KT&C KPC-EW230NUWX User Manual
M155-EW230U-001
HIGH PERFORMANCE
BULLET CAMERA
OPERATION MANUAL
Thank you for choosing our high quality camera. Before
attempting to connect or operate, please read and follow
these instructions.
CAUTIONS
These servicing instructions are for use by qualied service personnel only. To reduce the risk of electric shock do not perform any servicing other than
that contained in the operating instructions unless you are qualied to do so.
In USA and Canada, Use Class 2 Power Supply Only.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note -
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.”
WARNING -
This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate
measures.
Caution -
Any changes or modications in construction of this devies which are not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
1. A regulated DC12V 300mA power supply is recommended for use with this camera for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera. When unregulated power supply is applied,
product warranty will be out of subject.
2. It is recommended that the camera is used with a monitor that has a CCTV quality 75 video impedance level. If your monitor is switched to high
impedance then please adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal componets. Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reective light, which may cause smear on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.
CAUTION
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European
countries with separate collection systems)
This marking shown on the product or its literature, indicate that
it should not be disposed with other household wastes at the end
of its working life. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, please separate
this from other types of wastes and recycle it responsibly to promote
the sustainable reuse of material resources.
This product should not be mixed with other commercial wastes
purchased this product, or their local government ofce, for details
of where and how they can take item for environmentally safe
recycling.
Business users should contact their supplier and check the terms
and conditions of the purchase contract.
Household users should contact either the retailer where they for
disposal.
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION : TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER(OR BACK). NO USER.
SERVICING TO QUALIFED SERVICE PERSONNEL.
This symbol is intended to alert the user to the presence
of uninsulated "dangerous voltage" within the product's
enclosure that may be of sufcient mangnitude to constitute
a risk of electric shock to persons.
This symbol is intended to alert the user to the presence of
important operating and maintenance(servicing) instruction in
the literature accompanying the appliance.
CAUTION
IMPORTANT SAFETY INSTRUCTION
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat
registers,stoves, or other apparatus (including ampliers) that produce heat.
9) Do not defeat the safety purpose of the polarized or
grounding- type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades
and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not
t into your outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11) Only use attachments/accessories specied by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specied by
the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualied service personnel. Servicing is
required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
COMPONENTS
Bullet
Camera
Mounting
Bracket
Screw 3ea
Operation
Manual
MOUNTING POSITION
(A'ssy View)
Unit(mm)
23
Ф
23
Ф
84.6
76.8
23
Ф
23
Ф
68.1
71.8
50
1/4"-20 UNC
15.5
15.5
15.5
15.5
1/4"-20UNC
40
CONNECTION
VIDEO IN
Yellow (Video Out)
Black (GND Common)
Red ( DC +12V IN)
LEAD WIRE CONNECTION (STANDARD)
DC12V
(BLACK)
BNC FEMALE
DIY CABLE CONNECTION
When you install the camera, please glue up the end of
cable to keep it stable in order to protect the camera from
the humidity problems.
VIDEO IN
Joy-Stick
Control Rubber
28.6
3-Ф
24.8
TV MONITOR
DC12V POWER SUPPLY
DC12V POWER SUPPLY
TV MONITOR
OSD MENU STRUCTUREDIMENSIONS
MAIN MENU 1st Sub MENU 2nd Sub MENU 3rd Sub MENU 4th Sub MENU 5th Sub MENU
AUTO
EXPOSURE
MANUAL
PUSH
ATW
PUSH LOCK
WDR MODE OFF, ON
BLC MODE OFF, ON
HLC MODE OFF, ON, AUTO
2DNR MODE OFF, ON
2DNR LEVEL 000 ~ 015
DNR
3DNR MODE OFF, ON
3DNR LEVEL 000 ~ 063
CONTRAST 000 ~ 063
SHARPNESS 000 ~ 015
USER1
USER2
ANTI CR
MANUAL
COLOR
AUTO
BW
RETURN
HV-FLIP OFF, ON
FREEZE OFF, ON
EZOOM 1.0x ~ 3.0x
RETURN
3.2
WHITE BAL
DAY&NIGHT
WDR / BLC
IMAGE
HIGH
LUMINANCE
LOW
LUMINANCE
RETURN
MODE SHUT, SLOW
SHUT
AGC 6, 12, 18, 24, 30, 36, 42, 44.8
RETURN
SPEED 000 ~ 255
DELAY CNT 000 ~ 255
ATW FRAME x0.5, x1.0, x1.5, x2.0
ENVIRONMENT INDOOR,OUTDOOR
RETURN
B-GAIN 000 ~ 255
R-GAIN 000 ~ 255
RETURN
B-GAIN 000 ~ 255
R-GAIN 000 ~ 255
RETURN
LEVEL UP PUSH ENTER
LEVEL DOWN PUSH ENTER
PRESET
RETURN
BURST OFF, ON
DELAY CNT 000 ~ 255
DAY -> NIGHT 000 ~ 255
NIGHT ->DAY 000 ~ 255
RETURN
BURST OFF, ON
RETURN
FLICKERLESS OFF / ON
BRIGHTNESS 000 ~ 255
MODE
AGC MAX 6, 12, 18, 24, 30, 36
DSS MAX 2, 4, 8, 16, 32, 64, 128, 256
BRIGHTNESS x0.25, x0.5, x0.75, x1.0
SHUT MODE ONLY
1/50(PAL), 1/60(NTSC),
1/100(NTSC), 1/120(PAL),
1/250, 1/500, 1/1000,
1/2000, 1/4000, 1/10000
SLOW MODE ONLY
2, 4, 8, 16, 32, 64, 128, 256
LEVEL 000 ~ 015
CONTRAST1 000 ~ 007
CONTRAST2 000 ~ 004
RETURN
BLC ZONE
LEVEL 000 ~ 015
RETURN
CLIP LEVEL 000 ~ 255
SCALE 000 ~ 015
RETURN
AGC, SLOW, AGC→SLOW,
SLOW→AGC, OFF
CENTER, TOP, BOTTOM,
LEFT, RIGHT
MAIN MENU 1st Sub MENU 2nd Sub MENU 3rd Sub MENU 4th Sub MENU 5th Sub MENU
SAVE&EXIT
SPECIAL
FACTORY
DEFAULT
EXIT
CAMERA TITLE OFF, ON
LANGUAGE ENGLISH /
PRIVACY
MOTION DET OFF, ON
AREA SEL 1/15 ~ 15/15
POSITION NEXT:PUSH ENTER
TRANSP ARENCY 0.00, 0.50, 0.75, 1.00
DISPLAY THE TITLE EDITING MENU
RETURN
/ ESPAÑOL / DEUTSCH / FRANCAIS / PORTUGUÊS /
Русский
MODE OFF, ON
WHITE, BLACK, RED, GREEN, BLUE,
COLOR
MOSAIC OFF, ON
RETURN
YELLOW, CYAN, MAGENTA
DETECT SENCE 000 ~ 127
BLOCK DISP OFF, ON
DETECT AREA EXIT: HOLD ENTER
MONITOR AREA
UP
AREA SEL 1/4 ~ 4/4
BOTTOM 000 ~ 015
RETURN
MENU
(SELECTION KEY)
中文
日本語 /
MODE OFF, ON
TOP 000 ~ 015
LEFT 000 ~ 023
RIGHT 000 ~ 023
LEFT
RIGHT
DOWN
SPECIFICATION
Signal Format NTSC PAL
Image Device 1/3” 960H SONY Double Scan Super HAD CCD II
Scanning System 2 : 1 Interlace
Scanning Frequency H:15.734KHz, V:59.94Hz H:15.625KHz, V:50Hz
Total Pixels 1028(H) X 508(V) 1028(H) X 596(V)
Effective Pixels 976(H) X 494(V) 976(H) X 582(V)
H.Resolution 750TV Lines
Electronic Shutter 1/60 ~ 1/100,000sec 1/50 ~ 1/100,000sec
S/N Ratio More than 50dB (AGC OFF, 3DNR ON)
Min.Illumination Color:0.1Lux (30IRE@F2.0, AGC 36dB) 0.000001Lux (DSS x256)
Gamma
Video Output 1.0 Vp-p Composite(75Ω)
Sync System Internal
Lens Board Lens, Pinhole Lens
Digital Zoom Ratio 3x
Digital Slow Shutter OFF, 2 ~ 256 Field
Flickerless ON / OFF
WDR ON / OFF (Level adjustable)
BLC ON / OFF (Level adjustment, Area selection)
HLC ON / AUTO / OFF (Level adjustable)
AGC OFF, 6 ~ 36dB
DNR(2D/3D) ON / OFF (Level adjustable)
Image Function Image reverse (Normal / Flip), Freeze, Contrast, Sharpness
Day & Night COLOR / BW / AUTO (DIGITAL D/N)
Motion Detection 4 Zones (Level adjustable, Area adjustment)
Privacy Masking 15 Zones (Area adjustment)
White Balance ATW / PUSH / USER1 / USER2 / ANTI CR / MANUAL / PUSH-LOCK
OSD Built in (Joystick)
LANGUAGE
Operating Temperature 14°F ~ 122°F (-10°C ~ +50°C)
Storage Temperature -4°F ~ 140°F (-20°C ~ +60°C)
Humidity Less than 80%
Power Consumption DC 12V (±10%), Max 140mA
Weight Approx. 68g
Dimension(mm) 23.0(Ø) x 85(mm)
ENGLISH /
FRANCAIS / PORTUGUÊS /
Specications and designs are subject to change for improving the functionality of this product without notice.
γ
=0.45
/ ESPAÑOL / DEUTSCH /
Русск ий
日本語
/
中文
Loading...