KT&C KPC-HDB230M User Manual
M172-HDB230-001
HD CCTV
Digital Video Camera
OPERATION MANUAL
Thank you for choosing our high quality camera.
Befor e attempting to connect or op erate, please read and follow
these instructions.
CAUTIONS CAUTIONS
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired operation.
Note -
This equipment has been tes ted and found to comply with the lim its for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is opera ted in a comme rcial envi ronment. T his equip ment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordan ce with the i nstruction manual, may ca use harmf ul
inter ference to r adio c ommunica tions. Operatio n of this equipme nt in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
WARNING -
This is a class A product. In a domestic environment this product may cause
radio interference in which case the user may be required to take adequate
measures.
Caution -
Any changes or modications in const ruction of this dev ies which are not
expressly approved by the party responsi ble for compli ance could void the
user's authority to operate the equipment.
1. A regulated DC12V 300mA power supply is recommended for use with this
camera for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera.
When an unregulated power supply is applied, the product warranty will be
roid.
2. It is recommended that the camera be used with a monitor that has a CCTV
quality 75Ω video impedance level. If your monitor is switched to high impedance
then please adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal
componets. Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reective light, which
may cause smear on the picture and possible damage to the image sensor.
5. Do not remove the serial sticker for the warranty service.
6. Do not expose the camera to rain or other types of liquid.
7. The apparatus must be connected to a main socket-outlet with a protective
earth connection.
CAUTION
(Waste Electrical & Electronic Equipment)
This marking shown on the product or its literature, indicates that
it should not be disposed with other household wastes at the end
of its working life. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, please separate
this from other types of wastes and recycle it responsibly
to promote the sustainable reuse of material resources.
Household users should contact either the retailer where they
purchased this product, or their local government ofce, for details
of where and how they can take item for environmentally safe
recycling.
Business users should contact their supplier and check the terms
and conditions of the purchase contract.
This product should not be mixed with other commercial wastes
for disposal.
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER(OR BACK). NO USER SERVICING TO
QUALIFED SERVICE PERSONNEL.
This symbol is intended to alert the user to the presence
of uninsulated "dangerous voltage" within the product's
enclosure that may be of sufcient mangnitude to constitute
a risk of electric shock.
This symbol is intended to alert the user to the presence of
important operating and maintenance(servicing) instruction in
the literature accompanying the appliance.
WEEE
CAUTION
COMPONENTS
HD CCTV Camera
Mounting Bracket
Screw - 3ea
Operation Manual
Option - Remote Control (OSD Key)
1M or 35M(Maximum working distance.)
INSTALLATION
Mount Position Monitor Connection
When you install the camera, please glue up the end of
cable to keep it stable in order to protect the camera from
the humidity problems.
* Remote Control - Circuit Diagram (Option)
Function
SW1: Menu OSD Menu on / off, Selection.
SW2: Up OSD Menu up.
SW3: Down OSD Menu Down.
SW4: Left OSD Menu Left.
SW5: Right OSD Menu Right.
Camera
BNC Female
(HD-SDI Jack)
DC12V IN (Black)
BNC Female (2'nd Video)
RCA Jack
(OSD Key Jack)
HD SDI IN
DC12V Power Supply
Monitor
5Key Remote Control
(Option)
DIMENSIONS
Board Lens
(Only IP67)
Board Lens
Pinhole Lens
23
Ф
17
Ф23Ф
50
Unit(mm)
16.8
23
Ф
1/4"-20UNC
77.5
68.6
61.5
40
4
4
4
28.6
3-Ф
3.2
24.8
OSD MANUAL
MAIN MENU 1st Sub MENU 2nd Sub MENU 3rd Sub MENU 4th Sub MENU
BRIGHTNESS 0 ~ 20
AE MODE NORMAL / DEBLUR
EXPOSURE
WHITE
BALANCE
D-WDR /
BLC
DNR OFF / LOW / MIDDLE / HIGH
DAY &
NIGHT
IMAGE
SPECIAL
SYSTEM
SHUTTER
DSS Off / X2 / X3 / X4 / X5 / X6 / X7 / X8
AGC 0 ~ 20
RESET DATA BACK / DEF
RETURN BACK / EXIT
WB MODE
SATURATION
RESET DATA BACK / DEF
RETURN BACK / EXIT
SHARPNESS 0 ~ 20
GAMMA 0.45 / 0.5 / 0.55 / 0.6 / 0.65
MIRROR OFF / ON
FLIP OFF / ON
DZOOM 1.0X / 1.1X / 1.2X / 1.3X …… 7.7X / 7.8X / 7.9X / 8.0X
DEFOG OFF / ON
LENS SHADING OFF / ON
RESET DATA BACK / DEF
RETURN BACK / EXIT
FOCUS ASSIST OFF / ON
PRIVACY OFF / ON
HLMASK OFF / ON
PATTERN OFF / ON
RESET DATA BACK / DEF
RETURN BACK / EXIT
SDI FORMAT 1080P / 720P
FRAME RATE 30(60) / 25(50)
CVBS FORMAT NTSC / PAL
APPLY OK / ON
LANGUAGE ENG / CHN / CHN(S)
SYSTEM INFO
REBOOT
RETURN BACK / EXIT
AUTO /
MANUAL /
FLICKER
AUTO / AUTOext
/ PUSH / MANUAL
0 ~ 20
OFF / BLC /
D-WDR
AUTO/ COLOR /
B&W
LEVEL
RETURN BACK / EXIT
COLOR TEMP
R-GAIN
B-GAIN
RETURN
H-POS
V-POS
H-SIZE
V-SIZE
RETURN BACK / EXIT
AGC THRES
AGC MARGIN
DELAY
RESET DATA
RETURN BACK / EXIT
MODE AUTO / MANUAL
LEVEL LOW / MIDDLE / HIGH
RETURN BACK / EXIT
WEIGHT 0% ~ 100%
RETURN BACK / EXIT
ZONE NUM 0 ~ 15
ZONE OP OFF / ON
H-POS 0 ~ 60
V-POS 0 ~ 40
H-SIZE 0 ~ 40
V-SIZE 0 ~ 40
Y LEVEL 0 ~ 10
CR LEVEL 0 ~ 10
CB LEVEL 0 ~ 10
RETURN BACK / EXIT
LEVEL 0 ~ 20
COLOR
RETURN BACK / EXIT
S/W VERSION
SET VERSION
RETURN BACK / EXIT
1/30(25),1/60(50),
1/120(100),1/240,1/500,
1/1K,1/4K,1/8K,1/16K,
1/30K,1/60K
LOW / MIDDLE / HIGH
0 ~ 20
0 ~ 20
BACK / EXIT
0 ~ 20
0 ~ 20
0 ~ 20
0 ~ 20
0 ~ 20
0 ~ 20
LOW / MIDDLE / HIGH
BACK / DEF
BLK / WHI / YEL / CYN /
GRN / MAG / RED / BLU
• Function Description
0. SETUP
- EXPOSURE: Go sub menu for camera exposure control.
- WHITE BALANCE: Go sub menu for camera white balance control.
- WDR/BLC: Go sub menu for camera WDR or BLC action.
- DNR: Control noise reduction setting.
- DAY & NIGHT: Go sub menu for camera day & night control.
- IMAGE: Go sub menu for adjust image functions.
- SPECIAL: Go sub menu for special feature control.
- SYSTEM: Go sub menu for system control & information.
- Reset Data All: Reset camera’s all feature data to default value.
1. EXPOSURE
- BRIGHTNESS: Adjust image brightness value.
- AE MODE: Adjust AE control Mode.
- SHUTTER: Select shutter speed control type.
LEVEL: Adjust shutter speed at manual shutter mode.
- DSS: Adjust digital slow shutter control level.
- AGC: Adjust max gain level for brightness control.
2. WHITE BALANCE
- WB MODE: Select white balance control mode.
AUTO: Full auto control mode in color temperature rage 2300K~10000K
AUTOext: Extened auto mode for special illumination.
PUSH: Enable fix the control setting for specific environment.
Push & release, for fix WB control setting
MANUAL: Enable WB control setting by user’s intention.
>COLOR TEMP: Select color temperature range for WB control at
>R-GAIN: Adjust red color gain for WB control at maual mode.
>B-GAIN: Adjust blue color gain for WB control at manual mode.
- SATURATION: Adjust image brightness value.
3. WDR/BLC
- MODE: Select WDR for BLC mode.
BLC: Act in Backlight compensation mode.
D-WDR: Digital wide dynamic range control.
- BLC H-POS: Select BLC control zone vertical position.
- BLC V-POS: Select BLC control zone horizontal position.
- BLC H-SIZE: Select BLC control zone vertical size.
- BLC V-SIZE: Select BLC control zone horizontal size.
4. DNR: Reduce image’s noise
5. DAY & NIGHT
- MODE: Select DN( Digital Day & Night control ) mode.
AUTO: Camera controlled automatically to decide day or night
environment using AGC calculation data.
COLOR: Fix to mode at day environment setting.
Make video image act in color.
B&W: Fix to mode at night environment setting.
Make video image act in B/W.
> AGC THRES: Threshold level for Change Day to Night or Night to
> AGC MARGIN: Hysteresis Level for Change Day to Night or Night to
> DELAY: Delay Time for change day or Night Mode at Auto mode.
6. IMAGE
- SHARPNESS: Adjust image sharpness level.
- GAMMA: Gamma Curve Select.
- MIRROR: Vertical Mirror Setting.
- FLIP: Horizontal flip setting.
- DZOOM: Select digital zoom magnification.
- DEFOG: Enable Defog compensation.
LEVEL: Defog compensation Level change at Auto / Manual mode.
-LENS SHADING: Enable lens shading compensation.
manual mode
Day mode.
Day mode.
7. SPECIAL
- FOCUS ASSIST: Enable Lens Focus Assist OSD. ( 1080P Mode Only ).
- PRIVACY: Setting for protect private area in image using mask setting.
ZONE NUM. : Select private mask zone number. V-SIZE : Select zone vertical size.
ZONE DISP. : Select zone mask display on/off. Y LEVEL : Select mask color ( Y Level ).
H-POS : Select zone horizontal position. CR LEVEL : Select mask color ( CR Level ).
V-POS : Select zone vertical position. CB LEVEL : Select mask color ( CB Level ).
H-SIZE : Select zone horizontal size.
- HLMASK: Mask image high light area.
LEVEL : Select high light level.
COLOR : Select mask color
- PATTERN: Color bar display Enable.
8. SYSTEM
- SDI FORMAT: 1080P / 720P
- SDI FPS: 30 or 25 fps in 1080p mode,
720P Mode: 60 / 50 fps.
- CVBS FORMAT: NTSC / PAL
- APPLY: Apply all video setting changed at once. Use the Set button to apply.
- SYSTEM INFO
S/W VERSION: Camera’s basic software version.
SET VERSION: Camera’s feature control setting version.
SPECIFICATION
Image Device 2.1 Mega Pixel, 1/3” Exmor SONY CMOS
Video output mode
Effective Pixels 1984 (H) x 1105 (V)
Unit cell size 2.8um (H) x 2.8um (V)
S/N Ratio More than 50dB
Minimum Illumination 0.1 Lux
Video Output HD-SDI / 1.0 Vp-p Composite ( 75Ω ).
Lens Board Lens, Pinhole Lens
Shutter speed Auto / Manual selectable
D-WDR / BLC OFF / BLC / D-WDR
3DNR OFF / LOW / MIDDLE / HIGH
Controllable Max Gain 23 dB
White Balance AUTO / AUTOext / PUSH / MANUAL
Digital Zoom Ratio 1X ~ 20X
Digital Slow Shutter OFF, X2 ~ X8
Privacy Masking Zone 16 ea , On / Off
Day & Night Digital Day & Night
OSD Remote Control
Operating Temperature 14°F~112°F (-10°C~+50°C)
Storage Temperature -4°F~158°F (-20°C~+70°C)
Power Consumption DC12V (±10%), Max. 110 mA
Dimensions (mm) 23.0(Ø) x 77.5(WaterProof Cap Housing only)
Weight Approx. 90g
IP Rating IP67 (WaterProof Cap Housing only)
Specications and designs are subject to change for improving the functionality of this product without notice.
HD-SDI: 1080p@30, 1080p@25, 720p@60, 720p@50
TV Out: NTSC / PAL selectable
Loading...