Kussmaul 091-55 User Manual

Page 1
FILE:091-55-120-REVF
INSTRUCTION MANUAL
SUPER AUTO EJECT
REV F: 03-28-05
1 YEAR WARRANTY
KUSSMAUL ELECTRONICS CO., INC.
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826
Page 2
CAUTION
The AUTO EJECT must be
connected to the starter
circuit so that the solenoid is
energized only while the engine
is cranking. If the solenoid is
energized continuously it will
OVERHEAT and BURN OUT.
FAILURE TO FOLLOW
THIS CAUTION NOTE
WILL VOID THE
WARRANTY
Page 3
INSTALLATION INSTRUCTIONS
V
1. Locate a convenient place on the vehicle to mount the AUTO EJECT. A minimum clearance of 3" behind the mounting panel is required.
2. Place the template in position and center punch in 5 places.
3. Drill 4 mounting holes, 3/16" diameter and one, 1 3/4" clearance hole for the AUTO EJECT.
4. On the 2 conductor cable the black wire is Connected to the vehicle's ground and the white wire to the vehicle's starter. USE #16 GAUGE WIRE OR HEAVIER.
5. On the 3 conductor cable connect the Green, Black and White power wires to the accessories on the vehicle.
6. Test installation by installing mating connector into the AUTO EJECT. Energizing the starter should energize the solenoid and eject the connector.
7. Keep connector and contacts of the AUTO EJECT clean. Clean contacts with WD-40 solvent as required. Make certain that WD-40 is dry before returning to service
NOTE THAT WD-40 SOLVENT IS FLAMMABLE AND MAY BE IGNITED BY A SPARK
Lubricate contacts monthly with "vaseline" to insure free operation.
Note: USE ONLY CORD CONNECTOR (PLUG) SUPPLIED WITH THE AUTO EJECT
All connectors are not identical, using a substitute may result in unreliable operations or failure of the AUTO EJECT to operate.
Note: Place the gasket
#8-32 x 1-1/4”
Pan Head
Screw
Weather
Proof Cover
Gasket Note: notch at bottom
Truck Wall
SUPER AUTO EJECT
k
c
a
l
B
Incoming Power to Vehicle
e
t
i
h
W
with the notch at the bottom when installing
Solenoid
To Battery
ehicle Starter
Chassis Ground
Wiring Diagram SUPER AUTO EJECT
Page 4
1 5/8" Dia. Hole
1 YEAR WARRANTY
All Auto Ejects manufactured by Kussmaul Electronics Company Inc. are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 year from the date the equipment was shipped. Equipment is to be returned, shipping charges prepaid and will be returned, after repair, shipping charges paid.
This warranty does not include normal wear and tear, pitting of the electrical contacts, malfunction due to contamination of the mechanism, or solenoid overheating due to improper installation.
Kussmaul Electronics Company, Inc. shall have no liability for damages of any kind to associated equipment arising from the installation and /or use of the Kussmaul Electronics Company, Inc. products. The purchaser, by the acceptance of the equipment, assumes all liability for any damages which may result from its installation, use or misuse, by the purchaser, his or its employees or others.
Loading...