KT&C KPC-VD61NUB User Manual

M110-VD61-002

Mini Vandalproof Dome Camera

OPERATION MANUAL

Thank you for choosing our high quality camera.
Before attempting to connect or operate, please read and follow these instructions.

KEY FEATURES

These cameras are equipped with 1/3" Sony Exview HAD CCDⅡ, Solid-State Imaging Device
which provides superior performance. Its very low current consumption of 110mA or Less and
excellent durability (Vandal proof, IP66) allow easy installation in any location.

ACCESSORIES FURNISHED

Accessories DIY cable Mount screw Set Screw Manual L wrench Mount Guide

Q'ty - 4 3 1 1 1

Option 1 - - - - -

SPECIFICATIONS

Signal Format NTSC PAL
Image Device 1/3" Sony Exview HAD CCD
Scanning System 2 : 1 Interlace
H.Resolution 750TV Lines
Scanning Frequency H:15.734KHz, V:59.94Hz H:15.625KHz, V:50Hz
Total Pixels 1020(H) x 508(V) 1020(H) x 596(V)
Effective Pixels 976(H) x 494(H) 976(H) x 582(V)
Electronic Shutter Speed 1/60 - 1/100,000 sec Automatic 1/50 - 1/100,000 sec Automatic
S/N Ratio More than 50dB(AGC Off)
Gamma r =0.45
Min.Illumination 0.05Lux / F2.0
Sync System Internal
Video Output 1.0 Vp-p Composite 75(Ω)
Input Power Source DC 12V ±10%, Less than 110mA
Lens Fitted Board Lens
Operating Temperature -10℃ ~ +50
Storage Temperature -20℃ ~ +60
Dimensions Ø 82.2 x 63.6 mm
IP rating IP67

Specications and designs are subject to change for improving the functionality of this product without notice.

DIMENSIONS

Unit : mm

59.5

ø

30.3

ø

63.6

82.2

51

360° PAN

℃
℃

4-ø6.8
4-ø4 HOLE

Ⅱ

Indication of screen top

51

CAMERA MOUNTING POSITION

OPEN

CLOSE

Turn the lock counterclockwise pushing it up to

loosen it for ball part adjustment (step 1) and

loosen once more to dispart them completely
(step 2)

SCREW M2.5 x 3(3ea)
(Fixing Set)

FLAT WALL

TAPPING SCREW 3 X 20(4ea)
(Wall Mounting)

After installing the Camera, Housing
Please tighten the screw to secure.
(Packaged using L- Wrench)

CONNECTION

DC12V REGULATED POWER

DC MALE

BNC FEMALE

STANDARD DC12V BNC CONNECTION

When you install the camera, please glue up the end of cable to
keep it stable in order to protect the camera from the humidity problems.

VIDEO IN TV MONITOR

CAUTION

These servicing instructions are for use by qualified service personnel only.
To reduce the risk of electric shock do not perform any servicing other than that contained in the
operating instructions unless you are qualified to do so.

Use Class 2 Power Supply Only.

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to

Note:

part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.”

WARNING:

interference in which case the user may be required to take adequate measures.

Caution:

by the party responsible for compliance could void the user’s authority to operate the equipment.

1. A regulated DC12V 300mA power supply is recommended for use with this camera for the best picture and the
most stable operation.

An unregulated power supply can cause damage to the camera. When unregulated power supply is applied,
product warranty will be out of subject.

2. It is recommended that the camera is used with a monitor that has a CCTV quality 75 video impedance level. If
your monitor is switched to high impedance then please adjust accordingly.

3. Do not attempt to disassemble the camera to gain access to the internal componets. Refer servicing to your
dealer.

4. Never face the camera towards the sun or any bright or reective light, which may cause smear on the picture and

possible damage to the CCD.

5. Do not remove the serial sticker for the warranty service.

This marking shown on the product or its literature, indicate that it should not be disposed with
other household wastes at the end of its working life. To prevent possible harm to the environment
or human health from uncontrolled waste disposal, please separate this from other types of
wastes and recycle it responsibly to promote the sustainable reuse of material resources.
This product should not be mixed with other commercial wastes purchased this product, or their

local government ofce, for details of where and how they can take item for environmentally safe

recycling. Business users should contact their supplier and check the terms and conditions of the
purchase contract. Household users should contact either the retailer where they for disposal.

CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER(OR BACK). NO USER.

This is a class A product. In a domestic environment this product may cause radio

Any changes or modifications in construction of this device which are not expressly approved

CAUTION

Correct Disposal of This Product

(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems)

RISK OF ELECTRIC SHOCK DO NOT OPEN

SERVICING TO QUALIFED SERVICE PERSONNEL.

This symbol is intended to alert the user to the presence of uninsulated "dangerous voltage" within the

product's enclosure that may be of sufcient mangnitude to constitute a risk of electric shock to persons.

This symbol is intended to alert the user to the presence of important operating and
maintenance(servicing) instruction in the literature accompanying the appliance.

CAUTION

IMPORTANT SAFETY INSTRUCTION

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near water.

6) Clean only with dry cloth.

7) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8) Do not install near any heat sources such as radiators, heat registers,stoves, or other apparatus

(including ampliers) that produce heat.

9) Do not defeat the safety purpose of the polarized or grounding- type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the

third prong are provided for your safety. If the provided plug does not t into your outlet, consult an electrician for

replacement of the obsolete outlet.

10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.

11) Only use attachments/accessories specied by the manufacturer.

12) Use only with the cart, stand, tripod, bracket, or table specied by the manufacturer,

or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus

combination to avoid injury from tip-over.

13) Unplug this apparatus during lightning storms or when unused for long periods of time.

14) Refer all servicing to qualied service personnel. Servicing is required when the apparatus has been damaged
in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the

apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.