Kramer Electronics T1AF-26 User Manual

The Kramer T1AF-26 Inner Frame

To mount a Kramer insert or connector module:

Congratulations on purchasing your Kramer T1AF -26 inner frame for the TBUS-1Axl Table

Connection bus.

The T1AF-26 inner frame includes:

• An opening for 2 power sockets • 2 cable pass-through inserts

• 4 blank inserts

Figure 1: T1AF-26 Inner Frame (P/N: 80-000399)

Power Socket and Power Cord Options

Various power sockets and power cords are available to use with the T1AF -26, as described

in the “TBUS Modular Power Socket Installation and Power Cord” Installation Instructions,

supplied with the power socket.

Each power socket comes with detailed assembly instructions.

1. Unscrew the two screws that fasten the blank plate to the inner frame and remove the blank plate.

2. Place the required Kramer insert over the opening, insert the two screws to fix the Kramer insert in place, and tighten them.

Installing the Assembled Inner Frame

To install the T1AF-26 inner frame:

1. Place the assembled inner frame inside the TBUS-1Axl enclosure.

2. Set the required height using your fingers to bring the inner frame to the desired position, screw and tighten it in place using the height adjustment screws supplied with the inner frame.

Connecting the Cables

When replacing blank inserts with connector inserts (for example, VGA, audio, HDMI and so

on):

1. Insert the cables to their appropriate connectors from underneath.

2. Secure the cables to the tie holes on the TBUS-1Axl. Do not secure the cables too tightly or too loosely. Leave a small amount of slack.

After the TBUS-1Axl is connected to mains power and the proper cables, it is ready for use.

Inserting Pass-through Cables

Mounting the Inserts

You can rearrange or remove any of the plates mounted on the inner frame and replace them

with Kramer passive wall plates or connector modules for interfacing A/V type signals.

Go to http://www.kramerelectronics.com to check for up-to-date user manuals and the complete list of Kramer wall plates and module connectors.

To insert the pass-through cables (for example, to connect a laptop) do the following:

1. Remove the four screws attaching the split pass-through bracket.

2. Remove the split grommet(s).

3. Insert the cable(s) through the rectangular opening.

4. Open the split grommet slightly and insert the required cables.

5. Place the split bracket around the grommet and position this assembly over the inner frame.

6. Place the four screws appropriately and tighten the split bracket together with the

grommet and inserted cables to the inner frame.