These fittings are Class II and do not require an Earth
Important Information
It is recommended that these luminaires are installed and fitted by a qualified electrician
ensuring the installation complies with current IEE wiring regulations & local building
control. These products are designed for connection to a 240V~50Hz supply.
Any faulty, broken or damaged luminaires should be replaced immediately.
KSR will not accept responsibility for any claims arising from a poor installation.
Please Note: The limited warranty shall be deemed null and void in the following circumstances: Failure by the installer, end user or
any third party to exercise caution to protect any covered product or part from outside damage, adverse temperature (normal
operating ambient temperature -15 ~ +40°C), humidity conditions, fluctuations in the electrical system or physical abuse as well as
failure related to workmanship in the installation of the products or parts.
Important User Advice
Always switch off mains supply before servicing lamp changes and maintenance.
Please ensure that a suitable maintenance schedule is performed including greasing any exposed metal parts and cleaning with a
non-abrasive cleaner to ensure the product gives you a long lasting trouble free life.
Installation Procedure
Safely isolate the mains supply before installation.
Remove the head by loosening the grub screw and twisting anticlockwise.
Route the cable through the cable gland (8mm-12mm) and terminate wiring as per Figure 1.
Install suitable lamp not exceeding the maximum wattage.
Refit the head in reverse of removal ensuring the seal is clean, in place and undamaged, grease the grub screw and tighten.
Tighten the cable gland ensuring a water tight connection.
Secure the bollard in place using suitable fixings for the application.
Turn mains supply on and test luminaire.
Never touch a hot lamp.
Drg No. KSR1180-1181-IS-A
KSR Lighting Ltd, Unit E Hazleton Interchange, Lakesmere Road, Horndean, Hampshire, PO8 9JU
13.07.2019MAC
Installation Sheet
KSR1180-1181
Read these instructions before commencing installation. Please give these instructions to the owner/occupier after
installation to retain for future reference/maintainence.
KSR Lighting Aftersales: 023 92 674343
E-mail: aftersales@ksrlighting.com
Lamp Details
KSR Lighting recommend only branded lamps
For example: Sylvania, GE, Philips or Osram
Lamp Cap: E27 GLS
Wattage: 46W (max)
IP65
0.3m
240V~50Hz 46W max.
E27 Bollards
Manta
Available finish:- Black
KSR1181
KSR1180
450mm
200mm 200mm
135mm
135mm
750mm
Fig.1
Mains Supply Luminaire
Switched Live - Brown
Neutral
Switch Live
N - Blue
Loading...