Kramer VM-22H Quick Start Guide

VM-22H Quick Start

P/N:

2900- 301120QS

Rev:

Scan for full manual

VM-22H Quick Start Guide

This guide helps you install and use your VM-22H for the first time. Go to www.kramerav.com/downloads/VM-22H to download the latest user manual and check if firmware

upgrades are available.

Step 1: Check what’s in the box

VM-22H 2x1:2 HDMI Switcher/DA

4 Rubber feet

1 Quick start guide

1 Power supply (5V DC)

Kramer RC-IR3 Infrared Remote Control Transmitter with batteries and user manual

Step 2: Mount VM-22H

Install VM-22H using one of the following methods:

• Attach the rubber feet and place the unit on a flat surface.

• Fasten a bracket on each side of the unit and attach it to a flat surface

(see www.kramerav.com/downloads/VM-22H).

• Mount the unit in a rack using the recommended rack adapter

(see www.kramerav.com/product/VM-22H).

• Ensure that the environment (e.g., maximum ambient temperature & air flow) is compatible for the device.

• Avoid uneven mechanical loading.

• Appropriate consideration of equipment nameplate ratings should be used for avoiding overloading of

the circuits.

• Reliable earthing of rack-mounted equipment should be maintained.

• Maximum mounting height for the device is 2 meters.

Step 3: Connect inputs and outputs

Always switch OFF the power on each device before connecting it to your VM-22H.

To achieve specified extension distances, use the recommended Kramer cables available at www.kramerav.com/product/VM-22H. Using third-party cables may cause damage!

The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Step 4: Connect power

Connect the power cord to VM-22H and plug it into the mains electricity.

Safety Instructions (See www.kramerav.com for updated safety information)

Caution:

• For products with relay terminals and GPI\O ports, please refer to the permitted rating for an external connection, located next to the terminal or in the User Manual.

• There are no operator serviceable parts inside the unit.

Warning:

• Use only the power cord that is supplied with the unit.

• Disconnect the power and unplug the unit from the wall before installing.

Step 5: Operate the VM-22H

1. Press the EDID SETUP button to cycle through the EDID sources in the following order: a. Output 1 (Out 1 LED lights) b. Output 2 (Out 2 LED lights) c. Default EDID (Out 1 and 2 LEDs flash) d. Auto-Mix EDID (Out 1 and 2 LEDs light)

2. To store the EDID, release the button and the EDID is acquired.