KYE SYSTEMS GKZH6 User Manual

ENGLISH

Federal Communications Commission (FCC) Notice

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in particular installations, if this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:

1. Reorient / Relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that the
receiver is connected.

4. Consult the dealer or an experienced radio / TV technician for help.
CAUTION: Changes or modifications not expressly approved by the
manufacturer responsible for compliance could void the user’s authority to
operate the equipment.

Disclaimer

The following does not apply to any country where such provisions are
inconsistent with local law: KYE Systems Corp. makes no warranties with
respect to this documentation, whether expressed or implied. All material is
provided “as is”. This includes, but is not limited to, any implied warranties of
merchantability and fitness is for a particular purpose. The information
covered in this document is subject to change without notice.
KYE Systems Corp. assumes no responsibility for any errors that may appear
in this document.
All brand names mentioned in this manual are trademarks or registered
trademarks of their respective companies.
Copyright © 2007 KYE Systems Corp. All rights reserved.

1

ENGLISH

Hardware Installation

1. Install two AA batteries each into the mouse and keyboard.

2. Plug in your USB receiver to a USB port of your PC.

Software Installation

1. Place your CD driver in your PC drive for
software installation.

2. Follow the instructions on the screen to
finish the software installation.

Replace Batteries

If the mouse or keyboard does not work properly, then the batteries
have lost their charge, so you need to replace them.

Warning: do not mix or use different types of batteries at the same time.

ID Channel Setting

The channel ID is factory preset. The green LED (data transmission
indicator) will be lit constantly when the wireless device is in normal
operation. In case your wireless devices do not work, reset the ID
channel by:

1. Press the connect button on the receiver and the LED will be blinking
for connection.

2. Press the connect button on each wireless device within 20 seconds
and observe if the LED light on the receiver has gone off. If yes, it
means the wireless device is ready for use.

2