KT&C KPC-NSP301NU User Manual
M103-NSP301-002
NIGHT VISION DSP COLOR CCTV CAMERA
OPERATION MANUAL
Thank you for choosing our high quality camera.
Before attempting to connect operate this unit,
please read and follow these instructions.
KEY FEATURES
These CCD video cameras employ a SONY 1/3" CCD solid-state image device which provides
superior performance.
These cameras can be installed easily in most indoor and outdoor locations with a very low current
consumption of 380mA or less.
These cameras are not only easy to install but achieve an excellent reliability record.
ACCESSORIES FURNISHED
Accessories
Q'ty 1 3 1 1 1 1
Mounting
Bracket
Screw
Coin Hole
Bolt
Washer Sun Shield Manual
SPECIFICATIONS
Signal Format NTSC
Image Device 1/3" Sony Super HAD CCD
Scanning System 2 : 1 Interlace
H.Resolution 600TV Lines
Scanning
Frequency
Total Pixels 811(H) x 508(V)
Effective Pixels 768(H) x 494(V)
Electronic
Shutter Speed
S/N Ratio More than 50dB(AGC OFF)
Gamma r= 0.45
Sensitivity 0 Lux (IR LED ON)
Sync System Internal
Video Output 1.0 Vp-p Composite(75Ω)
Lens IR 3.6mm
IR LED 20 Units
IR LED Wavelength 850 nm
IR Beam Range Up to 30M
Input Power Source DC 12V ±10% Max. 380mA(IR LED On)
Operating
Temperature
Storage
Temperature
Operating Humidity Less than 80%
Water Resistant IP67
Specications and designs are subject to change for improving the functionality of this product without notice.
15.734KHz(H), 59.94Hz(V)
1/60 ~ 1/100,000 sec
14°F~122°F(-10°C~+50°C)
-4°F~140°F(-20°C~+60°C)
Ⅱ
DIMENSIONS
20LED
Photocell
CAMERA MOUNTING POSITION
Please assemble the coin
hole bolt as shown above.
Unit : mm
CONNECTION
BNC FEMALE VIDEO OUT
DC +12V MALE
DIY CABLE CONNECTION
When you install the camera, please glue up the end of cable to
keep it stable in order to protect the camera from the humidity problems.
VIDEO IN
DC12V REGULATED
POWER SUPPLY
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own expense.”
WARNING
This is a class A product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
Caution
Any changes or modifications in construction of this device which are not expressly approved by the party
responsible for compliance could void the user’s authority to operate the equipment.
1. A regulated DC12V 500mA power supply is recommended for use with this camera
for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
When unregulated power supply is applied, product warranty will be
out of subject.
2. It is recommended that the camera is used with a monitor that has a CCTV quality
75 video impedance level.
If your monitor is switched to high impedance then please adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal components.
Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reflective light, which may
cause smear on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.
Loading...