KYE SYSTEMS GKZH7 User Manual
ENGLISH
Federal Communications Commission (FCC) Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. This equipment has been tested and found to comply with
the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in particular installations, if this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Reorient / Relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that the receiver is
connected.
4. Consult the dealer or an experienced radio / TV technician for help. CAUTION:
Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
Disclaimer
The following does not apply to any country where such provisions are inconsistent
with local law: KYE Systems Corp. makes no warranties with respect to this
documentation, whether expressed or implied. All material is provided “as is”. This
includes, but is not limited to, any implied warranties of merchantability and fitness is
for a particular purpose. The information covered in this document is subject to change
without notice. KYE Systems Corp. assumes no responsibility for any errors that may
appear in this document. All brand names mentioned in this manual are trademarks or
registered trademarks of their respective companies. Copyright © 2007 KYE Systems
Corp. All rights reserved.
1
ENGLISH
Hardware Installation
1. You can connect the receiver to a USB port of a PC
2. Install two AAA batteries in the KeyBoard
3. Turn on your computer. The mouse will now work.
Warning: (Troubleshooting)
1. Please do not use wireless optical mouse on a desk which is made of
glass, mirror, iron, or black velvet. Also, a flat surface is necessary or
the optical sensor will be error easily. When you use wireless optical
mouse on a desk that is made of metal, try using a pad and reduce the
receiving distance.
2. The wireless optical mouse channel provides 256 ID-codes, and it
automatically selects the ID # for your mouse. You can only set up
one wireless optical mouse at a time. But if you have additional
wireless optical mouse sets in an area of 10 square meters, more
interference will occur between the receiver and your mouse.
2
Loading...