KTI Networks DH-8T User Manual

Installation Guide

10Base-T Ethernet Hub

Model: DH8T

DOC.980213-DH8T-K

P/N: 750-0104-001

KTI Networks Inc. All rights reserved. No part of this documentation may be
reproduced in any form or by any means or used to make any directive work
(such as translation or transformation) without permission from KTI Net­works Inc.

KTI Networks Inc. reserves the right to revise this documentation and to
make changes in content from time to time without obligation on the part of
KTI Networks Inc. to provide notification of such revision or change.

For more information, contact:

United States

KTI Networks Inc.
P .O. BOX 631008
Houston, Texas 77263-1008
Phone: [phone] Fax: [phone]
BBS: 713-2663015 E-mail: [e-mail]
Web: http://www.ktinet.com/

International

Fax: [phone]
E-mail: [e-mail]
Web: http://www.ktinet.com.tw/

The information contained in this document is subject to change without prior no­tice.

Copyright Ó KTI. All Rights Reserved.

TRADEMARKS

Ethernet is a registered trademark of Xerox Corp. NetWare is a registered trademark
of Novell Inc.

WARNING:

This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and if not installed and used in accordance with the
instruction manual may cause harmful interference in which case the user will be
required to correct the interference at his own expense.

NOTICE:

(1)The changes or modifications not expressively approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
(2)Shielded interface cables and AC power cord, if any, must be used in order to
comply with the emission limits.

CISPR A COMPLIANCE:

This device complies with EMC directive of the European Community and meets or
exceeds the following technical standard.
EN 55022 - Limits and Methods of Measurement of Radio Interference Characteris­tics of Information Technology Equipment. This device complies with CISPR Class
A.
WARNING: This is a Class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take adequate
measures.

CE NOTICE

Marking by the symbol CE indicates compliance of this equipment to the EMC
directive of the European Community. Such marking is indicative that this equip­ment meets or exceeds the following technical standards:
EN 55022: Limits and Methods of Measurement of Radio Interference characteris­tics of Information Technology Equipment.
EN 50082/1:Generic Immunity Standard -Part 1: Domestic Commercial and Light Indus­try.
EN 60555-2: Disturbances in supply systems caused by household appliances and similar
electrical equipment - Part 2: Harmonics.

10BASE-T ETHERNET HUB
INST ALLATION GUIDE

DOC.980214-DH8T-NK

P/N:750-0104-002

Table of Contents

Chapter 1 Introduction

Introduction ............................................................................... 1

Features.................................................................................... 2

Chapter 2 Installation

Installation................................................................................. 3

Checking AC Power .................................................................. 3

Chapter 3 Making Network Connection

Network Connectors.................................................................. 4

Connecting to an Ethernet Node ............................................... 5

Hub to Hub Connection via UTP Cable ...................................... 6

Chapter 4 Interpreting Hub LEDs

Locations of the Hub LED Indicators ......................................... 8

Interpretation ............................................................................. 8

Appendix

Specifications.......................................................................... 10

RJ-45 Jack Pin Assignments .................................................. 10

UTP Cabling Specifications ......................................................1 1