KRG Corporate KRG Sigfox SeniorAdom DS-3423ST-00 GPS Tracker User Manual
GPS TRACKER
DESCRIPTION
SET UP
To acvate the GPS Tracker, press
the buon during 1 to 2 seconds.
LED will blink as described below.
1. Red LED on the tracker ashing
every 1 second.
SEND AN ALERT
To send an alert, push buon during
1 to 2 seconds.
1. Green LED will ash every
second during 1 minute.
2. Green LED lights on during 3
seconds to indicate an alert is sent.
KRG GPS tracker is designed to
send geolocalized alerts.
GPS tracker is a fully supervised
low-current detector including an
advanced Sigfox protocol.
BATTERY CHARGE
To indicate low
baery (<20%),
red LED will ash
every 10 seconds.
2. Green or red (depending on the
conguraon) LED lights on during
5 seconds.
3. The conguraon is set up.
When the device restarts aer a
hardware or soware reset or when
it is plugged to be recharged aer a
shutdown due to empty baery, it
will follow steps described before.
DIMENSIONS
59 mm
59,1 mm
To cancel the alert, push the buon
in the following 30 seconds during
10 seconds without interrupon.
Green LED will stop ashing
to inidicate alert has been well
canceled.
1. Put the GPS tracker into the
cradle to charge it.
2. Green LED will start ashing
every 3 secondes.
3. When the green LED stops
ashing and is connously
turned on, the device is fully
charged (around 2h).
SPECIFICATIONS
Sigfox Zone
RF Specicaon
Product Size
Buon
LED
Connector
IP Rang
Baery
Baery life
Operaon temperature
Storage temperature
Geolocaon
RCZ1 (Europe)
Sigfox Class 0
59,1mm(L) x 59mm(W) x 21,6mm(H)
One big button for emergency usage
Dual color LED Green and Red
1. One MicroUSB connector for battery
charging
2. One cradle to charge easily the tracker
IP65
Rechargable lithium. Baery 3.8V 630mAh
> 18 months
- 10 / +50c, 0-90% RH non-condensing
- 20 / +70c, 0-90% RH non-condensing
Geolocaon can not be fully guaranteed in
the following condions : indoor, in trac.
21,6 mm
Regulatory Notices:
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
responsible for compliance could void the user's authority to operate this equipment.
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may cause
undesired operation.
uncontrolled environment and are safe for intended operation as described in this manual.
The further RF exposure reduction can be achieved if the product can be kept as far as
possible from the user body or set the device to lower output power if such function is
available.
other antenna or transmitter.
FCC Caution: Any changes or modifications not expressly approved by the party
This device complies with Part 15 of the FCC Rules. Operation is subject to the
IMPORTANT NOTE:
Radiation Exposure Statement:
The product comply with the US portable RF exposure limit set forth for an
This transmitter must not be co-located or operating in conjunction with any
Loading...