Kreg Tool KFT4X8 User Manual
4-
Framing Table
INSTRUCTIONAL MANUAL
KFT4X8
The Blue Mark of Quality.
Version 20060401
1.
Table of Contents
4-
Thank you for your purchase!
Kreg Tool Company is proud to manufacture top
quality machines that are surpassed only by our commitment to customer service. If
after reviewing this manual you still have a question or concern that you would like
addressed please visit our website at www.kregtool.com, call 800-447-8638 or email:
techsupport@kregtool.com.
Table of Contents
TABLE OF CONTENTS 1
SAFETY GUIDELINES 2
PARTS DIAGRAM 3
ASSEMBLY INSTRUCTIONS 4-5
CLAMPING CYLINDERS 6
SQUARING THE FENCE 7
RETRACTING THE FENCE 8
OPTIONAL SCREW GUN & HOSE 9
MAINTENANCE 10
ACCESSORIES AND OTHER PRODUCTS 11
4-
Safety Guidelines
Safety Guidelines
• To avoid injury, never place hand under clamping cylinders while adjusting them.
• When drilling, make sure drill comes to a complete stop before removing or securing workpiece.
• Don’t use in dangerous environment. Keep work area well lit.
• Keep children and visitors away. All children and visitors should be kept a safe distance from work area.
• Wear proper apparel. No loose clothing, gloves, neckties, rings, bracelets, or other jewelry to get caught in
moving parts. Nonslip foot wear is recommended. Wear protective hair covering or hat to contain long hair.
• Maintain tools in top condition. Keep tools sharp and clean for best and safest performance
• Disconnect tools from power supply before servicing.
• Use recommended accessories. The use of improper accessories may cause hazards.
• Never sit or stand on table. Serious injury could occur if the table is tipped or falls over.
• Check damaged parts. Before further use of the tool, a guard or other part that is damaged should be carefully
2.
checked to ensure that it will operate properly and perform its intended function. Check for alignment of
moving parts, binding of moving parts, breakage of moving parts, mounting, and any other conditions that may
affect its operation. A guard or other part that is damaged should be properly repaired or replaced.
• Drugs, alcohol, medication. Do not operate table while under the influence of drugs, alcohol or any medication.
KREG TOOL COMPANY
4-
201 Campus Drive
Huxley, Iowa 50124
www.kregtool.com 800.447.8638
Parts Diagram
3.
4-
Transfer Arm
Air Pressure
Regulator
Fence
Knob
Squaring
Fence
Plastic
End Cap
Bottom
Fence
Clamping
Cylinder
Leg
Levelers
Screwgun
Holster
Master
Switch
Cylinder
Knob
Clamping
Pad w/
Grit Tape
Melamine Surface
Toggle
Switch
Part Number Quantity Description
#CT6041 1 Squaring Fence
#CT6040 1 Bottom fence
#CT6009 1 Transfer Arm
#CT6059 4 Clamping Cylinder
#DK1430 1 Air Pressure Regulator
#CT6031 1 Melamine Surface
#DK1317 4 Grit Tape
#DK1310 4 Clamping Pad
#CT6012 5 Toggle Switch
#CT6049 1 Screwgun Holster
#CT6042 3 Fence Knob
#CT6046 4 Cylinder Knob
#CT6001 4 5/32” Blue Coil Hose
#CT6003 8 Plastic End Caps
#CT6004 4 Leg Levelers
Loading...