™
Installation
and care
Become a fan of Kurgo on
Facebook and receive all the latest
updates, giveaways and contests.
Parts List & Key:
A Bridge patform
B Seat strap
C Seat strap d-ring
D Between seat barrier
E Headrest strap
F Headrest strap d-ring
G Cup holder
H Barrier pocket
Installation:
1. Open the Backseat Bridge and
lay it across the backseat with the
preffered color up. Slide the bridge
forward until the edge is against the
back of the front seats. Place on top
of any front seat divider to ensure
the gap between the platform and
front seats is closed.
2. Secure strap (B) around the back rest of your driver’s
side seat, as close to the bottom of the seat as possible,
and clipping it to d-ring (C) (see Fig 1 and note to the
right). Repeat on your passenger’s side.
Seat strap d-rings (C)
on both front & back
Around
headrest
Seat strap (B)
Clipped to
d-ring (C) on
bottom side
of platform
Fig 1
Around
seat
Note: Seat Strap d-rings (C) are located on
both sides of the bridge. Conect to those
located on what will be the down side of
the Backseat Bridge.
3. Pull strap (E) around your driver’s side head
rest and clip onto d-ring (F) (see Fig 2). Repeat
this on the opposite side.
4. Adjust all straps for a secure fit.
Washing instructions: Brush off loose dirt with a dry brush.
As needed, wipe off with a damp sponge and mild soap. Lay flat to dry.
HARRISON SAYS…
Some dogs are overly excited to travel, making in and out of the car potentially dangerous.
If they understand ‘stay’ this issue can be avoided. I suggest practicing on a leash; opening
the car door and rehearsing ‘sit’ or ‘stay’ commands. Once stationary for a short time you can
give your pup an assertive ‘OK’ command, letting him know it is safe to get in or get out.
Make sure to always praise him when everything is done correctly.
Fig 2
Space should not be greater than 13”
between front and back seat
See the complete Dog Travel line at kurgo.com
1.14 For more information: 877.847.3868 :: www.kurgo.com :: info@kurgo.com
Loading...