Page 1
Duothek Plus
Model #464
Instructions
for Use
Warranty
Guarantee of
Performance
Page 2
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety
precautions should always be followed to reduce the
risk of fire, electric shock, and/or injury to persons,
including the following:
● Read all instructions and information in this
instruction book and any other literature included in
this carton referring to this product befor
e
operating
or using this appliance.
● Do not touch hot surfaces. Use handles or knobs.
● To protect against electric shock, do not immerse
cord, plugs, or appliance in water or other liquid.
● Close supervision is necessary when any appliance is
used by or near children.
● Unplug from outlet when not in use and before
cleaning. Allow to cool before putting on or taking off
parts, and before cleaning the appliance.
● Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions, or has been
damaged in any manner. Return appliance to your
nearest authorized KRUPS service center for
examination, repair or adjustment.
(see Guarantee of Performance)
● The use of an accessory not evaluated for use with
this appliance may cause injuries.
● Do not use outdoors.
● Do not let cord hang over edge of table or counter, or
touch hot surfaces.
● Do not place on or near a hot gas or electric burner, or
in a heated oven.
● To disconnect, turn switch to “OFF”, then remove
plug from wall outlet.
Page 3
● Do not use appliance for other than intended use.
● Snap lid securely onto glass carafe before serving
beverages.
● Do not remove glass carafe from heating plate while
water is dripping from the spout.
● Appliance with glass carafe:
A. The carafe is designed for use with these
appliances.
It must never be used on a range top.
B. Do not set a hot carafe on a wet or cold surface.
C. Do not use a cracked carafe or a carafe having a
loose or weakened handle.
D. Do not clean carafe with rough cleansers, steel
wool pads, or other abrasive material.
SAVE THESE INSTRUCTIONS
Page 4
CAUTION
This appliance is for household use. Any servicing other
than cleaning and user maintenance should be performed
by an authorized KRUPS service representative.
(see Guarantee of Performance)
Do not immerse base in water or any other liquid.
To reduce the risk of fire or electric shock, do not remove
the base. No user serviceable parts inside. Repair should
be done by authorized service personnel only.
● Check voltage to be sure that the voltage indicated
on the name plate agrees with your voltage.
● Never use warm or hot water to fill the water
container! Use cold water only!
● Never refill the water chamber while this KRUPS
coffee maker is in operation, in the “on” position.
Turn the KRUPS coffee maker off and let cool down
for 10 minutes before refilling with water.
● Before turning your KRUPS coffee maker on, please
make sure that:
1. the filter is properly inserted into the swivel filter;
2. the swivel filter is properly closed;
3. the lid for the glass carafe is properly attached to
the glass carafe;
4. the glass carafe sits flat on the inside circle of the
heating plate.
● Keep your hands and the cord away from hot parts of
the appliance during operation.
● Never clean with scouring powders or hard
implements.
Page 5
SPECIAL CORD SET INSTRUCTIONS
Regarding your Cord Set:
A. A short power-supply cord is provided to reduce risks
resulting from becoming entangled in or tripping over
a longer cord.
B. Longer extension cords may be used if care is exercised
in their use.
C. If a long extension cord is used, (1) the marked
electrical rating of the extension cord should be at least
as great as the electrical rating of the appliance, (2) if
the appliance is of the grounded type, the extension
cord should be a grounding-type 3-wire cord, and (3)
the longer cord should be arranged so that it will not
drape over the counter top or table top where it can be
pulled on by children or tripped over.
D. This appliance has a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit into a polarized outlet only one
way. If the plug does not fit fully into the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician. Do not attempt to modify the plug
in any way.
Page 6
6
Duothek Plus
a hinged water chamber lid
b dual water level indicators
c swing out filter holder
d glass carafe
e warming plate
f illuminated on/off switch
g full flavor selector switch
(left side only)
h hidden cord storage
a
c
d
b
e e hf g f
Page 7
7
1
2
3
11
456
7
9
10
8
Page 8
8
KRUPS „Duothek Plus“
(model #464)
Your new Duothek Plus coffee maker is
a great new addition to your home or
office, and is the perfect choice for
entertaining. The Duothek Plus has the
following features:
● 2 x 10 cup dual coffeemaking system
makes one or two pots
simultaneously - perfect for
entertaining!
● Exclusive KRUPS “Deep Brew“
system with special filtering action
for maximum flavor.
● Electronically controlled dual
brewing cycle (left side only) slows
down the brewing process when
preparing less than 3 cups of coffee
to ensure full bodied flavor even in
small quantities.
● Swing out filter holders are
convenient to use and easy to clean.
● “Stop ‘n Serve“ feature lets you
serve a cup or two while brewing.
The automatic filter seal allows you
to remove the carafe for 20 seconds
without coffee dripping onto the
warming plate.
● Automatic warming plate keeps
coffee at the perfect drinking
temperature; however, due to the
breakdown of coffee´s aroma, we do
not recommend serving coffee which
has been kept warm more than one
hour.
● Dual water level indicators easily let
you measure how much water is in
each water chamber.
● Hinged water chamber lid will protect
the water chamber from dust and
dirt.
● Krups specially designed heating and
tubing system minimizes calcification
and leaves no residual water in the
system when brewing is finished.
● Hidden cord storage allows you to
set the desired cord length.
Preparing coffee
Before making your first pot of
delicious coffee, we recommend
operating the coffee maker once or
twice with water only, without ground
coffee or a paper filter to remove any
possible dust.
● Be sure that the water container is
empty. Remove literature, etc. if
inserted in the water container.
● The lid of the glass carafe must be
properly positioned during the
brewing process. Position the lid
over the carafe and snap the
rectangular piece onto the handle.
The lid is then locked in place.
● Make sure that the swing away filter
(e) is properly closed during the
brewing process, When closing the
swivel filter you will feel a noticeable
resistance between the swivel filter
and the base. Push in firmly until you
hear the filter “click“ into place.
● Caution: If the swivel filter is not
completely closed, the “Stop ‘n
Serve“ trigger will not function
properly, which may cause hot water
or hot coffee to overflow.
◆
Page 9
9
● The “Stop ‘n Serve“ mechanism is
opened as long as the glass carafe is
inserted into the machine and sits
properly on the warming plate and
the swivel filter is properly closed.
Filling the Water Chamber
Open the hinged lid (see figure 1).
Pour in the desired quantity of water
(see figure 2).
The water level indicator shows you
how much water you are filling into the
container
(see figure 3).
The amount of freshly brewed coffee
delivered after the brewing process will
always be slightly less than the amount
put into the water container. This is
due to the minimal absorption of the
water by the ground coffee. Therefore,
put in a little more water to begin with
so that you will have the number of
cups you desire.
Replace the carafe on the warming
plate with the glass carafe lid in
position.
Putting in the Ground
Coffee
To open the swing away filter holder,
move the filter handle to the left to
swing the filter out
(see figure 4).
Insert a paper filter (we recommend
Krups size 4) with the seam pointing
towards the handle of the filter holder
(see figure 5).
Instead of filter paper you can also use
the Krups goldtone filter (model #053).
(When ordering filter paper or the
goldtone filter from Krups be sure to
indicate that they are for model #464.)
Put ground coffee into the paper filter
(see figure 6). We suggest using one
level Krups measuring spoon of
ground coffee for each cup of robust
brewed coffee.
After using your Krups coffee maker
several times you can adjust the
measure to suit your own taste.
Close the swivel filter and make sure
that is completely closed
(see figure 7).
You will feel a noticeable resistance
between the swivel filter and the base.
Push in firmly until you hear the filter
“click“ into place.
Attention!
Make sure that the filter paper does not
tip over when closing the swivel filter,
or else the water might run between
the filter paper and the filter holder
producing a very weak cup of coffee.
Plug in the coffeemaker and turn the
on/off switch to the “on“ position (right
switch for right side, left switch for left
side)
(see figure 8).
Replace glass carafe on the warming
plate with the lid securely in position
(see figure 9).
Page 10
10
Selecting the fullest flavor
The Krups “Duothek“ has a full flavor
selector switch, if you want to make
1-3 cups of coffee, turn this switch to
the appropriate position
(see figure 10).
This will extend the brewing cycle so
that the water will seep into the ground
coffee slowly enough to yield brewed
coffee that is rich, aromatic and truly
delicious (works on left side only).
In order to have truly aromatic coffee,
the water must be allowed to seep
through the ground coffee for a certain
minimum of time.
For making 4-12 cups, the full-flavor
switch should be turned to the position
“4-max“.
„Stop’n Serve“ Feature
The “Stop’n Serve“ feature is KRUPS’
answer to the impatient coffee
drinker’s clamor for “a quick cup of
coffee!“. This device automatically
stops the flow of brewed coffee
through the filter cone of the glass
carafe is removed from the warming
plate during the brewing cycle. You
have about 20 seconds between the
removal of the carafe and its being
reinserted to allow the serving of one
or two cups of coffee.
The “Stop’n Serve“ device closes off
the filter cone so effectively that there
is virtually no coffee-drip onto the
warming plate (one drop, at most!).
Once the carafe is replaced, the
brewing cycle and the flow of the
coffee into the carafe are resumed.
Caution
If the coffee does drip onto the warming
plate after removal of the carafe, it is
usually an indication that the small black
seal in the filter holder is missing or
defective. It is also possible that too
much ground coffee has been placed
into the paper filter. This causes the
water that jets into the filter cone to
overflow between the paper filter and
the sides of the filter cone.
The overflow carries the coffee
grounds with it that interfere with the
snap-shot action of the filter holder,
thus allowing brewed coffee to
continue to drip through.
If this blockage and subsequent
dripping do occur, replace the glass
carafe immediately and allow the full
brewing cycle to run its course. Do not
swing out the swivel filter until the
brewing cycle is completed.
Cleaning
● Always unplug this appliance before
cleaning. Remove the filter holder by
opening the holder and lifting the
filter directly off (see figure 11).
● Clean the filter holder, the carafe and
carafe lid in a solution if hot water
and mild liquid soap. These parts can
also be placed in the upper level of
your dishwasher for safe effective
cleaning.
Page 11
11
● Never use scouring agents.
● Never immerse the appliance itself
in the water or any other liquid. To
clean, simply wipe off with a soft,
damp cloth.
●
Never use a cloth to clean the inside of
the water chamber, as this might leave
fuzzy deposits in the chamber. Just
rinse with cold water, periodically.
Decalcifying
Although your KRUPS coffee maker
has the most advanced water heating
and pumping system, it will
periodically need cleaning with a
decalcifying agent.
● This is due to the calcium (limestone)
found in drinking water.
●
In some areas where the water is hard,
you will need to decalcify more frequently than in areas with soft water.
● It will also depend upon how often
you use your coffee maker.
When to decalcify
You will know when such a cleaning is
necessary by an obvious slowdown in
the brewing time of your coffee. This
extended time indicates that there are
calcium deposits in your coffee maker.
We recommend using a decalcifying
agent for cleaning your KRUPS coffee
maker. If used in accordance with the
following instructions, it will prolong
the life of your coffee maker.
Decalcifying agents can be found in department and gourmet specialty stores,
or by calling KRUPS Consumer Service.
Limited One Year Warranty
Your KRUPS #464 is covered by the
following warranty:
If from date of purchase within one
year this KRUPS product fails to
function because of defects in
materials or workmanship, KRUPS
North America will, at its option, repair
or replace the unit with our charge,
provided the owner has a proof of date
of purchase.
This warranty will be void if
malfunction was caused by damage to
the product by accident, misuse, use
on frequency or voltage other than
marked on the product and/or
described in the instructions, abuse
including tampering, damage in transit,
or use for commercial purposes. This
warranty gives you specific legal rights,
and you may also have other rights
which may vary from state to state.
For best results...........
.........always use fresh , cold water
(warm water might be stale and have
mineral deposits which would impair
the flavor of the coffee).
.........we recommend that you grind
your own beans. Freshly ground beans
deliver more aroma and flavor. Use one
KRUPS measuring spoon of beans per
cup.
.........serve coffee immediately after
brewing.
........ never reheat coffee.
Page 12
GUARANTEE OF PERFORMANCE
This fine KRUPS product is manufactured according to a rigid
code of quality standards, and, with minimum care, should
give years of satisfying service. However, should the need
arise for repairs or for replacement parts within or after the
warranty period, please call our CONSUMER SERVICE
DEPARTMENT:
(800) 526-5377
24-hours a day, 7 days a week
You will be provided with specific instruction on how to get
your product repaired, as well as the name and address of
your nearest authorized KRUPS Service Center.
The department will also be able to answer any general
product questions you may have.
Before calling the Consumer Service Department, please have
the type number of your KRUPS appliance available.
You must have this information before calling our Consumer
Service Department so that we may better answer your
questions. The type number can be located by looking at the
bottom of your appliance.
This product is Type #464
Any general correspondance can be addressed to:
KRUPS North America, Inc.
P.O. Box 3900
Peoria, IL 61612
Loading...