Kurgo Retro Bloom Bench Seat Cover User Manual

Installation:

1) Clip adjustable straps
(A) around your bench seat
head rests so that the cover
aligns itself with your vehicle’s
seat.

2) OPTIONAL There is an
optional back strap (B) that
attaches around the back of
your seat, clipping together in
the back. This is for extra
fitting support in vehicles
where the seat folds down.

Installation & care

3) The under-seat bungee
cord (C) simply slips through
triangle (D) and ties to the left
and right D-rings (E). Tie
straight across, leaving no
slack; tuck under the edge of
the seat there may be extra
bungee left over!

4) OPTIONAL At the end of
the excess bungee you will
find clips (F). These are
optional, and used for extra
fitted support around the
bench portion of your vehicles
seat. (See figure 1)

5) Use the extra storage
pockets (G) for anything you
like! We suggest lots of fun
dog stuff!

Become a fan of Kurgo on Facebook
so you can receive all the latest
updates, giveaways and contests.

Underside details are
shown as dashed lines

figure 1

From triangle (D) to
left & right D-rings (E)

To clip (F) Fastens
underneath seat

Washing instructions:

• Brush off loose dirt with a dry brush.

• As needed, wipe off with a damp sponge and mild soap.

• Rinse only, if possible. Use cold water and a sponge or rinse in a tub without soap.

• Machine wash in front-loading unit (DO NOT use machine with agitator, agitator could cause damage not covered
under warranty) with cold water and mild soap (Ivory Flakes, Woolite, Sport Wash, Etc.) No detergents.

• Rinse thoroughly to eliminate soap residue.

• Lay flat to dry.

8.10 For more information: 877.847.3868 :: www.kurgo.com :: [e-mail]