KVS MORAVIA TYPE 9101 Maintenance Manual

TYPE 9101 07/2014 1

TYPE 9101

OPERATION & MAINTENANCE

MANUAL

INSTALLATION MANUAL

SOLID FUEL

RANGE COOKER

TYPE 9101 07/2014 2

TYPE 9101 07/2014 3

Dear customer,

Thank you for purchasing of the appliance KVS MORAVIA - solid fuel range cooker. We trust that
our product serves you well. Some important principles should be observed during its operation.
Therefore, in your interest, carefully study this manual and operate the product according to the
given instructions. The 9101 appliance has a manufacturer issued declaration of conformity
according to Section 12, Article 3, of Law No. 22/1997 of the Czech Republic.

• No flammable liquids should be used when lighting the fire, nor should they be used to
increase the nominal output of the appliance.

• The appliance should not be used for waste incineration; only recommended fuels may be
used.

• During operation, the ash tray door should be closed, and the fire door should only be opened
for lighting the fire or raking the grate in order to prevent flue gas bleeding.

• Ash should be put into non-flammable ash bins with covers! Be very careful during the
removal of hot ash.

• Pay attention to fire safety!

• It is forbidden to use the appliance if it is damaged (unfit for its function)!

• Any contravention of the operating conditions may cause damage to some parts of the

appliance. It is recommended not to overload the appliance in any way.

• Possible noisy impacts (popping) of the metal plates or chipping of the fired clay lining
inside the appliance are not subject to repair or a claim procedure. The cause of these
impacts is the internal stress of the metal plates, which will fade after a certain time (it
depends on the firing frequency). These occurrences endanger neither the safety, nor
the function of the appliance.

• Any repair of the appliance, except cleaning and fired claying must only be made by an
authorised worker.

• Local regulations, including those regulations related to national and European standards,
shall be observed during the installation of the appliance.

• It is recommended that you only use spare parts approved by the manufacturer.

• Unauthorised modifications of the appliance are forbidden.

• The appliance must only be operated by adults, and during operation, the appliance requires

intermittent attendance and supervision.

OPERATION AND MAINTENACE MANUAL

Important Information, Binding Instruction

s and Recommendations

TYPE 9101 07/2014 4

The TYPE 9101 appliance has been designed for solid fuel combustion in periodic feed rates and
is intended for cooking in households and/or for heating the space in which it is situated, accor­ding to the ČSN EN 12815:2002 Standard as amended by A1:2005. The appliance can be con­nected to a chimney from the back, both sides or from the top by means of a hole in the hob-top
(Figure 1).
The appliance is suitable for short operational periods, so it is not possible to set the permanent­heat process with a shortest interval of fuel supply of 10 hours.

Appliance TYPE 9101

Nominal heat output (NHO) wood coal

• summer mode 6 kW 6 kW

• winter mode 6 kW 6 kW

Efficiency with NHO 73,3%
Average flue gas temperature with NHO 275°C
Flue gas mass flow rate with NHO 8,3 g/s
Average concentration of CO with NHO (with O2 = 13%) 0,11 %
Minimum chimney draught 12 Pa
Working surface height (distance from floor to hob top panel) 850 mm
Appliance width 325 mm
Appliance depth 620 mm
Exhaust branch diameter 120 mm
Height to flue centre 700 ± 0.5 mm
Hob-top panels area 0.12 m

2

Tested fuel wood: size 200-265 mm
Average wood consumption 2 kg/h
Weight 100 kg

Dimensions of the Fire Box

Width x Height х Depth (summer regime) 190 х 220 x 270 mm
Width x Height х Depth (winter regime) 190 х 360 x 270 mm

Fire grate, Width х Depth (upper) 185 х 285 mm
Fire grate, Width х Depth

(bottom) 140 х 240 mm

Stokehole, Width x Height 192 х 130 mm

Accessories

Poker 1 piece

Technic

al S

pecifications

TYPE 9101 07/2014 5

1. Hob-top

2. Cover strip

3. Combustion chamber – door

4. Grate lever (with a safety lock)*

5. Ash tray door

6. Air rose

7. Fuel case

* the lock is only in some versions
of TYPE 9101 appliances.

Figure 1

The upper working surface comprises a hob-top. The appliance casing is made of enamelled steel
plates. The thermally stressed parts of the appliance are made of cast iron and fired clay.
The appliance can be connected to a chimney from the back, both sides or from the top by means
of a hole in the Hob-Top (Fig.1 and 5).
The hotplate lid* is packaged separately behind the rear side of the appliance for ease of
transportation. After the appliance has been unpacked, insert the hinge pins into the openings at

the rear section of the hotplate frame. The springs in the hinges assist in keeping the lid in a
vertical position.

*The hotplate lid is supplied upon the customer’s request only.

NOTE:

The manufacturer reserves the right to carry out small changes resulting from innovative or
technical changes of the product that will have no detrimental affect on the function of the
appliance.

Description

and Dimensional Sketch