Kussmaul 091-84-086 User Manual

INSTALLATION INSTRUCTIONS

For

Model 091-84-086

Ford Park/Neutral

Electronic Interface

+12 volts

1 amp fuse

Input from Vehicle

Ignition Switch, STA (Red/Lt Blu)

Output to High Idle System

Park/Neutral Signal

Ground when in Park or Neutral

091-84-086

Park/Neutral

Interface

1

234

56

1. Locate module in a suitable location, preferably not under the hood, protected from
the environment and away from any sources of heat.

2. Connect pin 1 to +12 volts througha1ampere fuse supplied.

3. Connect pin 2 to a solid ground in the vehicle.

4. Pin 3 is connected to the vehicle ignition switch, STA, (Red/Lt Blu) or other suitable
location.

5. Test installation:

A. By placing the shift lever in PARK and checking that pin 4 shows

continuity to ground.

B. Place shift lever in REVERSE and note that there is no continuity

to ground on pin4.
C. Place shift lever in NEUTRAL and note pin 4 continuity to ground
D. Place shift lever in DRIVE and note NO continuity from pin 4 to ground

6. This completes the installation. Connect pin 4 to the required Neutral Safety
switch pin on the High Idle System.

Note that pin 4 goes to ground when in Neutral
or Park

SINCE 1967, DESIGNERS OF INNOVATIVE PRODUCTS

KUSSMAUL ELECTRONICS COMPANY, INC.

170 CHERRY AVENUE, WEST SAYVILLE, NEW YORK, 11796-1221 USA

TEL. In NY: TOLL FREE: FAX:[phone] 346-0857 631 567-5826