File: 091-185-009.pmd
Date: 1-23-09
THN
Rev: new
INSTRUCTION MANUAL
E-Z Mounting Plate
For Super Auto Ejects
MODEL #091-185-009
KUSSMAUL ELECTRONICS CO., INC.
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
Phone: 631-567-0314 Toll Free: 800-346-0857 Fax: 631-567-5826
Web: www.kussmaul.com E-Mail: sales@kussmaul.com
E-Z MOUNTING PLATE INSTRUCTIONS
1. Locate a convenient place on the vehicle to mount the AUTO EJECT. A minimum clearance of 3
inches behind the mounting panel is required.
2. Place the Hole Template (Figure 2) in position and center punch in 4 places.
3. Drill 4 mounting holes, #29 drill (0.136” diameter). Be certain that all the holes are precisely located.
4. Cutout rectangular hole.
5. See Figure 1, Mounting. Install Weatherproof Cover, Weatherproof Cover Gasket,Indicator light to
E-Z Mounting Plate, and install to Super Auto Eject using (4)#8-32 x 1” screws provided.
6. Install that assembly and E-Z mount gasket into cutout in truck wall using (4)#8-32 x ½” self tapping
screws provided.
7. Use the Auto Eject instruction manual for wiring information. Wire the indicator to any 120 VAC circuit
on the vehicle so when the Auto Eject is plugged in the indicator will illuminate.
E-Z MOUNTING PLATE
GASKET
HEX NUT
E-Z MOUNTING PLATE
“O” RING
INDICATOR
#8 x 1”
SS SCREW
COVER
COVER GASKET
TRUCK WALL
SUPER AUTO EJECT
Figure1 Mounting
#8 x ½” THREAD CUTTING
SCREW
6.750
.250
#29 drill (0.136"Dia) 4Places
4.500
7.250
.250
5.000
Figure 2 Hole Template
Loading...