm) away from the mouse and other electrical devices, such as the computer,

monitor, and etc.

.

Software Installation

1. Make sure the mouse and keyboard is connected to the computer.

2. Put the Setup disk (or CD) into the disk drive.

3. Follow the instructions on the screen to finish the software installation.

Factory Setting

1. Mouse:

2. Keyboard:

1. Rewind: Previous track of audio or video CD’s

2. Play & Pause: Play and pause of audio or video CD’s

3. Stop: Stop play of audio or video CD’s

4. Forward: Next track of audio or video CD’s

5. Vol.-& +: decrease or increase volume

6. My favorite: Open my favorite folder

7. E-mail: Open mail folder

8. Back: See last page when viewing the Internet

9. www: Open browser in Netscape or IE

10. Forward: Go to next page when viewing the Internet

11. Sleep: Turn system into sleep mode