Kramer WP-20/US(W) Quick Start Guide

KRAMER

2 90 0- 3 00 50 8 QS

WP-20 Wall Plate Quick Start Guide

This guide helps you install and use your product for the first time. For more detailed information, g

http://www.kramerav.com/manual/WP-20 to download the latest manual or scan the QR code on the left.

o to

Step 1: Check what’s in the box

The WP-20 Wall Plate

Power Adapter (12v DC)

1 Quick start guide

Step 2: Connect outputs

Always switch off the power to each device before connecting it to your . For best results, we recommend that you always use Kramer high-performance cables to connect AV equipment to the WP-20.

WP-20

Remote

Switches

Audio

Amplifier

Note: When the receiver in use does not support Ethernet, you can replace the left hand side faceplate with an optional part (WP-20-BLNK(W) P/N 68-80305099 or WP-20-BLNK(B) P/N 68-80305199) that does not have a cutout for the RJ-45 Ethernet connector.

Serial

Controller

TP-588D/

TP-580RXR

WP-20 Quick Start (P/N: 2900-300508QS REV 1)

P/N:

Rev:

Step 3: Set the DIP-switches

Feature

Function

DIP-switch

DIP-switch 2 Status

DIP-switch 1 Auto Switching (Off)

DIP-switch 1 Manual Switching (On)

1 Manual/Auto

Switching

2 Priority/Last

Connected Switching

3 Manual/Auto

Audio Switching

4 Analog/HDMI

Audio Priority Switching

Selects either manual or auto input switching

Selects either priority or last connected input switching, (DIP-switch 1 must be off)

Selects either manual or auto audio input selection

Selects either the analog or the HDMI audio input as priority

On—Manual switching Off—Auto switching

On—Priority switching Off—Last connected switching Default video input priority is HDMI 1 >

HDMI 2 > PC

On—Manual switching Off—Auto switching

On DIP-switch 3 On: Analog audio

input

DIP-switch 3 Off: External > Embedded priority

Off DIP-switch 3 On:

HDMI audio input

DIP-switch 3 Off: Embedded > External priority

Off—Last Connected

On—Priority When two sources are connected

When two sources are connected the last one connected gets priority

the active source is selected according to the pre-defined priority

Manual video input selection

Step 4: Connect the power

Connect power adapter to the WP-20, (if the device is not supplied power via the HDBT PoE), and plug the adapter into the mains power.

Step 5: Install the WP-20

Mount the device in a suitable wall box.

We recommend that you open all holes in the walls of the box to assist in cooling the WP-20.

Step 6: Connect the inputs

Blu-ray

Disk

Player

PC Graphics

Source

WWW.KRAMERAV.COM

Ethernet

LAN/PC

Multimedia

Player