KuulAire PACKA34 User Manual
WARNINGS AND SAFETY RULES
▲
!
LOCATION
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
TROUBLESHOOTING
Symptom Possible Cause Possible Solution
No discharge of air
The unit will not
turn off
Unit is making noise Calcium Build-up in Blower Deep clean unit — remove calcium debris
Not cooling
Odor Emission
Water droplets coming
out of air outlet
PARTS DESCRIPTION
Cord is not plugged in
Power is not on
Damaged PCB
Remote Control Batteries
Calcium Build-up in Blower
Low/No Water
Water Level Sensor is stuck
Brand new unit
Old unit with algae
Calcium saturated water
Clogged media
1. Control Panel
2. Horizontal Louvers
3. Water Level Gauge
4. Caster
Make sure cord is plugged in and try to turn the unit on pressing
buttons on control panel and remote control
Check the circuit breaker or check GFCI reset button
Try to use remote control to see if unit responds
Check batteries
Deep clean unit — remove calcium debris
Check water level
Drain/rell with fresh water and/or clean water tank
Brand new media will initially emit an odor which will dissipate
within a week of initial use
If the unit is not new, there may be an algae issue - replace the rigid
media pads and clean pads regularly
Drain water, deep clean and clean the media.
Media may need to be replaced.
Owner’s Manual
Model PACKA34
and PACKA342205060
SAVE AND READ THESE IMPORTANT INSTRUCTIONS
CAUTION
Read all instructions carefully before setting up and operating this unit. This manual
was designed to provide you with important information needed to setup, operate,
maintain, and trouble-shoot your cooler. Failure to follow these instructions may damage and/or impair its operation and void the warranty.
For one year from date of installation, Port-A-Cool, LLC, warrants any original
component part or parts of the KuulAire® evaporative unit found, upon examination
by factory authorized personnel, to be defective in material or workmanship. Due to
warranty limits placed on our component parts by the original manufacturers, our
warranty is limited on manufactured units and their original component parts, as well
as replacement parts to a total of one (1) year after the date of installation.
If said equipment develops such defects within this period, it will be repaired or
replaced at our option. For breach of any implied or written warranty on this product,
Port-A-Cool, LLC, shall not be liable for any incidental or consequential damages.
This warranty is declared void if the equipment is found to have been misused, abused
or tampered with by unauthorized personnel. Do not use cooler cleaners, cooler treatments, or other additives in this portable evaporative cooler. The use of any of these
products will void your warranty and may impair the life of your evaporative cooler.
All transportation charges on parts submitted for replacement or repair under this
warranty must be borne by the purchaser.
To obtain service under this warranty, contact the dealer where you purchased your
evaporative cooler. As a nal step, if you cannot locate your dealer, please contact
customer service at Port-A-Cool, LLC. Please include your name, address and ZIP code,
the model number and serial number of your evaporative cooler, date of installation,
and a description of your problem. Port-A-Cool, LLC, 709 Southview Circle, Center, TX
75935, Tel: 1-800-695-2942, 936-598-5651. For more information or to register online,
visit www.kuulaire.com.
WARRANTY
5. Side Water Fill
6. Cooling Pad / Cover
7. Drain Plug
Model PACKA44
and PACKA442205060
115V 220V
Made in China
Port-A-Cool, LLC • 709 Southview Circle • Center, TX 75935
www.kuulaire.com • 1-888-999-6511
COOL
Introduction
WARNINGS AND SAFETY RULES
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
USE AND OPERATION
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
TROUBLESHOOTING
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
WARNINGS AND SAFETY RULES
▲
!
LOCATION
PARTS DESCRIPTION
ELECTRICAL
ASSEMBLY INSTRUCTIONS
WARRANTY
CLEANING AND MAINTENANCE
TECHNICAL SPECIFICATIONS
TROUBLESHOOTING
REMOTE CONTROL
The PACKA34 and PACKA44 feature a
3-speed fan and automatic timer that can
be programmed for 0.5 hour to 7.5 hours.
The automatic louver sweep function
provides directional control and the
remote control (batteries not included),
!
▲
Basic safety precautions should always be followed when using any electrical appliance.
1. This unit is intended for indoor use. Any other
use is not recommended and may cause re,
electric hazard, or injury to persons or property,
and may void the warranty.
2. Unplug the unit from power outlet when lling
and relling water reservoir.
3. Unplug the unit from power outlet when moving
the unit.
4. Unplug the unit from power outlet when
cleaning or servicing.
5. Do not use the unit in areas where gasoline,
paint or any other ammable chemicals are
stored.
6. Extreme caution should be taken when used
near children and the elderly. The unit should
not be left unattended for any extended period
of time while in operation.
7. Do not let children play with any packaging
material.
8. Do not operate the unit with a damaged power
cord.
9. Do not attempt to repair or adjust any electrical
or mechanical functions of the unit.
10. The PACKA34 and the PACKA44 unit
should run on 110-120V 60Hz AC only. The
PACKA342205060 and PACKA442205060 on
220-240V 50/60 Hz AC only .
provides convenience. The PACKA34 and
PACKA342205060 portable evaporative cooler
is the latest in evaporative cooling technology
from Port-A-Cool, LLC, manufacturer of worldclass portable cooling units , for residential,
industrial and commercial applications.
11. Do not cover unit air inlet or air outlet openings.
12. This product is not intended for use in wet or
damp locations.
13. When not in use, drain the water from the tank
and store the unit in a dry location.
14. Do not run power cord under carpeting or cover
with rugs or runners. Arrange the cord away
from areas where it may be tripped over.
15. Do not use the unit with an extension cable.
16. Do not insert or allow objects to enter the air
outlet opening, as this may cause damage to
the blower and may void the warranty.
17. Use only fresh water to ll the water reservoir.
The use of air fresheners or cleaners is not
recommended as it may damage the unit and
void the warranty.
18. Drain the reservoir once every week to reduce
calcium saturation.
19. The unit is built with a water pump which has a
feature to stop when water in reservoir is at low
water. The pump will restart when the reservoir
is relled with water.
20. Do not use this appliance with any solid-state
speed control device.
21. If the unit is damaged or malfunctioning,
discontinue operation and refer to the troubleshooting section and/or contact a service
technician
USE AND OPERATION
!
▲
Filling the Reservoir with Water
Fill water from the top compartment. Pay attention to the water level indicator
to avoid overlling the unit. The capacity of the reservoir is 11 liters.
Draining the Reservoir
Move the unit to a location where water can be disposed of safely. Remove
the drain plug which is located at the back of the unit to release water from
the reservoir. Once it is completely drained, replace the drain plug. The unit is
ready to be lled with fresh water.
WARNING: Unplug the unit from power outlet
prior to moving or servicing, or lling or draining
the water reservoir. After unplugging, drain the
tank until it is half full before moving the unit.
USE AND OPERATION
ON/OFF
1. Connect the cord to a power outlet.
2. Press the ON/OFF button to turn on the unit. Indicator light
will illuminate. To turn off, press the ON/OFF button again.
SPEED
Press the SPEED button to select the desired fan speed. The
selected fan speed indicator LED light will light up. Fan speed
settings are LOW – MED – HIGH.
MODE:
Press the MODE button to select the desired fan mode. The
selected fan mode indicator LED light will light up. When
SLEEP or NATURAL is selected, air speed will change
randomly.
COOL
To use the unit as an evaporative cooler, press the COOL
button. The pump will start and distribute water to wet out
the cellulose media located in the rear of the unit. After
approximately three minutes, as the pad becomes
saturated, the air from the outlet should be cool.
LOW WATER ALARM FUNCTION
The PACKA34 and PACKA342205060 are equipped with a
REMOTE CONTROL
ON/OFF – start or turn off the unit
Timer – timer from 0.5 hour to 7.5 hours
Cool – start water pump
Speed – Low/Medium/High
Swing – automatic swing of louvers
Mode – Sleep/Natural/Normal
CLEANING AND MAINTENANCE
WARNING: Unplug the unit from power
!
▲
outlet prior to moving or servicing, or
lling or draining the water reservoir.
Dampen a clean cloth with water and use it on the exterior
of the unit to remove any dust or dirt. Never use harsh
detergents, solvents, and corrosive cleaners to clean the unit.
When not in use, drain the water reservoir and store the unit in
an area where it is dry and out of sunlight.
MAINTENANCE:
Regular draining, at least once each week, will decrease the
low water sensor alarm. When water in the tank is below
minimum level, you will hear 10 beeps and COOL LED
indicator will ash continuously. At the same time the
power to the pump will be cut off to protect the life of the
pump. In order to disengage the alarm function, turn off
and unplug the unit from the power outlet, and ll the tank
with water above the minimum level. In order to turn off
the alarm function and continue to use it in FAN mode,
press COOL button again. If COOL button is pressed again
without lling the tank with water, low water alarm will go
off again.
SWING:
Press the SWING button to direct the air stream. The
vertical louvers will begin to move automatically from side
to side. The indicator LED will come on. To adjust the
vertical direction of air ow, adjust the horizontal
louvers manually.
TIMER
The unit comes with an 0.5 hour to 7.5 hour. To set, press
the TIMER button to the desired operation time. When the
pre-selected time has elapsed, the unit will automatically
shut off.
ELECTRICAL
Model No. PACKA34
(110-120V 60Hz, 70W)
Model No. PACKA342205060
(220-240V 50/60Hz, 70W)
Water Tank Capacity 11 Liters
Dimensions 65cm H x 39.7cm W x 30cm D
Shipping Weight 6.0 kg
Model No. PACKA44 (110-120V 60Hz, 70W)
Model No. PACKA442205060 (220-240V 50/60Hz, 70W)
Water Tank Capacity 15 Liters
Dimensions 72cm H x 39.7cm W x 30cm D
Shipping Weight 7.8 kg
water mineral build up and extend the life of the honey-comb
media pad. A damp cloth can be used to remove calcium build-
up inside and outside of the unit. The dust lter/cover can be
removed easily and can be cleaned weekly. The inside of the
water reservoir can be cleaned once or twice in a season to
maintain air quality.
DEEPER CLEAN:
Remove the screw holding the dust ler/cover. You now can
take out the honeycomb media pad for cleaning. Wash the dust
ler/cover and honey comb media pad in clean water.
Loading...