KRYLON® Industrial ECO-GUARD™ Latex Enamel
Satin White
Other means of
identification
Emergency telephone
number of the company
Section 1. Identification
THE SHERWIN-WILLIAMS COMPANY
KRYLON PRODUCTS GROUP
Cleveland, OH 44115
Relevant identified uses of the substance or mixture and uses advised against
Product Information
Telephone Number
Regulatory Information
Telephone Number
Transportation Emergency
Telephone Number
Section 2. Hazards identification
FLAMMABLE AEROSOLS - Category 1
GASES UNDER PRESSURE - Compressed gas
SERIOUS EYE DAMAGE/ EYE IRRITATION - Category 2A
CARCINOGENICITY - Category 2
SPECIFIC TARGET ORGAN TOXICITY (REPEATED EXPOSURE) - Category 2
Classification of the
substance or mixture
Percentage of the mixture consisting of ingredient(s) of unknown toxicity: 9%
Read label before use. Keep out of reach of children. If medical advice is needed, have
product container or label at hand.
This material is considered hazardous by the OSHA Hazard Communication Standard
(29 CFR 1910.1200).
Extremely flammable aerosol.
Contains gas under pressure; may explode if heated.
Causes serious eye irritation.
Suspected of causing cancer.
May cause damage to organs through prolonged or repeated exposure.
Date of issue/Date of revision
Section 2. Hazards identification
Obtain special instructions before use. Do not handle until all safety precautions have
been read and understood. Use personal protective equipment as required. Wear eye
or face protection. Keep away from heat, hot surfaces, sparks, open flames and other
ignition sources. No smoking. Pressurized container: Do not pierce or burn, even after
use. Do not spray on an open flame or other ignition source. Do not breathe dust or
mist. Wash hands thoroughly after handling.
Get medical attention if you feel unwell. IF exposed or concerned: Get medical
attention. IF IN EYES: Rinse cautiously with water for several minutes. Remove
contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get
medical attention.
Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50
°C/122 °F. Store in a well-ventilated place.
Dispose of contents and container in accordance with all local, regional, national and
international regulations.
Hazards not otherwise
classified
Please refer to the SDS for additional information. Keep upright in a cool, dry place. Do
not discard empty can in trash compactor.
Supplemental label
elements
DELAYED EFFECTS FROM LONG TERM OVEREXPOSURE. Contains solvents which
can cause permanent brain and nervous system damage. Intentional misuse by
deliberately concentrating and inhaling the contents can be harmful or fatal. WARNING:
This product contains chemicals known to the State of California to cause cancer and
birth defects or other reproductive harm. FOR INDUSTRIAL USE ONLY.
Section 3. Composition/information on ingredients
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Other means of
identification
CAS number/other identifiers
Occupational exposure limits, if available, are listed in Section 8.
Immediately flush eyes with plenty of water, occasionally lifting the upper and lower
eyelids. Check for and remove any contact lenses. Continue to rinse for at least 10
minutes. Get medical attention.
Flush contaminated skin with plenty of water. Remove contaminated clothing and
shoes. Continue to rinse for at least 10 minutes. Get medical attention. Wash clothing
before reuse. Clean shoes thoroughly before reuse.
Remove victim to fresh air and keep at rest in a position comfortable for breathing. If
not breathing, if breathing is irregular or if respiratory arrest occurs, provide artificial
respiration or oxygen by trained personnel. It may be dangerous to the person providing
aid to give mouth-to-mouth resuscitation. Get medical attention. If unconscious, place
in recovery position and get medical attention immediately. Maintain an open airway.
Loosen tight clothing such as a collar, tie, belt or waistband.
Section 4. First aid measures
Description of necessary first aid measures
Date of issue/Date of revision
Section 4. First aid measures
Wash out mouth with water. Remove dentures if any. Remove victim to fresh air and
keep at rest in a position comfortable for breathing. If material has been swallowed and
the exposed person is conscious, give small quantities of water to drink. Stop if the
exposed person feels sick as vomiting may be dangerous. Do not induce vomiting
unless directed to do so by medical personnel. If vomiting occurs, the head should be
kept low so that vomit does not enter the lungs. Get medical attention. Never give
anything by mouth to an unconscious person. If unconscious, place in recovery position
and get medical attention immediately. Maintain an open airway. Loosen tight clothing
such as a collar, tie, belt or waistband.
Protection of first-aiders
No action shall be taken involving any personal risk or without suitable training. It may
be dangerous to the person providing aid to give mouth-to-mouth resuscitation.
Treat symptomatically. Contact poison treatment specialist immediately if large
quantities have been ingested or inhaled.
Most important symptoms/effects, acute and delayed
No known significant effects or critical hazards.
Irritating to mouth, throat and stomach.
No known significant effects or critical hazards.
Causes serious eye irritation.
Over-exposure signs/symptoms
Adverse symptoms may include the following:
respiratory tract irritation
coughing
Adverse symptoms may include the following:
pain or irritation
watering
redness
Potential acute health effects
See toxicological information (Section 11)
Indication of immediate medical attention and special treatment needed, if necessary
Section 5. Fire-fighting measures
Hazardous thermal
decomposition products
Specific hazards arising
from the chemical
Decomposition products may include the following materials:
carbon dioxide
carbon monoxide
metal oxide/oxides
Extremely flammable aerosol. In a fire or if heated, a pressure increase will occur and
the container may burst, with the risk of a subsequent explosion. Gas may accumulate
in low or confined areas or travel a considerable distance to a source of ignition and
flash back, causing fire or explosion. Bursting aerosol containers may be propelled from
a fire at high speed. Runoff to sewer may create fire or explosion hazard.
Use an extinguishing agent suitable for the surrounding fire.
Suitable extinguishing
media
Unsuitable extinguishing
media
Date of issue/Date of revision
Section 5. Fire-fighting measures
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training. Move containers from fire area if this can be done without risk. Use water
spray to keep fire-exposed containers cool.
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Special protective
equipment for fire-fighters
Special protective actions
for fire-fighters
Section 6. Accidental release measures
Environmental precautions
Personal precautions, protective equipment and emergency procedures
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Approach release from upwind. Prevent entry into sewers,
water courses, basements or confined areas. Wash spillages into an effluent treatment
plant or proceed as follows. Contain and collect spillage with non-combustible,
absorbent material e.g. sand, earth, vermiculite or diatomaceous earth and place in
container for disposal according to local regulations (see Section 13). Dispose of via a
licensed waste disposal contractor. Contaminated absorbent material may pose the
same hazard as the spilled product. Note: see Section 1 for emergency contact
information and Section 13 for waste disposal.
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. In the case of aerosols being ruptured, care should be taken due to the rapid
escape of the pressurized contents and propellant. If a large number of containers are
ruptured, treat as a bulk material spillage according to the instructions in the clean-up
section. Do not touch or walk through spilled material. Shut off all ignition sources. No
flares, smoking or flames in hazard area. Avoid breathing vapor or mist. Provide
adequate ventilation. Wear appropriate respirator when ventilation is inadequate. Put
on appropriate personal protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Stop leak if without risk. Move containers from spill area. Use spark-proof tools and
explosion-proof equipment. Dilute with water and mop up if water-soluble. Alternatively,
or if water-insoluble, absorb with an inert dry material and place in an appropriate waste
disposal container. Dispose of via a licensed waste disposal contractor.
Methods and materials for containment and cleaning up
For non-emergency
personnel
If specialised clothing is required to deal with the spillage, take note of any information in
Section 8 on suitable and unsuitable materials. See also the information in "For nonemergency personnel".
Section 7. Handling and storage
Put on appropriate personal protective equipment (see Section 8). Pressurized
container: protect from sunlight and do not expose to temperatures exceeding 50°C. Do
not pierce or burn, even after use. Avoid exposure - obtain special instructions before
use. Do not handle until all safety precautions have been read and understood. Do not
get in eyes or on skin or clothing. Do not breathe vapor or mist. Do not ingest. Avoid
breathing gas. Use only with adequate ventilation. Wear appropriate respirator when
ventilation is inadequate. Store and use away from heat, sparks, open flame or any
other ignition source. Use explosion-proof electrical (ventilating, lighting and material
handling) equipment. Use only non-sparking tools. Empty containers retain product
residue and can be hazardous.
Precautions for safe handling
Date of issue/Date of revision