KVS MORAVIA TYPE 9114-HEU Maintenance Manual
TYPE 9114-HEU
OPERATION & MAINTENANCE
MANUAL
INSTALLATION MANUAL
TYPE 9114-HEU 01/2016
0
SOLID FUEL
RANGE COOKER
WITH HOT WATER HEATER
This product is not suitable as a main heat source for heating.
KVS EKODIVIZE, a. s. declares that the hygienic character of the baking accessories intended for contact with
foodstuff under all normal conditions, or by the stated use of the manufacturer, comply with the requirements
of Law No. 258/2000 Coll., the Ministry of Health Decree No. 38/2001 Coll., and Regulation No. 207/2006 Coll.
of the Czech Republic.
TYPE 9114-HEU 01/2016
1
Declaration
KVS EKODIVIZE, a. s.
Chairman of the Board of Directors
Dear customer,
Thank you for purchasing of the appliance KVS MORAVIA - solid fuel range cooker. We trust that
our product serves you well. Some important principles should be observed during its operation.
Therefore, in your interest, carefully study this manual and operate the product according to the
given instructions. The 9114 appliance has a manufacturer issued declaration of conformity according to Section 12, Article 3, of Law No. 22/1997 of the Czech Republic.
No flammable liquids should be used when lighting the fire, nor should they be used to in-
crease the nominal output of the appliance.
The appliance should not be used for waste incineration; only recommended fuels may be
used.
During operation, the ash tray door should be closed, and the fire door should only be opened
for lighting the fire or raking the grate in order to prevent flue gas bleeding.
The cooker cannot be used unless it is connected to a functioning water system even
during the summer months, otherwise the heat exchanger will be overheated and thus
suffer permanent damage.
Ash should be put into non-flammable ash bins with covers! Be very careful during the re-
moval of hot ash.
Pay attention to fire safety!
It is forbidden to use the appliance if it is damaged (unfit for its function)!
Any contravention of the operating conditions may cause damage to some parts of the appli-
ance. It is recommended not to overload the appliance in any way.
Possible noisy impacts (popping) of the metal plates or chipping of the fired clay lining
inside the appliance are not subject to repair or a claim procedure. The cause of these
impacts is the internal stress of the metal plates, which will fade after a certain time (it
depends on the firing frequency). These occurrences endanger neither the safety, nor
the function of the appliance.
Any repair of the appliance, except cleaning and fired claying must only be made by an au -
thorised worker.
Local regulations, including those regulations related to national and European standards,
shall be observed during the installation of the appliance.
It is recommended that you only use spare parts approved by the manufacturer.
Unauthorised modifications of the appliance are forbidden.
The appliance must only be operated by adults, and during operation, the appliance requires
intermittent attendance and supervision.
TYPE 9114-HEU 01/2016
2
Important Information, Binding Instructions and Recommendations
OPERATION & MAINTENANCE MANUAL
The appliance should be installed by an authorised specialist. No claims are accepted
in case of incorrect or amateur installation.
The TYPE 9114 appliance has been designed for solid fuel combustion in periodic feed rates and
it is intended for cooking and in households and/or for heating the space in which it is situated, according to the ČSN EN 12815:2002 Standard as amended A1:2005 and Commission Regulation
(EU) 2015/1185 – eco design of solid-fuel local space heaters.
The appliance can be connected to a chimney from the top by means of a hole in the Hob top
(Drawing 1). The appliance is suitable for short operational periods, so it is not possible to set the
permanent-heat process with a shortest interval of fuel supply of 10 hours.
Appliance Characteristics TYPE 9114-HEU
Energy efficiency class A
Energy efficiency index 104
Nominal heat output – NHO 7.8 kW
Direct heat output 4.4 kW
Indirect heat output 3.4 kW
Efficiency at NHO 78.6%
(Seasonal efficiency 68.6%)
Average temperature of flue-gas at NHO 277 °C
Mass flow rate of flue-gas at NHO 7.1 g/s
Emissions during heating of spaces at NHO (with O2 =13%):
PM 28 mg/m
3
OGC 83 mg/m
3
CO 1474 mg/m
3
Nox 99 mg/m
3
Minimum chimney draught 15 Pa
Preferred fuel wood briquettes (pressed wood
with moisture content < 12%)
Consumption of preferred fuel 2.1 kg/h
Weight 130 kg
Dimensions
Height of the worktop (distance from floor to hob top panel) 850 mm
Width of the appliance 515 mm
Depth of the appliance 575 mm
Diameter of the exhaust flue 120 mm
Area of the cooking range 0.2 m
2
TYPE 9114-HEU 01/2016
3
Technical Specifications TYPE 9114-HEU
Connection to the hot water system 1”
Heat exchange unit water capacity 15 l
Heated space 125 – 150 m
3
Operational pressure of the heat exchanger 2 bar
Dimensions of the Fire Box
Width x Height х Depth 380 х 250 x 400 mm
Fire grate, Width х Depth 160 х 290 mm
Stokehole, Width x Height 300 х 245 mm
Accessories
Poker 1 pc.
Glove 1 pc.
1. Hob top
2. Hob top frame
3. Fire box door
4. Ash chamber door
TYPE 9114-HEU 01/2016
4
Description TYPE 9114-HEU
Drawing 1
The upper working surface comprises a hob top. The appliance casing is made of enamelled steel
plates. The thermally stressed parts of the appliance are made of cast iron and fired clay.
The combustion chamber (fire box) is located in the upper section of the appliance (under the hob
top panel) so the discharge of combustion products travels to the chimney extension.
The appliance can be connected to a chimney from the top panel by means of a hole in the hob
top (Fig.1 and 2).
Fuel
The appliance is designed for combustion of solid fuel:
- recommended fuel is wood (the logs) max. diameter 200 mm and max. length 350 mm.
- the appliance also enables burning of other kinds of solid fuel (wood briquettes, waste wood,
brown coal briquettes, brown coal blocks of 40 mm). However the operating conditions and parameters of the appliance may differ from those with the recommended fuel. Please note that the
technical characteristics given above were based on a test wood fuel sample and using other fuel
types will alter these characteristics, energy output, fuel consumption, flue draught etc.
Make sure that the fuel is dry. It is not recommended to burn high-calorific fuels, which reduce the
service life of the appliance.
Grate, Grating
This appliance has one grate. The purpose of the grate is allowing the burned fuel to fall to the
ashtray, which increases the supply of combustion (primary) air to the combustion chamber. It is
done by means of the poker with the combustion chamber door open.
After the end of each operation (and cooling down) it is possible to grip the grate lever to move the
grate back and forth. To remove the pieces which are too big to fall through, rotate the grate a few
times by means of this lever.
Air Supply Control
Controlling the supply of primary combustion air is enabled by means of the air rose, which is a
part of the ashtray door. Turning the rose by means of the rose handle enables precise control of
air to the combustion chamber and thus alters the speed of fuel combustion (energy output of the
appliance).
The secondary combustion air supply can be controlled by means of a lever on the front part of
the appliance under the combustion chamber (fire box). The air supply is opened (flap is opened)
by movement of the lever towards the front side of appliance and it is closed (the flap is closed) by
movement from the front side. Movements lock on the lever by the neck.
Tertiary air is continuously and independently supplied into the heating chamber through the ventilators in the bottom part of the Combustion chamber door.
TYPE 9114-HEU 01/2016
5
Service Instructions
Loading...