Page 1
KS-MINI-5P/8P
10/100 SOHO Switches
User’s Guide
DOC.070524-KSMINI-5P/8P
Page 2
1. Introduction
The 10BASE-T/100BASE-TX Switches which are high-performance Fast
Ethernet switches designed for the network core. It provides 5/8
10BASE-T/100BASE-TX ports that can significantly improve the performance
of your network’s backbone, and deliver the throughput needed to support a
broad range of advanced network applications. With Fast Ethernet Switches
high performance bandwidth, it provides the quickest solution to meeting the
growing demands on your network’s limited resources.
2. Features
z Compact size.
z 5/8-port 10/100 Mbps auto-MDI/MDI-X.
z Secure store and forward switching scheme.
z Auto correction of reverse twisted pair polarity.
z All ports support half/full duplex, Nway auto negotiation.
z All ports support 802.3x flow control for protection against data loss.
2
Page 3
3.Package Contents
z User guide.
z Power adapter.
z 10/100Mbps Ethernet Switch.
4. Hardware Introduction
4.1 Front Panel
POWER LED
This LED light is on when power is present.
5 Port LED
Indicates the status of each of the 5 ports.
8 Port LED
Indicates the status of each of the 8 ports.
Speed 100 Mbps LED
A green LED indicates the speed is 100 Mbps.
Link/Activity LED
There is a link when the LED light is lit, there is an activity when the
LED blinks.
3
Page 4
4.2
Rear Panel
DC-input
connect power adapter
5 Port Switch
connect computers, hub’s, switches or other devices.
8 Port Switch
connect computers, hub’s, switches or other devices.
4
Page 5
Specifications
Standards
IEEE 802.3 10BASE-T Ethernet
IEEE 802.3u 100BASE-TX Fast Ethernet
IEEE 802.3x Flow Control
Data Transfer Rate
- Ethernet : 10Mbps (half-duplex)
20Mbps (full-duplex)
- Fast Ethernet : 100Mbps (half-duplex)
200Mbps (full-duplex)
Interface
10/100Mbps Auto-MDI/MDI-X Ports
Diagnostic LED
Power, Link / ACT, 100Mbps
Power Input
DC 5V / 800mA
Dimension
5 Port Switch 78 x 98 x 28mm
8 Port Switch 109 x 155 x 33mm
Operating Temperature
0°C ~ 40° C
Operating Humidity
10% ~90% RH, Non-condensing
EMI Certification
FCC Class B / CE Class B
5
Page 6
5. FCC Warning
This equipment has been tested and found to comply with the regulations
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with this
user’s guide, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the
interference at his own expense.
z Reorient the receiving antenna.
z Increase the separation between the equipment and receiver.
z Connect the equipment into an outlet on a circuit in a different room
that to which the receiver is connected.
z Consult the dealer or an experienced radio/TV technician for help.
6. CE Mark Warning
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
6
Loading...