Kraus Nola KPF-1660, Nola KPF-1640 Installation Manual

Download

Page 1

INSTALLATION MANUAL

Nola™ Single Lever Concealed

Pull Down Kitchen Faucet

KPF-1660

Page 2

Thank you for your purchase

We would like to take this opportunity to thank you for choosing Kraus. We hope that you are completely satised with your purchase, and enjoy it for years to come. If you have any questions, or require technical assistance, please contact us at 800-775-0703 and one of our representatives will be happy to help.

For more information about Kraus products, please visit:

www.kraususa.com

In order to activate your warranty and receive the full benet of customer support, please register your new Kraus product at:

www.kraususa.com/registration

Sincerely,

Kraus USA Customer Service

Page 3

6 5/8”

5 4/5”

3/8”

(10mm)

7/8”

19.7

(22mm)

8 5/16”

1 1/4-18UNF-2A

(21mm)

10 1/8”

(257mm)

1 3/8”

(35mm)

3 3/4”

(168mm)

(147.3mm)

(96mm)

Prior to Installation:

• Make sure you have all necessary parts by checking the diagram and parts list. If any part is missing or damaged, please contact Kraus Customer Service at 800-775-0703 for a replacement

• Turn o the hot and cold water supply at the angle stops and turn on the old faucet to release any built up pressure. Remove existing faucet. Clean sink or countertop to remove any debris, plumber’s putty, or silicone

• Place bucket under angle stops. Turn on to ush any debris prior to installing new plumbing. Shut o angle stops

• Pre-drilled hole size requirement: 1-3/8”

• Max countertop thickness without deck plate: 1-3/8”

Tools you will need

Adjustable Wrench

Bucket

Phillips Screwdriver

Safety Goggles

Page 4

Diagram and Parts List

A. Spray Head

B. Faucet Body

C. Mounting Hardware

C1. Rubber & Metal Washer

C2. Mounting Nut

C3. Mounting Screws

D. Supply Hose

D1. Supply Hose Washer

E. Check Valve Connector

F. Weight

G. Hot & Cold Waterlines

H. Aerator Key

I. Faucet Extender (used for top

mount sinks only)

J. 2.5 mm Hex Wrench K. Deck Plate Assembly

Page 5

Faucet Dimensions

9.7” (183mm)

18.3” (473mm)

8.1”

(206mm)

Ø54

35MAX

360

Page 6

Step 1: Remove mounting hardware

Remove mounting

hardware (C) from

mounting pipe

Step 2: Install faucet and mounting hardware

Insert faucet body (B) into

hole in countertop or sink.

Install mounting hardware

countertop

Note: Deck plate assembly

(K) can be used to cover

preexisting holes

Page 7

Step 3: Secure mounting hardware

Adjust the direction of

faucet body (B). Tighten

mounting nut (C2) until

snug. Tighten mounting

screws (C3) to nut with a

Phillips screwdriver until

snug

Step 4: Attach spray hose and counterweight

E D

Connect hose (D) to check

valve connector (E). Tighten

with wrench. Install weight

(F) on lowest vertical point on

hose (D)

Page 8

Step 5: Connect waterlines

E D

Connect waterlines (G) to

copper lines and angle

stops. Tighten both ends of

waterlines with an adjustable

wrench until snug. Turn on

angle stops and check for

leaks (DO NOT TURN FAUCET

ON)

Step 6: Flush spray hose

Remove spray head (A)

from hose (D). Hold tip of

hose (D). Turn faucet on

for 60 seconds to ush any

debris

Installer Tip: Please make

sure washer (D1) is installed

prior to attaching spray

head (A) to hose (D)

Page 9

Hot Water

Cold Water

Push

Step 7 : Check for leaks

Check for leaks at the

connections

Care & Maintenance

*To keep the product clean & shining, follow the steps below:

1. Rinse with clean water & dry with a soft cloth

2. Do not clean with soaps, acid, polish, abrasives, or harsh cleaners

3. Do not use cloth with a coarse surface

4. Unscrew the aerator and clean when necessary

*This installation manual is subject to change without further notice.

Page 10

Replacement Parts

1. A. Spray Head

B. Check Valve

2. Washer

3. Spray Hose

4. Plastic Cover

5. Pivot Clip

6. Cover Button

7. Set Screw

8. Metal Handle

9. Cartridge Cover

10. Locking Nut

11. Cartridge

12. Rubber & Metal Washer

13. Mounting Nut

14. Mounting Screw

15. Protective Sleeve

16. Weight

17. Check Valve Connector

18. Aerator Key

19. Faucet Extender

20. 2.5 mm Hex Wrench

21. Hot & Cold Waterlines

22. Deck Plate Assembly

Page 11

Trouble - Shooting

If you have followed the instructions carefully and your faucet still does not work

properly, take the following corrective steps:

PROBLEM CAUSE ACTION

Leaking from faucet handle

Water does not shut off completely

Locking nut (10) may have come loose, or cartridge (11) may need to be reseated

Cartridge (11) may need to be adjusted or replaced

Remove cover button (6). Loosen set screw (7) with 2.5 mm hex wrench (20). Remove handle (8). Unscrew cartridge cover (9) by hand. Tighten locking nut (10) with an adjustable wrench

Remove cover button (6). Loosen set screw (7) with 2.5 mm hex wrench (20). Remove handle (8). Unscrew cartridge cover (9) by hand. Unscrew locking nut (10) with an adjustable wrench. Remove cartridge (11). Check for cracks, and if O-ring is seated correctly. Reseat cartridge (11)

Page 12

PROBLEM CAUSE ACTION

Leaking between spray head and hose

Hose does not retract Weight (16) may be

Low flow Check valve connector

Spray head (1A) may be loose or washer (2) may not be seated correctly in the hose connection

installed incorrectly

(17) may be clogged with debris

Tighten spray head (1A) by hand until snug. Make sure washer (2) is seated correctly

Readjust weight (16) on the hose (3)

Remove check valve connector (17) from supply line. Soak in 50/50 solution of warm water and vinegar for 5 minutes. Reinstall check valve connector (17)

Page 13

Maintenance - Cartridge Replacement

Step 1: Remove button

located at the top of the

handle. Loosen the set

screw with a hex wrench.

Remove the handle and

unscrew cartridge cover by

hand

Step 2: Unscrew the

locking nut with an

adjustable wrench. Remove

ceramic disc cartridge

Step 3: Place the new

cartridge in the handle

seat. Secure the cartridge

with the locking nut and

assemble the handle

Page 14

Codes/Standards Applicable:

NSF/ANSI 372

NSF/ANSI 61-9

GREEN

Water Eciency

LEAD FREE

Meets ASME A112.18.1M/A112.18.1

1.8gpm 6.8L/min maximum

KRAUS LIMITED LIFETIME WARRANTY

This product has been manufactured and tested to the highest quality standards by Kraus USA Inc. (“Kraus”). We offer our customers thoughtfully crafted fixtures & accesso-

ries, engineered for enduring performance over years of use.

WHO IS COVERED BY THE WARRANTY

This warranty extends to the original purchaser only. This warranty is not transferable, between homes or owners and is only applicable to residential use.

WHAT IS COVERED BY THE WARRANTY

Kraus warranties this product against defects due to material or craftsmanship error during the warranty period: Kraus will provide replacement parts at no charge, or at its option, replace any product or part of the product that is deemed defective, under normal installation, use, service and maintenance. If Kraus is unable to provide a replacement and repair is not practical or cannot be made in timely fashion, Kraus may elect to

refund the purchase price in exchange for the return of the product.

CONDITIONS AND EXCLUSIONS

Like other home fixtures, Kraus products will require light maintenance to ensure proper function. We provide you with complete knowledge to perform this maintenance and can also recommend resources if you are unable to fulfill this service.

A. Kraus will not be responsible for product failures due to lack of maintenance or proper use. Please read your care and maintenance documentation to determine the limits of proper use.

B. The original sales receipt, order number, and/or proof of purchase must be presented at the time of the warranty claim, without exception, for this warranty to be applied to all Kraus products.

C. Kraus recommends installing all Kraus products with a licensed, professional plumber. Kraus will not be held responsible for any damage or product failure due to improper installation, misuse, or failure to use a licensed professional. Please read your care and maintenance documentation to determine the limits of proper use.

D. Commercial use will automatically void this warranty.

E. This warranty is not applicable to Kraus products purchased from an unauthorized seller. For a complete list of authorized sellers please visit http://www.kraususa.com/ where-to-buy.html

Page 15

NONAPPLICABILITY OF THIS WARRANTY

By the purchase and use of our products, you agree that Kraus is not liable for incidental, consequential or special damages associated with the return, replacement, installation or use of your product. This includes freight costs, cartridge replacement, labor, travel time, lost profit, home damages and other contingent liabilities and costs (including, without limitation, costs associated with experts, investigations, analyses, attorneys and other professionals and services). The Kraus warranty is a comprehensive and explicit limit of liability, and all items outside of it are not addressable by or the responsibility of Kraus. Certain states have variances regarding implied warranties and in those situations we remain fully compliant.

KRAUS USA Inc. makes no implication that products comply with any or all local building or plumbing codes. It is the consumer’s responsibility to determine local code compli-

ance. This warranty extends to the original purchaser and first consumer.

HELP LINE

Our customer service hours are Monday – Friday, 9am – 8pm EST. Be sure to visit our website at www.kraususa.com

If you are a homeowner please contact a Kraus Customer Service Representative at:

Kraus USA, Inc. 12 Harbor Park Drive Port Washington, NY 11050 Toll-free 800-775-0703 Customerservice@kraususa.com

If you are a plumbing contractor or trade professional please contact a Kraus Pro Representative at:

Kraus USA, Inc. 12 Harbor Park Drive Port Washington, NY 11050 516-801-8955 Proservice@kraususa.com

If you are an Authorized Partner please contact a Partner Support Representative at:

Kraus USA, Inc. 12 Harbor Park Drive Port Washington, NY 11050 516-801-8954 Partnersupport@kraususa.com

In requesting warranty service, please be ready to provide:

1. Proof of purchase.

2. A description of the problem.

Page 16

www.kraususa.com