Kucht KRH4802U, KRH3003U Installation Manual

www.kucht.com

BE A PRO IN YOUR KITCHEN

30” 36” 48”

900

CMF

RANGE HOOD

INSTALLATION GUIDE AND USER MANUAL

APPLICABLE MODEL: KRH3001U, KRH3601U, KRH4801U, KRH3002U, KRH3602U
KRH4802U, KRH3003U, KRH3603U, KRH3004U, KRH3604U

INSTALLATION GUIDE AND USER MANUAL

Safety Notice

Approved for residential type untis for residential use only read these indtructions and be safe.

Please read these instructions completely before starting.

The installation of the appliance must respect all codes.

Important: Save these instructiond so that you can provide the electrical inspector in your area.

Safety Warning:Turn off the circuit in the electrical panel and lock front panel to connect the cord of this unit.

Power requirement: 110V-120V/60HZ

CAUTION: USE THIS PRODUCT FOR GENERAL FAN ONLY. DO NOT USE THIS PRODUCT TO EXHAUST FUMES OR

HAZARDOUS OR EXPLOSIVE MATERIALS.

WARNINGl TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK OR INJURY TO PEOPLE, OBSERVE THE

FOLLOWING:

1. Use this unit only for the purposes intended by the manufacturer. If you have any questions about this product, contact the

manufacturer.

2. Before the machine’s maintenance or cleaning, turn off the electrical p

from accidentally activating the power. If it is not possible to lock the access panel, attach a highly visible label to the

electrical panel.

3. A qualified person should perform the installation and wiring of the electricity in accordance with all codes and all

standards, including fire resistance rating.

4. When you use hood together with stove, please do not close the window and door of the kitchen. Because during the fuel

stove working, which will consume lots of air, so do open the door and window to make the kitchen ventilating, to avoid

any suffocation.

5. It is important to provide sufficient air for proper combusion of heating equipment and proper evacuation of gases through

the chimney pipe to prevent back flow of air. Follow the instructions and safety standards

anel and lock the panel blocking feature to prevent

of the manufacturers of heating

equipment, such as those published by the National Fire Protection Association(NFPA),the American Society for Heating,

Refrigeration and Air Conditioning Engineers(ASJRAE) and the code authorities in your area.

6. When cutting or drilling into wall or ceiling, be sure not to damage electrical wiring or other access to public service.

7. Always evacuate outside the conduit system.

To reduce the risk of fire and to properly exhause air, be sure that the pipe is leading outside, do not exhause air into the

space between the walls, ceilings, attics, crawl spaces or garages.

FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM

INSTALLATION GUIDE AND USER MANUAL

Warning:

requirements mentioned.

WARNING: TO REDUCE THE RISK OF FIRE, GREASE THE RANGE.

1. Never leave the stove unattended when it is at a high temperature. Boil overs cause smoke and fat that overflows can

2. Always operate the hood when you use the stove to high heat or when you Flame.

3. Clean ventilating fans frequently. Do not let fat accumulate on the filters or propellers.

4. Use proper pan size. Always use a pot size appropriate to the stove element.

5. Do not touch on-workig or off-soon bulb, to avoid any thorny.

Warning

TO AVOID INJURING SOMEONE IN A GREASE FIRE, FOLLOW THE FOLLOWING:

1.SMOTHER FLAMES with a lid to the dimensions of the cooking

gas or power supply of the stove. BE CAREFUL NOT TO BURN YOURSELF. If the flames do not go out immediately, LEAVE

TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCT. Install this hood in accordance with all the

ignite. Heat the oil slowly at a low or medium temperature.

hobs, a cookie sheet or other metal tray, then turn off the

AND CALL THE FIRE DEPARTMENT.

2.NEVER PICK IP A FLAMMING PAN, you could hurt yourself.

3.DO NOT USE WATER, including Dish towels or wet towels-a violent steam explosion of dew may occur.

4. Use an extinguisher only if:

. You are sure to have a Class ABC extinguisher that you know how to use.

. The fire is small and confined to the area where it was formed.

.Firefighters were called.

.You can fight against the fire with an exit behind you.

Operative Mode

Always leave safety grills and filers in place. Without the presence of thesem blowers could catch hair, fingers or clothing. The

manufacturer is not liable if detailed in this manual for installation info, maintenance and proper use of the product

observed. The manufacturer declines all responsibility for any injury caused by negligence. This product is manufactured for

internal use. Do not use this appliance outdoors.

are not

FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM

INSTALLATION GUIDE AND USER MANUAL

Electrical requirements and installation requirements

Power Requirements

IMPORTANT

Observe all governing codes and ordinances. The customer is responsible for: Contacting an electrician-installer. Check that
the electrical installation is adequate and in conformance with the National Electrical Code, ANSI / NFPA 70 (latest edition *)
or CSA Standards C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.0-M91 (the latest edition **) of the CSA, and all
codes and ordinances in your area. If codes permit and use a wire to separate the ground, it is recommended to check the
path of the wire by an electrician. Do not put the device to land on a gas line. Consult a qualified person if you are not sure that
the hood is properly grounded electrically. Do not install a fuse in the neutral circuit or circuit ground.

Location of the electrical installation

• The cable must enter the rear wall at least 20 to 1/4 "above the height
"from the left side of the midline.
MPORTANT
Keep these instructions in order to return them to the electrical inspector. The hood must be plugged directly into a 110 volt
wall outlet.

of the installation base, and between 7-5/8" and 4-7/8

Before installing the hood

1. To ensure the most efficient ventilation possible, install the pipe in a straight line or with the least elbows possible.
CAUTION: The output of the vent pipe should give to the outside.

2. Two people are required for installation.

3. Supplied hardware can secure the hood to most walls and ceilings, consult a qualified installer to ensure that the
hardware provided is suitable for your type of wall or cabinet.

4.In the case of areas prone to COLD WEATHER,install a check against extra-circulation to minimize the cold air return and a
nonmetallic thermal break to minimize conduction of outside temperature in the duct. The valve must be placed on the side of
the cold air from the heat insulator. The insulation must be placed as close as possible to where the pipe enters the heated
part of the house.

5. Air booster: The building code in your area may require the use of a make-up air system if you use a ventilation system
which leads the movement of air exceeding a certain number of CFM. The number of ft3/min varies from one region to
another. Consult your HVAC professional for specific requirements in your area.
Remove the packaging.
CAUTION
Carefully remove the cardboard, gloves to protect against sharp edges.

FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM

INSTALLATION GUIDE AND USER MANUAL

Examples and positioning possibilities ducts

Follow the letter of the guidelines presented in this manual.
The manufacturer declines any liability with respect to any loss, damage or fire caused by non-observance of the instructions
contained in this manual.
Ventilation methods
The hood is equipped with a vertical transition to remove fumes outside.
Recommended diameter conduit model and wall chimney hood and hood island: vertical round pipe 7'' tolerance + or – 1.
Models Chimney hood Wall: KRH3003U, KRH3004U

FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM

INSTALLATION GUIDE AND USER MANUAL

Do not cut a joist or stud unless it is absolutely necessary to do so. If you need to cut a joist or stud, you must build a support
framework. Supplied hardware can secure the hood to most walls and ceilings. However, you should ask a qualified
technician to check the strength of materials depending on the type of wall or ceiling. Before cutting, make sure there is
enough clearance in the ceiling or wall for the outlet pass. You can determine for yourself how high you install the hood
above the stove. Over the hood near the stove, it is more effective to capture cooking odours, grease and smoke.

FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM

INSTALLATION GUIDE AND USER MANUAL

ClearanceTraining

Caution:

When install the hood, the height should not be too high or too low. Before the installation, please inspect the maximum height
of your ceiling and bonnet.Too high, will affect the efficiency of the hood; too low, stove temperature will damage some parts
of the hood. So the installation height requirement is: the distance between the bottom of the hood to the surface of the
cooktop is Max 30”/ Min 27”(as figure showing)

FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE WWW.KUCHT.COM