Krylon S00010000 User Manual
SP™010 Clear RTV Silicone Sealant
Not available.
Spray
(216) 566-2917
SAFETY DATA SHEET
Product name
Other means of
identification
Product type
Emergency telephone
number of the company
Section 1. Identification
:
:
:
:
Manufacturer
:
Sprayon Products
Cleveland, OH 44115
Relevant identified uses of the substance or mixture and uses advised against
Not applicable.
S00010000
S00010000
Product code
:
Product Information
Telephone Number
:
(800)247-3266
Regulatory Information
Telephone Number
:
(216)566-2902
Transportation Emergency
Telephone Number
:
(800)424-9300
Section 2. Hazards identification
FLAMMABLE AEROSOLS - Category 1
GASES UNDER PRESSURE - Compressed gas
SERIOUS EYE DAMAGE/ EYE IRRITATION - Category 2B
TOXIC TO REPRODUCTION (Fertility) - Category 2
SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 2
Classification of the
substance or mixture
:
Signal word
:
Danger
Hazard pictograms
:
Precautionary statements
Prevention
:
Obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Use personal protective equipment as required. Wear eye
or face protection. Keep away from heat, hot surfaces, sparks, open flames and other
ignition sources. No smoking. Pressurized container: Do not pierce or burn, even after
use. Do not spray on an open flame or other ignition source. Do not breathe vapor.
Wash hands thoroughly after handling.
GHS label elements
Percentage of the mixture consisting of ingredient(s) of unknown toxicity: 55.9%
OSHA/HCS status
:
This material is considered hazardous by the OSHA Hazard Communication Standard
(29 CFR 1910.1200).
Extremely flammable aerosol.
Contains gas under pressure; may explode if heated.
Causes eye irritation.
Suspected of damaging fertility.
May cause damage to organs through prolonged or repeated exposure.
:
Hazard statements
Date of issue/Date of revision
:
3/22/2015.
Date of previous issue
:
3/19/2015.
Version
:
1.01
1/10
Section 2. Hazards identification
Response
:
Get medical attention if you feel unwell. IF exposed or concerned: Get medical
attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove
contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get
medical attention.
Storage
:
Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50
°C/122 °F. Store in a well-ventilated place.
Disposal
Dispose of contents and container in accordance with all local, regional, national and
international regulations.
Hazards not otherwise
classified
:
None known.
Please refer to the SDS for additional information. Keep upright in a cool, dry place. Do
not discard empty can in trash compactor.
Supplemental label
elements
DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Contains solvents which
can cause permanent brain and nervous system damage. Intentional misuse by
deliberately concentrating and inhaling the contents can be harmful or fatal. FOR
INDUSTRIAL USE ONLY.
Section 3. Composition/information on ingredients
Octamethylcyclotetrasiloxane
30.7
556-67-2
1,1-Difluoroethane
4.0
75-37-6
Middle Petroleum Distillates
2.9
64742-46-7
Ingredient name
CAS number
% by weight
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Other means of
identification
:
Not available.
Substance/mixture
CAS number/other identifiers
:
Occupational exposure limits, if available, are listed in Section 8.
Mixture
Get medical attention.
Get medical attention following exposure or if feeling unwell.
Continue to rinse for at least 10 minutes. Get medical attention.
It may be dangerous to the person providing aid to give mouth-to-mouth resuscitation.
Get medical attention. In case of inhalation of decomposition products in a fire,
symptoms may be delayed. The exposed person may need to be kept under medical
surveillance for 48 hours.
Section 4. First aid measures
Eye contact
Skin contact
Inhalation
Ingestion
:
:
:
:
Description of necessary first aid measures
Most important symptoms/effects, acute and delayed
Inhalation
:
Exposure to decomposition products may cause a health hazard. Serious effects may
be delayed following exposure.
May be irritating to mouth, throat and stomach.
:
Ingestion
Skin contact
:
No known significant effects or critical hazards.
Causes eye irritation.
:
Eye contact
Over-exposure signs/symptoms
Potential acute health effects
Date of issue/Date of revision
:
3/22/2015.
Date of previous issue
:
3/19/2015.
Version
:
1.01
2/10
Section 4. First aid measures
Protection of first-aiders
:
No action shall be taken involving any personal risk or without suitable training. It may
be dangerous to the person providing aid to give mouth-to-mouth resuscitation.
Notes to physician
:
In case of inhalation of decomposition products in a fire, symptoms may be delayed.
The exposed person may need to be kept under medical surveillance for 48 hours.
Specific treatments
:
No specific treatment.
Skin contact
Ingestion
Inhalation
Adverse symptoms may include the following:
reduced fetal weight
increase in fetal deaths
skeletal malformations
Adverse symptoms may include the following:
reduced fetal weight
increase in fetal deaths
skeletal malformations
Adverse symptoms may include the following:
reduced fetal weight
increase in fetal deaths
skeletal malformations
:::
Eye contact
:
Adverse symptoms may include the following:
irritation
watering
redness
See toxicological information (Section 11)
Indication of immediate medical attention and special treatment needed, if necessary
Section 5. Fire-fighting measures
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training. Move containers from fire area if this can be done without risk. Use water
spray to keep fire-exposed containers cool.
Hazardous thermal
decomposition products
Specific hazards arising
from the chemical
Decomposition products may include the following materials:
carbon dioxide
carbon monoxide
halogenated compounds
carbonyl halides
metal oxide/oxides
Extremely flammable aerosol. In a fire or if heated, a pressure increase will occur and
the container may burst, with the risk of a subsequent explosion. Gas may accumulate
in low or confined areas or travel a considerable distance to a source of ignition and
flash back, causing fire or explosion. Bursting aerosol containers may be propelled from
a fire at high speed. Runoff to sewer may create fire or explosion hazard.
Special protective
equipment for fire-fighters
Use an extinguishing agent suitable for the surrounding fire.
Extinguishing media
:
:
:
None known.
Suitable extinguishing
media
:
Unsuitable extinguishing
media
:
Special protective actions
for fire-fighters
:
Date of issue/Date of revision
:
3/22/2015.
Date of previous issue
:
3/19/2015.
Version
:
1.01
3/10
Loading...