Page 1
FILE: 091-117-xx.PM6.5
INSTRUCTION MANUAL
DATE: 8-30-2005
EURO CHARGER II
AUTOMATIC BATTERY CHARGER
KUSSMAUL ELECTRONICS CO., INC.
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796-1221
TEL: in NY 631-567-0314 TOLL FREE: 800-346-0857 FAX: 631-567-5826
MODEL #091-117-XX
3 YEAR WARRANTY
Page 2
INTRODUCTION
The EURO CHARGER II, Model 091-117-xx is a compact , completely automatic dual channel battery charger designed specifically for the fire service and emergency vehicles. The
voltage of each battery is individually controlled so that each battery is charged only as much
as required. Once the batteries are fully charged, current stops flowing to guard against overcharging and water boil-off. Of rugged construction, the charger is made to withstand the
shock and vibration encountered in vehicle mounted equipment. Utilizing components which
meet international safety requirements makes this charger ideal for worldwide applications.
BATTERY CHARGER FEATURES
Completely automatic operation, charges battery on demand
Input voltage, switch selectable, 115 volt or 230 volts
Output voltage regulated, eliminates overcharging battery
Output, current limited to protect charger from overloading
Optional charge indicators
INSTALLATION
The EURO CHARGER II automatic battery charger should be installed in an area with
adequate ventilation.
Mount the charger using the four holes provided.
Connect the wiring from the batteries to the output terminal strip
Double check battery wiring. V erify that the battery voltage appears at charger output
terminals.
Set the voltage selector to either the 1 15 volt or 230 volt position to match the input source
available.
Connect the input power to the input power terminal strip and energize charger.
Verify that power indicator is illuminated and charger is charging.
Page 3
INSTALLATION WIRING DIAGRAM
115 or 230 voltage selector switch.
NOTE:
Do not apply 230 volts to
the charger with the selector switch in the 115
volt position serious damage may result
Optional Bar-graph
Indicator
091-11-127-XX
5 AMP
POWER
FUSE
Bat 2
Gnd
Bat 1
Y
B
R
Optional Economy
Indicator
E
L
L
O
W
L
A
C
K
E
D
KUSSMAUL
MAINS
CHARGER
CHARGING
091-90-012-XX
Chassis
Ground
ON
EURO
BATTERY
A.C. Input Power
Line
Neutral
Ground
INPUT
LN
OUTPUT
BAT 1 BAT 2
++
Chassis
Ground
REMOTE
Chassis
Ground
IMPORTANT: Charger output wire size is 14 awg. Wire size is for a maximum length of 20 feet.
If wiring is to be longer, larger wiring is required. Additional information is available on request.
Page 4
SPECIFICATION & OUTLINE
SPECIFICATIONS:
Input: see chart
Output: see chart
Output Current: see chart
Charge Indicator: 0-15 amps 5%
Weight: 11 lbs
Model # Output Current Output Voltage Input Voltage Input Current Charge Indicator
091-117-12 12 Amp s 12 230/1 15, 50/60 Hz 1.3/2.6 Amps 15 amps
091-117-24 6 Amps 24 230/115, 50/60 Hz 1.3/2.6 Amps 8 amps
OUTLINE DRAWING
Page 5
INSTALLATION RECORD & WARRANTY
Date Installed
Installed By
Vehicle Identification
Vehicle Owner
WARRANTY
All products of Kussmaul Electronics Company Inc. are warranted to be
free of defects of material or workmanship. Liability is limited to repairing or
replacing at our factory, without charge, any material or defects which become apparent in normal use within 3 years from the date the equipment
was shipped. Equipment is to be returned, shipping charges prepaid and
will be returned, after repair, shipping charges paid.
Kussmaul Electronics Company, Inc. shall ha ve no liability f or damages
of any kind to associated equipment arising from the installation and /or use
of the Kussmaul Electronics Company, Inc. products. The purchaser , by the
acceptance of the equipment, assumes all liability for any damages which
may result from its installation, use or misuse, by the purchaser, his or its
employees or others.
Loading...