Page 1
Ramus Single Handle Lavatory Faucet
INSTALLATION MANUAL
www.kraususa.com I toll free: 1.800.775.0703 I © 2013-2014 Kraus USA Inc.
FVS-1007
Page 2
Congratulations on your new Kraus purchase!
We would like to take this opportunity to thank you for your business with Kraus USA.
It is our sincere hope that you are completely satised with your Kraus experience.
We welcome any questions or comments you may have, and look forward to assisting
you in the future.
For more information about Kraus products, please visit our website at:
www.kraususa.com.
In order to allow us to serve you better, we recommend registering your new Kraus
product at: www.kraususa.com/product-registration
Sincerely,
Kraus Customer Service Department
Page 3
BEFORE INSTALLATION
Check to make sure you have the following parts:
(42.5 mm Max)
7A
8B
8C
8D
8A
7A
8B
8C
8D
8A
Included Parts:
• Faucet
• Rubber Washer
• Metal Washer
• Mounting Nut
• Mounting Screws
• Base Trim Ring
• Rubber Washer
• Hot & Cold Waterlines
TOOLS REQUIRED:
3 5/8”
3/8”
(10mm)
7/8”
19.7
º
(22mm)
8 5/16”
1 1/4-18UNF-2A
(21mm)
10 1/8”
(257mm)
1 3/8”
(35mm)
3 3/4”
(168mm)
(96mm)
3/8”
(10mm)
7/8”
19.7
º
(22mm)
8 5/16”
1 1/4-18UNF-2A
(21mm)
10 1/8”
(257mm)
1 3/8”
(35mm)
3 3/4”
(168mm)
(96mm)
3/8”
(10mm)
7/8”
19.7
º
(22mm)
8 5/16”
1 1/4-18UNF-2A
(21mm)
1 3/8”
(35mm)
3 3/4”
(168mm)
(96mm)
3 5/8”
3/8”
(10mm)
7/8”
19.7
º
(22mm)
8 5/16”
1 1/4-18UNF-2A
(21mm)
1 3/8”
(35mm)
3 3/4”
(168mm)
(96mm)
Adjustable
Wrench
Phillips Head
Screwdriver
Silicone
Sealant
Hex
Wrench
Pipe Tape
Installer Tip
Shut o main water supply before installation.
Page 4
Faucet Installation Procedure
3 5/8”
3/8”
(10mm)
7/8”
19.7
º
(22mm)
8 5/16”
1 1/4-18UNF-2A
(21mm)
10 1/8”
(257mm)
1 3/8”
(35mm)
3 3/4”
(168mm)
(96mm)
Safety Tips
• If soldering the water connections when installing the faucet, remove the O-rings,
cartridges, and washers before applying any heat
• Protect your eyes with safety glasses when cutting or soldering
Installer Tip
∅ - Hole Size 1 3/8”
3 5/8”
3/8”
(10mm)
7/8”
19.7
º
(22mm)
8 5/16”
1 1/4-18UNF-2A
(21mm)
10 1/8”
(257mm)
1 3/8”
(35mm)
3 3/4”
(168mm)
(96mm)
∅ 1 3/4”
(
∅ 45mm)
∅ 1 15/16”
(
∅ 50mm)
9/16”-18UNEF
∅ 1 15/16”
(
∅ 50mm)
12 7/16”
(316mm)
1 5/8”
(42.5 mm Max)
Page 5
Step 1
Remove rubber washer (8A),
metal washer (8B), mounting
nut (8C), and mounting
screws (8D). Keep the base
trim ring (7A) and rubber
washer (7B) on the base of
the faucet
27mm ~ 41.3mm
1 1/16” ~ 1 5/8”
7A
8B
8C
8D
8A
Step 2
(
∅ 45mm)
9/16”-18UNEF
27mm ~ 41.3mm
1 1/16” ~ 1 5/8”
∅ 1 15/16”
(
∅ 50mm)
1 5/8”
Install the faucet through the
1-3/8” predrilled hole in the
countertop. Attach rubber washer
(8A), metal washer (8B), mounting
nut (8C), and mounting screws
(8D) on the threaded mounting
pipe. Tighten the mounting nut
(8C) until snug. Tighten screws
(8D) on the mounting nut (8C)
with a Phillips head screw driver
until snug
Page 6
Step 3
Step 4
27mm ~ 41.3mm
1 1/16” ~ 1 5/8”
27mm ~ 41.3mm
1 1/16” ~ 1 5/8”
Install ex water supply lines on
the angle stops and tighten with
an adjustable wrench. Turn on
both the cold and hot main valves
Apply pipe tape (optional)
After installing the faucet, remove
the aerator (6) with the included
aerator key (10). Turn on the water
to remove any leftover debris,
then reassemble the aerator (6)
Page 7
Replacement Parts
Keep this manual for ordering replacement parts.
12 7/16”
(316mm)
1 5/8”
(42.5 mm Max)
1. (A) Index Button
(B) Set Screw
2. Metal Handle
3. Trim Cap
4. Locking Nut
5. Ceramic Disc Cartridge
6. Aerator
7. Mounting Hardware
(A) Base Trim Ring
(B) Rubber Washer
8. Mounting Hardware
(A) Rubber Washer
(B) Metal Washer
(C) Mounting Nut
(D) Mounting Screws
9. Hex Wrench
10. Aerator Key
Page 8
Trouble - Shooting
If you have followed the instructions carefully and your faucet still does not work
properly, take the following corrective steps:
PROBLEM CAUSE ACTION
Leakage under the
handle
Adjusting locking nut
(4) has come loose
Remove handle index
button (1a). Loosen
set screw (1b) with
hex wrench (9).
Remove handle (2)
by hand only. Tighten
locking nut (4) with an
adjustable wrench
Aerator drips or has
inconsistent water flow
pattern
Aerator (6) is dirty or
not seated properly
Unscrew aerator (6)
with aerator key (10)
and clean out debris
Water will not shut off
completely
Cartridge may be
defective
Remove handle index
button (1a). Loosen
set screw (1b) with hex
wrench (9). Remove
handle (2) by hand only.
Unscrew trim cap (3)
by hand only. Unscrew
the locking nut (4) with
an adjustable wrench.
Remove ceramic disc
cartridge (5). Check for
cracks
Leaking between spout
and body
Loose spout or
damaged O-rings on
connector
Tighten set screw under
the spout
Page 9
Care & Maintenance
*To keep the product clean & shining, follow the steps below:
1. Rinse with clean water & dry with a soft cloth
2. Do not clean with soaps, acid, polish, abrasives, or harsh cleaners
3. Do not use a cloth with a coarse surface
4. Unscrew the aerator and clean when necessary
*This installation manual is subject to change without further notice.
Hot
Water
Cold
Water
Push
Page 10
Codes/Standards Applicable:
Specied model meets or exceeds the following: ANSI/ASME A112.18.1, cUPC,
AB1953
Codes/Standards Applicable:
Specied model meets or exceeds the following: ANSI/ASME A112.18.1, cUPC,
AB1953
KRAUS LIMITED LIFETIME WARRANTY
This product has been manufactured and tested to the highest quality standards
by Kraus USA Inc. (“Kraus”). We offer our customers thoughtfully crafted fixtures
& accessories, engineered for enduring performance over years of use.
WHO IS COVERED BY THE WARRANTY
This warranty extends to the original purchaser only. This warranty is not
transferable, between homes or owners and is only applicable to residential use.
WHAT IS COVERED BY THE WARRANTY
Kraus warranties this product against defects due to material or craftsmanship
error during the warranty period: Kraus will provide replacement parts at
no charge, or at its option, replace any product or part of the product that is
deemed defective, under normal installation, use, service and maintenance. If
Kraus is unable to provide a replacement and repair is not practical or cannot
be made in timely fashion, Kraus may elect to refund the purchase price in
exchange for the return of the product.
CONDITIONS AND EXCLUSIONS
Like other home fixtures, Kraus products will require light maintenance to
ensure proper function. We provide you with complete knowledge to perform
this maintenance and can also recommend resources if you are unable to fulfill
this service.
A. Kraus will not be responsible for product failures due to lack of maintenance
or proper use. Please read your care and maintenance documentation to determine the limits of proper use.
B. The original sales receipt, order number, and/or proof of purchase must be
presented at the time of the warranty claim, without exception, for this warranty
to be applied to all Kraus products.
Page 11
C. Kraus recommends installing all Kraus products with a licensed, professional
plumber. Kraus will not be held responsible for any damage or product failure
due to improper installation, misuse, or failure to use a licensed professional.
Please read your care and maintenance documentation to determine the limits
of proper use.
D. Commercial use will automatically void this warranty.
E. This warranty is not applicable to Kraus products purchased from an unau-
thorized seller. For a complete list of authorized sellers please visit http://www.
kraususa.com/where-to-buy.html
NONAPPLICABILITY OF THIS WARRANTY
By the purchase and use of our products, you agree that Kraus is not liable
for incidental, consequential or special damages associated with the return,
replacement, installation or use of your product. This includes freight costs,
cartridge replacement, labor, travel time, lost profit, home damages and other
contingent liabilities and costs (including, without limitation, costs associated
with experts, investigations, analyses, attorneys and other professionals and
services). The Kraus warranty is a comprehensive and explicit limit of liability,
and all items outside of it are not addressable by or the responsibility of
Kraus. Certain states have variances regarding implied warranties and in those
situations we remain fully compliant.
KRAUS USA Inc. makes no implication that products comply with any or all local
building or plumbing codes. It is the consumer’s responsibility to determine
local code compliance. This warranty extends to the original purchaser and first
consumer.
HELP LINE
For additional assistance at any point in the installation process, please call us at
1.800.775.0703 or email us at info@kraususa.com
Our customer service hours are Monday – Friday, 9am – 8pm EST.
Be sure to visit our website at www.kraususa.com.
Page 12
www.kraususa.com
Loading...