KYE SYSTEMS GKZGW Users manual

ENGLISH

Hardware Installation

1. Install two rechargeable AA batteries into the mouse a nd
two AAA batteries into the keyboard.

2. Plug in your USB receiver to a USB port of your PC.

3. Turn on your PC.

Software Installation

1. Place your CD driver in your PC drive for software
installation

2. Follow the instruction on the screen to finish the software
installation

Replace Batteries

When your mouse or keyboard does not work properly, then
the batteries have lost their charge, so please replace them.
(Warning: please do not mix or use different types of batteries
at the same time)

1

ENGLISH

ID Channel Setting

The channel ID is factory preset. The green LED (data
transmission indicator) will be lit constantly when the wireless
device is in normal operation. In case your wireless devices do
not work, please reset the ID channel by:

1. Press the connect button on the receiver and the light will
be blinking for connection.

2. Press the connect buttons of the keyboard and mouse
within 20 seconds.

3. To confirm the connection of the wireless devices, the LED
light will be lit constantly for approximately three seconds
and will turn off after being connected.

Charger and charging usage

1. The charger device can be used to recharge both AA and
AAA batteries; two batteries must be charged
simultaneously.

2. Make sure that only rechargeable batteries (NiMH~
Nickle-Metal-Hydride) batteries are used and placed in the
correct position.

3. For safety, the charge r features a recognition function for
alkaline batteries placed and/or when the batteries are not
placed in the correct polarity direction; resulting in
charger’s LED Light to blink between green and red to
indicate a warning.

2

ENGLISH

4. The LED will be red in charging mode and Green when
batteries are fully charged.

5. The Hub on the charger is designed for a dongle receiver
or other USB accessories (such as mouse, flash memory
stick).

Warning (Trouble shooting)

1. Please do not use the wireless optical mouse on a surface
that is made of glass, iron, black velvet or a desk that is
made of metal, as they will reduce the operational distance
of the keyboard and mouse.

2. The wireless desktop set provides 256 ID codes, and it
selects the ID # for your wireless devices. You can only set
up one wireless desktop at a time. When you have another
27Mhz wireless desktop set within 10 square meters, there
may be interference between the wireless devices.

3. The wireless mouse uses an IR sensor and no light will be
shown just like an ordinary optical mouse.

3